tow NISSAN VERSA 2007 1.G Quick Reference Guide

WINDSHIELD WIPER/WASHER SWITCH
 The ignition switch must be in the ON position to
activate the windshield wipers.
 Push the lever down to operate the windshield wipers.
 Switch operation includes:
Intermittent – Wipers operate intermittently and can be adjusted by turning the
time control.
Low speed – Wipers operate at a continuous low speed.
High speed – Wipers operate at a continuous high speed.
Mist – Lift the lever up for one sweep operation of the wiper.
Wash – Pull the lever toward you. Wipers automatically wipe several times.

Rear wiper and washer switch (Hatchback only) – The rear window wiper and
washer operates when the ignition switch is in the ON position. Turn the switch
forward to operate rear window wipers. Switch operation includes:
Intermittent (not adjustable) – Wipers operate intermittently.
On – Wipers operate at a continuous speed.
Wash – Push the lever away from you. Wipers automatically wipe several
times.
INT
LO
HI
MIST
INT
ON
LCN0042
LCN0042
CRUISE CONTROL (if so equipped)
 To activate the cruise control, push the ON/OFF
switch. The indicator light in the instrument panel will
illuminate.
 To set cruising speed, accelerate the vehicle to the
desired speed, push the COAST/SET switch and
release it. The SET indicator light in the instrument
panel will illuminate.
 To reset at a faster cruising speed, push and hold the ACCEL/RES switch. When the
vehicle reaches the speed you desire, release the switch.
 To reset at a slower cruising speed, push and hold the COAST/SET switch. Release
the switch when the vehicle slows to the desired speed.
 To resume a preset speed, push and release the ACCEL/RES switch. The vehicle
returns to the last set cruising speed when the vehicle speed is over 24 MPH (38
km/h).
 To cancel cruise control, push the CANCEL switch or tap the brake pedal. The SET
indicator light in the instrument panel will go out.
 To turn off cruise control, push the ON/OFF switch. Both the CRUISE indicator light
and the SET indicator light in the instrument panel will go out.

FRONT SEAT ADJUSTMENTS
 Pull up on the lever 01 under the front of the seat and slide backward or forward;
release.
 Lift the lever 02 on the side of the seat to adjust your seatback backward or forward;
release when you have found a comfortable angle and the seat belt fits properly.
 Pull up or push down the adjusting lever 03 repeatedly to adjust the seat height.
01
0302
FOLDING DOWN THE REAR SEATS
(if so equipped)
Either side of the seatback (or both) can
be folded and has it’s own release.
 Pull the release 01 on the top of the
seatback to fold rear seat down.01
SUNROOF CONTROLS (if so equipped)
The ignition switch must be in the ON position to operate
the sunroof.
TILTING THE SUNROOF

To tilt the sunroof up, push the tilt switch toward the
LIC0977
1A
1
2 01 position.

To tilt the sunroof down, push the tilt switch toward the
LIC0977
1A
1
2
02 position.
SLIDING THE SUNROOF

To fully open the sunroof, push the switch toward the
LIC0977
1A
1
2
02 position.

To fully close the sunroof, push the switch toward the LIC0977
1A
1
2 01 position.

To open or close the sunroof part way, push the switch in either direction (01 or 02)
while the sunroof is sliding to stop it in the desired position.
01
02