ECU Oldsmobile Achieva 1995 s User Guide
[x] Cancel search | Manufacturer: OLDSMOBILE, Model Year: 1995, Model line: Achieva, Model: Oldsmobile Achieva 1995Pages: 340, PDF Size: 16.99 MB
Page 50 of 340

3. Put the belt’s special latch plate into the vehicle’s
safety belt buckle. 4. You can make the belt longer by tilting the buckle
and pulling it along the belt.
5. Put the restraint on the seat. Follow the instructions
for the child restraint.
6. Secure the child in the child restraint as the
instructions
say.
7. Run the belt through or around the child restraint.
The child restraint instructions will show
you how.
1-42
Page 51 of 340

8. Put the hook on the free end through the slot in the
latch plate. 9. To make it tight, pull the belt while you push down
on the child restraint. If the belt won’t stay tight,
switch
it end for end.
10. Push and pull the child restraint in different
directions to be sure
it is secure.
1-43
Page 61 of 340

Illuminated EntryExit System
When you lift the outside handle of either front door or
open either rear door, the lamps inside your vehicle will
go on. These lamps will fade out after about 40 seconds,
or when the ignition
is turned on after all doors have
been closed.
If the ignition was recently turned off, the
lamps will fade
out after four seconds. These lamps will
also go on when you press the
DOOR or UNLOCK
button on the optional Remote Lock Control transmitter.
Rear Door Security Locks
Your Oldsmobile is
equipped with rear
door security locks
that help prevent
passengers from
opening the rear
doors
of your vehicle from
the inside.
If the ignition has been off for less than two minutes,
the lamps inside your vehicle will stay
on for about
15 seconds after your key is removed from the ignition
to provide an illuminated exit. To use one of these locks:
1. Use a key to move the lock all the way up.
2. Close the door.
3.. Do the same thing to the other rear door lock.
Page 62 of 340

The rear doors of your vehicle cannot be opened from
inside when this feature
is in use. If you want to open a
rear door when the security lock is on:
1. Unlock the door from the inside.
2. Then open the door from the outside.
If you don’t cancel the security lock feature, adults or
older children who ride in the rear won’t be able to open
the rear door from the inside. You should let adults and
older children know how these security locks work, and
how to cancel the locks.
To Cancel the Rear Door Lock:
1. Unlock the door from the inside and open the door
from the outside.
2. Use a key to move the lock all the way down.
3. Do the same for the other rear door.
The rear door locks will now work normally.
Remote Lock Control (Option)
If your Oldsmobile has this option, you can lock and
unlock your doors or unlock your trunk from
up to
30 feet (9 m) away using the key chain transmitter
supplied with your vehicle.
Your Remote Lock Control operates on a radio
frequency subject to Federal Communications
Commission (FCC) Rules.
2-6
Page 139 of 340

CD Player Theft Deterrent Feature
Delco LOC 11’ is an theft deterrent feature for the
compact disc player. It can be used or ignored. If
ignored, the system plays normally. If it is used, your
player won’t be usable if
it is ever stolen because it will
go to “LOC” mode any time battery power is removed.
It will also
go to LOC mode any time power from the
battery is turned off by the Battery Rundown Protection
feature (see“Battery Rundown Protection”
in the Index).
Until an unlock code is entered, it will not turn on.
The instructions below tell you how to enter a secret
code into the system. If your vehicle loses battery power
for any reason, you must unlock
the system with the
secret code before your audio system will turn on.
Setting the Anti-Theft System
1. Write down any six-digit number and keep it in a
2. Turn the ignition to the ACC or RUN position.
3. Turn the PWR-VOL knob to turn the radio off.
safe place. This is your secret c.ode.
4. Press station preset buttons 1 and 4 at the same time
and hold
until bb---’’ shows on the display.
You now have only 15 seconds between each of the
following steps.
5. Press SET, and “000” will appear on the display.
6. Press SCAN until the first digit of your code
appears.
7. Press SEEK until the second and third digits of your
8. Press the TUNE knob (“000” will appear again on
code
appear.
the display).
9. Press SCAN until the fourth digit of your code
appears.
10. Press SEEK until the fifth and sixth digits of your
code appear.
11. Press the TUNE knob (“rEP’ will appear for five
seconds,
then 000 ).
12. Repeat steps 6 through 10. Then press the TUNE
knob again. SEC will appear, indicating that Delco
LOC IT’ is set, and your audio system is secure. If
bb---” appears, the steps were not successful, and
you must repeat the entire procedure.
3-13
Page 140 of 340

Disabling the Anti-Theft System
Enter your secret code by following these steps (you
will have only
15 seconds between each step).
1. Turn the ignition to the ACC or RUN position, and
turn
the radio off.
2. Press station preset buttons 1 and 4 at the same time.
SEC will appear in the display, indicating the audio
system is secure.
3. Press SET, and “OOO” will appear on the display.
4. Press SCAN until the first digit of your secret code
appears.
5. Press SEEK until the second and third digits of your
code appear.
display).
6. Press the TUNE knob (“000” will appear on the
7. Press SCAN until the fourth digit of your code appears.
8. Press SEEK until the fifth and sixth digits of your
code appear.
9. Press the TUNE knob. If the display shows “---,” the
radio is unsecured and will play again. If the display
shows SEC, the disabling sequence was unsuccessful
and the numbers did not match
the secret code.
If
you lose or forget your code, see your retailer.
Unlocking the System After a Power Loss
When battery power is reapplied to a secured audio
system after a
loss of power, the audio system will not
turn on and
LOC will appear on the digital display. You
will need to unlock the Delco LOC
11s system.
1. Turn the ignition to the ACC or RUN position, and
turn the radio
off.
2. Press SET, and “000” will appear on the display.
3. Follow steps 4-8 for disabling your anti-theft
system.
digital display if you are successful.
If SEC appears,
however, the numbers did not match, and your audio
system
is still locked.
4. Press the lower knob. The time will appear on the
Understanding Radio Reception
FM Stereo
FM stereo will give you the best sound, but FM signals
will reach only about
10 to 40 miles ( 16 to 65 km). Tall
buildings or hills can interfere with FM signals, causing
the sound to come and go.
3-14
Page 167 of 340

Driving on Snow or ,Ice
Most of the time, those places where your tires meet the
road probably have good traction.
However, if there is snow or ice between your tires and
the road, you can have a very slippery situation. You’ll
have a lot less traction or “grip” and will need to be very
careful.
Include an
ice scraper, a small brush or broom, a supply
of windshield washer fluid, a rag, some winter outer
clothing, a small shovel, a flashlight, a red cloth, and a
couple
of reflective warning triangles. And, if you will
be driving under severe conditions, include a small bag
of sand, a piece of old carpet or a couple of burlap bags
to help provide traction. Be sure you properly secure
these items in your vehicle.
4-23
Page 179 of 340

Safety Chains
You should always attach chains between your vehicle
and your trailer. Cross the safety chains under the tongue
of the trailer
so that the tongue will not drop to the road
if it becomes separated from the hitch. Instructions
about safety chains may be provided by the hitch
manufacturer or by the trailer manufacturer. Follow the
manufacturer’s recommendation for attaching safety
chains and do not attach them to the bumper. Always
leave just enough slack
so you can turn with your rig.
And, never allow safety chains to drag on the ground.
Trailer Brakes
Does your trailer have its own brakes‘!
Be sure to read and follow the instructions for the trailer
brakes
so you’ll be able to install, adjust and maintain
them properly. And because you have anti-lock brakes,
do not try
to tap into your vehicle’s brake system. If you
do, both brake systems won’t work well,
or at all.
Driving with a Trailer
Towing a trailer requires a certain amount of experience.
Before setting out for the open road, you’ll want
to get
to know
your rig. Acquaint yourself with the feel of
handling and braking with the added weight of the trailer.
And always keep in mind that the vehicle you are
driving is now
a good deal longer and not nearly as
responsive as your vehicle is by itself.
Before you start, check
the trailer hitch and platform
(and attachments), safety chains, electrical connector,
lamps, tires and mirror adjustment. If the trailer has
electric brakes, start your vehicle and trailer moving and
then apply the trailer brake controller by hand to be sure
the brakes are working. This lets you check your
electrical connection at the same time.
During your trip, check occasionally to be sure that the
load is secure, and that the lamps and any trailer brakes
are still working.
Following Distance
Stay at least twice as far behind the vehicle ahead as you
would when driving your vehicle without a trailer. This
can help you avoid situations that require heavy braking
and sudden turns.
Passing
You’ll need more passing distance up ahead when
you’re towing
a trailer. And, because you’re a good deal
longer, you’ll need to go much farther beyond the
passed vehicle before you can return to your lane.
4-35
Page 203 of 340

The following steps will tell you how to use the jack and
change a tire.
The equipment you’ll need is in the trunk.
1. Turn the center retainer nut on the compact spare tire
housing counterclockwise to remove it, then lift the
tire cover.
You will find the jacking instructions label
on the underside of the tire cover.
2. Remove the wing bolt securing the compact spare
tire and spacer by turning it counterclockwise. Then
lift
off the spacer and remove the spare tire.
3. The jack and wheel wrench are stored in a foam tray
by the compact spare tire.
4. Using the wheel wrench, remove the wheel nut caps
(if your vehicle has them) and loosen all the wheel
nuts. Don’t remove them yet. On some models, a
cover plate must be removed to find the wheel nuts.
Carefully use the wedge end of the wheel wrench to
pry it
off.
5-21
Page 208 of 340

13. Store the flat tire in the compact spare tire
compartment, and
secure with the wing bolt and
extension. Store the jack and wheel wrench back in
the foam tray provided.
5-26