fog light OLDSMOBILE AURORA 2002 Owners Manual

2-36
As you signal a turn or a lane change, if the arrows flash
very fast, a bulb may be burned out and other drivers
won't see your turn signal.
If a bulb is burned out, replace it to help avoid
an accident.
If the arrows don't go on at all when you signal a turn,
check the fuse (see ªFuses and Circuit Breakersº in
the Index) and check for burned
-out bulbs.
Turn Signal On Chime
If your turn signal is left on for more than 0.8 miles
(1.3 km), a chime will sound at each flash of the turn
signal and the DIC will display the TURN SIGNAL
ON? reminder message. To turn off the chime and
message, move the turn signal lever to the off position.
To turn off the DIC message while the turn signal is
still active, press any button on the DIC. See
ªDriver Information Center (DIC)º in the
Index for more information.
Headlamp High/Low-Beam Changer
To change the headlamps from low beam to high, push
the lever away from you until you hear a click. Then
release it.
When the high beams
are on, this light on the
instrument panel cluster
will also be on.
If the fog lamps are on when you turn on the
high
-beam headlamps, the fog lamps will turn off.
The fog lamps will turn back on when you turn
off the high
-beam headlamps.
ProCarManuals.com

2-46 Fog Lamps
To turn on only the front
fog lamps, turn the fog
lamp band to the single fog
lamp symbol. To turn on
both the front and rear fog
lamps, turn the fog lamp
band to the double fog
lamp symbol.
Turning on the front fog lamps only will automatically
activate the parking lamps. Turning on the front and rear
fog lamps will automatically activate the parking lamps
and headlamps.
To turn off the fog lamps, turn the band to OFF. The
front fog lamps will also turn off when you turn on your
high
-beam headlamps, but will turn on again when you
switch to low beams.
Exterior Lighting Battery Saver
If the exterior lamps control has been left on, the
exterior lamps will turn off approximately 10 minutes
after the ignition is turned to OFF and any door has been
opened. This protects against draining the battery in case
you have accidentally left the headlamps or parking
lamps on. If you need to leave the lamps on for more
than 10 minutes, use the exterior lamps control to turn
the lamps back on after the ignition has been turned to
OFF and any door has been opened.
ProCarManuals.com

2-50 Rear Reading Lamps
These lamps will come on when you open the doors.
You can also turn them on by pressing the button on the
side of the lamp. Press it again to turn them off.
Inadvertent Power Battery Saver
This feature is designed to protect your vehicle's battery
against drainage from the interior lamps, trunk lamp,
glove box lamp or cigarette lighters. When the ignition
is turned off, the power to these features will
automatically turn off after 10 minutes. Power will be
restored for an additional 10 minutes if any door is
opened, the trunk is opened or the courtesy lamp control
is turned on. To restore power to the cigarette lighters,
the ignition must be turned back to ON.
Battery Load Management
The battery load management feature is designed to
monitor the vehicle's electrical load and determine when
the battery is in a heavy discharge condition. During
times of high electrical loading, the engine may idle at a
higher rpm setting than normal to make sure the battery
charges. High electrical loads may occur when several
of the following are on: headlamps, high beams, fog
lamps, rear window defogger, blower fan, heated seats
and engine cooling fans.
If your vehicle's battery remains in a heavy discharge
condition for a long period of time, the fan, rear
defogger, heated seats and heated mirrors will be
disabled and the DIC will display BATTERY SAVER
ACTIVE. This can happen either under long periods of
idling or low speed driving with high electrical loading,
or in the event of a charging system fault.
ProCarManuals.com

3-3
Temperature Buttons
Maintain the temperature inside the vehicle by using the
red and blue arrows located below the digital display. If
you want a warmer comfort level, push the red arrow. If
you want a cooler comfort level, push the blue arrow.
Your selected comfort setting will be shown on the
digital display for five seconds, then the outside
temperature will be displayed.
Manual Operation
Use the left and right mode knobs, along with the
buttons on your climate control system to operate the
system manually.
OFF: Turning the left mode knob to OFF will cause
the fan to turn off and the airflow to be directed through
the floor ducts. The system will work to maintain the
previously chosen temperature setting. The display will
show the outside temperature when the system is set
to OFF.
(Panel): This setting directs the airflow through
the instrument panel outlets.
(Bi-Level): This setting directs the airflow
through both the instrument panel outlets and the floor
ducts. There is also a small amount of air directed to the
front defroster and the side window defrosters.
(Floor): This setting directs most of the airflow
to the floor ducts. There is also some airflow directed
to the side window defrosters and a small amount of
airflow directed to the front defroster.
(Defogger): This setting directs the majority
of the airflow to the floor ducts and the front defroster,
with a small amount of airflow to the side window
defrosters. This can be useful in helping to remove
moisture from the inside of the windshield when the
outside temperature is cold or the humidity is high. The
air conditioning indicator light will come on to show the
air compressor is working to dehumidify the air.
(Defroster): This setting directs the majority of the
airflow to the windshield with some airflow to the side
window defrosters and the floor ducts. To increase the
fan speed, turn the right mode knob clockwise.
Even though air conditioning is not selected, in defrost
mode the air conditioning compressor will run
automatically at temperatures over approximately 40
F
(4
C) to improve windshield clearing performance. This
dehumidifies the air to help dry the windshield. Even
though the compressor may be running, the air
conditioning indicator light will not come on in defrost
unless you select air conditioning.
ProCarManuals.com

3-4
(Air Conditioning): Press this button to turn
the air conditioning compressor on and off. The air
conditioning indicator light will illuminate. In the
automatic mode, the air conditioning compressor will
only operate when the system determines it is needed.
(Recirculation): Press this button to limit the
amount of outside air entering your vehicle. This is
helpful when you are trying to cool the interior of the
vehicle quickly or limit the amount of outside air
entering your vehicle for some other reason. The
recirculation button may be selected and the mode knobs
may be adjusted at the same time. The system will
remain in recirculation until the ignition is turned off,
then the system will return to the previously selected
mode. Recirculation may be selected in all airflow
modes except defrost.
When the weather is cool or damp, operating in
recirculation for extended periods of time may cause
fogging of the vehicle's windows. To clear the fog,
switch back to outside air by turning off recirculation,
then select either defogger or defrost mode and increase
the fan speed. To avoid refogging of the windows,
minimize your use of recirculation under these
conditions and turn the air conditioning on to help
dehumidify the air.Automatic Operation
Press the left and right mode knobs for the system
to automatically maintain the air temperature, airflow
direction and the fan speed. They will be controlled based
on the selected temperature setting, the temperature inside
the vehicle, the outside temperature and the sun load.
Fan speed will vary as the system reaches and maintains
the comfort setting you have selected.

Press the left and right mode knobs to turn on
the lights under the knobs, indicating that the
system is being controlled automatically. Your
current temperature setting will be shown in the
digital display.

Then adjust the temperature level using the red
and blue arrows located below the climate control
display until you reach a setting of 75F (24C)
on the display. Give the vehicle about 30 minutes to
stabilize and then readjust the temperature setting if
necessary. The display will show the temperature
setting for five seconds and then it will show the
outside temperature.
ProCarManuals.com

3-7
On very hot days, open the windows long enough to let
the hot air out. This reduces the time required to cool the
interior of the vehicle to a comfortable temperature. If
the system is in the automatic mode (left and right mode
knob indicator lights are on), during very hot days the
system will automatically go to the recirculation mode
and the temperature door will initially be at the full cold
position for maximum cooling. You can choose the
extreme temperature setting of 60
F (16
C), but the
system will not cool any faster by choosing this setting.
Heating
In cold weather, if the automatic mode is selected
(left and right mode knob indicator lights are on), the
system will automatically direct the airflow out of the
floor ducts and the temperature door will initially be
positioned at the full hot position. You can choose
the extreme temperature setting of 90
F (32
C),
but the system will not warm up any faster by selecting
this setting.In cold weather, the system will delay turning on the fan
to avoid blowing cold air into the vehicle. The length of
the delay depends on the engine coolant temperature and
the outside temperature. The fan speed will increase as
the temperature of the engine coolant rises. Turning the
right mode knob will override this delay by cancelling
the automatic fan control mode.
Defogging and Defrosting
On cool, humid days, use the defog setting to keep
the windows clear while also providing heat through
the floor ducts. Turn the left mode knob clockwise
to defrost to quickly remove fog or ice from
the windshield.
For maximum front defrost performance under extreme
icing or frosting conditions, increase the temperature
setting to 90
F (33
C) and increase the fan speed
to high.
ProCarManuals.com

3-8 Rear Window Defogger
(Rear Defogger):
Press this button to
warm the defogger
grid on the rear
window. An indicator
light below the button
will glow while the
rear window defogger
is operating.
At speeds above 30 mph (48 km/h), the rear defogger
will stay on until you press the rear button again. At
speeds below 30 mph (48 km/h), the rear defogger will
turn off automatically after about 10 minutes of use. If
you press it again, the defogger will operate for about
five minutes only. You can also turn the defogger off
by turning off the ignition.
Do not attach a temporary vehicle license across the
defogger grid on the rear window.
If your vehicle is equipped with heated outside rearview
mirrors, when you operate the rear window defogger,
the mirrors are also heated to help remove ice and fog.
For more information see ªHeated Outside Rearview
Mirrorsº in the Index.
NOTICE:
Don't use a razor blade or other sharp object on
the inside of the rear window. If you do, you
could cut or damage the warming grid, and the
repairs wouldn't be covered by your warranty.
Ventilation System
Your vehicle's flow-through ventilation system allows
filtered outside air to flow through your vehicle while it
is moving, even if the system is off.
The direction of the airflow
can be controlled by
adjusting/closing the outlets
in the instrument panel.
ProCarManuals.com

6-70
Minifuse Usage
1 Not Used
2 Accessory
3 Windshield Wipers
4 Not Used
5 Left Low
-Beam Headlamp
6 Right Low
-Beam Headlamp
7 Spare
8 Powertrain Control
Module BatteryMinifuse Usage
9 Right High
-Beam Headlamp
10 Left High
-Beam Headlamp
11 Ignition 1
12 Not Used
13 Transaxle
14 Cruise Control
15 Direct Ignition System
16 Injector Bank #2
17 Not Used
18 Not Used
19 Powertrain Control Module
Ignition
20 Oxygen Sensor
21 Injector Bank #1
22 Auxiliary Power
23 Cigarette Lighter
24 Fog Lamps/Daytime
Running Lamps
25 Horn
26 Air Conditioner Clutch
ProCarManuals.com