traction control NISSAN VERSA HATCHBACK 2009 1.G Warranty Booklet

20
GOODYEAR/DUNLOP TIRE LIMITED WARRANTY
WHAT IS NOT COVERED BY THIS
WARRANTY?This limited warranty does not cover the following:
• Tires submitted for ride disturbance complaints that
are worn beyond the fi rst two thirty-seconds of an inch
(2/32”) tread depth or 6 months from date of new vehicle
purchase, whichever occurs fi rst, or tires submitted for
ride disturbance due to damaged wheels or any vehicle
condition.
• Goodyear & Dunlop do not warrant or give credit in any
adjustment transaction for any kind of material added to
a tire (e.g., tire fi llers, sealants, balancing substances)
after the tire leaves a factory producing Goodyear or
Dunlop tires, nor will it adjust any tire that has failed as
a result of adding such material.
• Irregular wear or damage due to mechanical condition of
the vehicle, improper infl ation, overloading, high speed
spin-up, misapplication, misuse, negligence, racing,
use of tire chains, improper mounting or demounting,
improper repair, wreck, collision or fi re.
• Road hazards (includes, but not limited to, punctures,
cuts, snags, impact breaks, etc.) .
• Any tire that, after leaving a factory producing Good-
year or Dunlop tires, has been intentionally altered to
change its appearance (e.g., white inlay on a black tire
or regrooved) .
• Tires with weather-cracking that were purchased more
than four (4) years prior to presentation for adjustment or,
if purchase date cannot be verifi ed, manufactured more
than four years prior to presentation for adjustment.
• Temporary spare tires used on vehicles used in racing
and on passenger cars in special applications such as
police pursuit service.
• Goodyear Unisteel Commercial Radial Light Truck
Tires.• Loss of time, inconvenience, loss of vehicle use, inci-
dental or consequential damages.
• Tires supplied as Original Equipment are not eligible
for any tread life warranty consideration.
WHAT ARE YOUR LEGAL RIGHTS?Some states and provinces do not allow the exclusion or
limitation of incidental or consequential damages, so the
above limitation or exclusion may not apply to you.
No Representative or Dealer has authority to make any rep-
resentation, promise, or agreement on behalf of Goodyear
or Dunlop except as stated herein.
Any tire, no matter how well constructed, may fail in
service or otherwise become unserviceable due to con-
ditions beyond the control of the manufacturer. Under no
circumstances is this warranty a representation that a tire
failure cannot occur.
This warranty gives you specifi c legal rights and you may
also have other rights that vary from state to state or
province to province.HOW DO YOU OBTAIN AN ADJUSTMENT?A. You must present the tire to be adjusted to an authorized
Goodyear or Dunlop service facility. Tires replaced on an
adjustment basis become the property of The Goodyear
Tire & Rubber Company, Goodyear Dunlop Tires North
America, Ltd. or Goodyear Canada Inc.
B. You must pay for taxes and any additional services you
order at the time of adjustment.
C. You must submit your claim on an approved claim form
supplied by an authorized Goodyear or Dunlop service
facility. The form must be fi lled out completely and
signed, where you the owner or your authorized agent
presented the tire for adjustment.
SAFETY WARNINGSProperty damage, serious injury or death may result
from:
• TIRE FAILURE DUE TO UNDERINFLATION/OVER-
LOADING.
Follow the vehicle owner’s manual, tire placard or vehicle
certifi cation label on vehicle.
• EXPLOSION OF TIRE/RIM ASSEMBLY DUE TO
IMPROPER MOUNTING.
Only specially-trained persons should mount tires.
• FAILURE TO MOUNT RADIAL TIRES ON APPROVED
RIMS.
• FAILURE TO DEFLATE SINGLE OR DUAL ASSEM-
BLIES COMPLETELY BEFORE DEMOUNTING.
• TIRE SPINNING ON SLIPPERY SURFACES SUCH
AS SNOW, MUD, ICE, ETC. DO NOT SPIN TIRES
IN EXCESS OF 35 MPH (55 KPH) , AS INDICATED
ON THE SPEEDOMETER. PERSONAL INJURY AND
SEVERE DAMAGE MAY RESULT FROM EXCESSIVE
WHEEL SPINNING, INCLUDING TIRE DISINTEGRA-
TION OR AXLE FAILURE.
WARNING: Vehicle handling, traction, ride comfort
and other performance parameters may be signifi cantly
affected by a change in tire size or type. Before replacing
tires, always consult and follow the vehicle owner’s manual
because some vehicle manufacturers prohibit changing
tire size. When selecting tires that are different from the
original equipment size make certain: (1) The tires have
adequate load carrying capacity based on the vehicle
placard, (2) The tires have suffi cient infl ation pressure
to carry the load and (3) There is proper clearance with
no interference points between the tire and vehicle. The
consumer must be aware to always drive safely and obey (Continued on page 21)

36HARD BRAKINGYou must inspect your tires after any hard braking
circumstances or after tires have slid on the pavement. This
can cause a fl at spot in a section of the tire tread.TIRE SPINNINGNever spin your tires above a speedometer reading of 35
mph (55 km/h) if your vehicle becomes stuck. The centrifugal
force generated by the free spinning tire/wheel assembly
may cause a sudden tire explosion, resulting in vehicle
damage and/or serious personal injury or death. Never
allow anyone to stand near or behind a tire spinning at
high speed while attempting to push a vehicle that is stuck.
When in mud, sand, snow, ice or other slippery conditions,
do not indulge in excessive wheel spin. In such conditions,
with automatic transmission vehicles, by accelerating the
engine excessively, it is possible to spin one of the drive
tires beyond its speed capability. This is also true when
balancing a drive tire/wheel assembly using the engine of
the vehicle to spin the wheel.TIRE TREADTires must be replaced when the depth of the tread
reaches 2/32 inch (1.6 mm) . Tires are manufactured with
tread wear indicators molded into the tire grooves which
indicate tread wearout. As tires approximate 2/32 inch (1.6
mm) wearout, the tread gauge becomes thinner and more
vulnerable to the effects of road hazards. Also, worn tires
are more subject to hydroplaning, which can cause loss
of control. Therefore, visual tire inspection becomes more
crucial as the tires wear out.
WORN TIRESNever drive on worn tires. Tires should be replaced by trained
personnel when 2/32nds of an inch tread depth remains,
as indicated by the tread wear indicators molded into the
tread grooves. In most states, it is illegal to drive with less
than 2/32nds of an inch of tread remaining.TIRE MIXINGFor best performance select tires similar in size and load
rating to the original equipment tires. It is recommended
that the same size and type of tire be used on all four
wheel positions. In certain tires, casing ply material and
ply construction may vary as indicated on the sidewall of
the tire. When changing or replacing tires, it is preferred
that all four tires are the same construction type (i.e., High
Performance, All Season, Mud & Snow) and construction
(Radial or Bias Ply) . Before mixing tires of different types on
a vehicle in any confi guration, be sure to check the vehicle
owner’s manual for its recommendations.
Tires which meet the Rubber Manufacturer's Association
(RMA) defi nition of mud and snow tires are marked M/S,
M+S, M&S. On such tires, this designation is molded
into the sidewall. Tires without this notation are not
recommended for mud and/or snow driving.
If snow tires are needed, it is necessary to select tires
equivalent in size and load rating to the original equipment
tires. Always fi t performance snow tires in sets of four
(4) for optimum mud & snow traction and maintenance
of vehicle handling characteristics. If you do not, it may
adversely affect the safety and handling of your vehicle.
It is also important to check the vehicle owner’s manual
before mixing or matching tires on 4-wheel drive vehicles
as this may require special precautions.Please refer to your Owner’s Manual for more information
on tire replacement precautions.
TIRE ROTATIONTires on your Nissan vehicle should be rotated every
7,500 miles or as irregular wear develops. If irregular
wear becomes apparent or if the wear rate on the tires is
perceptibly uneven, the tires should be rotated in such a
way to alleviate the problem. Check your vehicle for any
mechanical problems and correct if necessary. Any rotation
pattern or procedure may be followed including those
indicated in the Owner’s Manual. Some tires have arrows on
the sidewall showing the direction in which the tire should
turn. When rotating this type of tire, care must be taken to
maintain the proper turning direction as indicated by the
arrows. Some vehicles have different tire sizes specifi ed
for front and rear axles. Tires on these vehicles should not
be rotated side to side (unless they are non-directional) .
Where a temporary type spare tire is available, it should
not be included in the tire rotation schedule. Such tires
are intended for temporary use only.REPLACING TWO TIRESIf your vehicle was originally equipped with four tires that
were the same size and you are only replacing two of the
four tires, install the new tires on the rear axle. Placing new
tires on the front axle may cause loss of vehicle control
in some driving conditions and cause an accident and
personal injury.
* Provided by and published at the request of the tire
manufacturers/warrantors.
IMPORTANT TIRE SAFETY INFORMATION*
(Continued on page 37)