width OLDSMOBILE BRAVADA 1994 Owners Manual

Q: Am I likely to stall when going
downhill?
A It’s much more likely to happen
going uphill. But if it happens going
downhill, here’s what to do.
Stop your vehicle by applying the
regular brakes. Apply the parking
brake.
Shift to P (Park) and, while still
braking, restart the engine.
Shift back to a low gear, release the
parking brake, and drive straight
down.
If the engine won’t start, get out
and get help.
Driving Across an Incline
Sooner or later, an off-road trail will
probably go across the incline of a
hill. If
this happens, you have to decide
whether to
try to drive across the incline.
Here are some things to consider:
A hill that can be driven straight up or
down may be too steep to drive
across. When you go straight up or
down
a hill, the length of the wheel
base (the distance from the front wheels
to the rear wheels) reduces the
likelihood the vehicle will tumble end
over end. But when you drive across
an incline, the much more narrow
track width (the distance between the
left and right wheels) may not prevent
the vehicle from tilting and rolling
over. Also, driving across an incline
puts more weight
on the downhill
wheels. This could cause
a downhill
slide or a rollover.
Surface conditions can be a problem
when you drive across a hill. Loose
gravel, muddy spots, or even wet grass
can cause your tires to slip sideways,
downhill. If the vehicle slips sideways,
it can hit something that will trip it (a
rock, a rut, etc.) and roll over.
Hidden obstacles can make the
steepness of the incline even worse. If
you drive across a rock with the uphill
wheels, or if the downhill wheels drop
into a rut or depression, your vehicle
can tilt even more.
For reasons like these, you need to
decide carefully whether to
try to drive across
an incline. Just because the trail
goes across the incline doesn’t mean
you have to drive it. The last vehicle to
try it might have rolled over.
Q: What if I’m driving across an
incline that’s not too steep, but
I
hit some loose gravel and start to
slide downhill. What should I do?
A: If you feel your vehicle starting to
slide sideways, turn downhill. This
should help straighten out the
vehicle and prevent the side slipping.
However, a much better way to
prevent this is
to get out and “walk
the course”
so you know what the
surface is like before you drive it.
L
I
121
ProCarManuals.com

temperature can cause the material of
the tire to degenerate and reduce tire
life, and excessive temperature can lead
to sudden tire failure. The grade
C
corresponds to a level of performance
which all passenger car tires must meet
under the Federal Motor Vehicle Safety
Standard
No. 109. Grades B and A
represent higher levels of performance
on the laboratory test wheel than the
minimum required by law.
Warning: The temperature grade for
this tire is established for a tire that is
properly inflated and not overloaded.
Excessive speed, underinflation, or
excessive loading, either separately or in
combination, can cause heat buildup
and possible tire failure.
These grades are molded
on the
sidewalls of passenger car tires.
While the tires available as standard
or
optional equipment on General Motors
vehicles may vary with respect to these
grades,
all such tires meet General
Motors performance standards and have
been approved for use
on General Motors
vehicles.
All passenger type (P Metric)
tires must conform to Federal safety
requirements
in addition to these grades.
Wheel Alignment and Tire
Balance
The wheels on your vehicle were
aligned and balanced carefully at the
factory to give you the longest tire life
and best overall performance.
In most cases, you will not need to have
your wheels aligned again. However, if
you notice unusual tire wear or your
vehicle pulling one way or the other, the
alignment may need to be reset. If you
notice your vehicle vibrating when
driving
on a smooth road, your wheels
may need to be rebalanced.
Wheel Replacement
Replace any wheel that is bent, cracked
or badly rusted. If wheel nuts keep
coming loose, the wheel, wheel bolts,
and wheel nuts should be replaced. If
the wheel leaks air, replace it (except
some aluminum wheels, which can
sometimes be repaired). See your
Oldsmobile dealer if any of these
conditions exist.
Your dealer will know the kind of wheel
you need. Each new
wheel should have the same
load carrying capacity, diameter, width,
offset, and be mounted the same way as
the one it replaces.
If you need to replace any of your
wheels, wheel bolts, or wheel nuts,
replace them only with new GM
original equipment parts. This way, you
will be sure to have the right wheel,
wheel bolts, and wheel nuts for your
Oldsmobile model.
189
ProCarManuals.com