brake rotor OLDSMOBILE INTRIGUE 1998 Owners Manual

NOTICE:
Improperly tightened wheel nuts can lead to
brake pulsation and rotor damage.
To avoid
expensive brake repairs, evenly tighten the wheel
nuts in the proper sequence and to the proper
torque specification.
Storing the Flat Tire and Tools
Storing a jack, a tire or other equipment in the
passenger compartment
of the vehicle could
cause injury. In
a sudden stop or collision, loose
equipment could strike someone. Store all these
in the proper place. After you’ve
put the compact spare tire on your vehicle,
you’ll need
to store the flat tire in your trunk. Use the
following procedure to secure the flat tire in the trunk.
When storing
a full-size tire you must use the extension
to help avoid wheel surface damage. Use extension and
protector/guide located
in foam holder.
To store a full size tire, place tire valve stem facing down,
with the protectodguide through a wheel bolt hole, then
remove protector and attach retainer securely. When
reinstalling compact spare put
the protector/guide back in
foam holder. Store the cover as far forward as possible.
5-33
ProCarManuals.com

Part C: Periodic
Maintenance Inspections
Listed below are inspections and services which should be
performed at least twice a year (for instance, each spring
and fall).
You should let your retailer’s service department
or other qualiJied service center do these jobs. Make sure
any necessary repairs are completed at once.
Proper procedures to perform these services may be
found in a service manual. See “Service and Owner
Publications” in the Index.
Steering, Suspension and Front Drive Axle
Boot and Seal Inspection
Inspect the front and rear suspension and steering
system for damaged, loose or missing parts, signs of
wear or lack of lubrication. Inspect the power steering
lines and hoses for proper hook-up, binding, leaks,
cracks, chafing, etc. Clean and then
axle boot seals for damage, tears or
seals if necessary.
Exhaust System Inspection
Inspect the complete exhaust system. inspect
the drive
leakage. Replace
Inspect the body near
the exhaust system. Look for broken, damaged, missing
or
out-of-position parts as well as open seams, holes, loose
connections or other conditions which could cause a heat build-up in
the floor
pan or could let exhaust fumes into
the vehicle. See “Engine Exhaust” in the Index.
Engine Cooling System Inspection
Inspect the hoses and have them replaced if they are
cracked, swollen or deteriorated. Inspect all pipes, fittings
and clamps; replace as needed. Clean the outside
of the
radiator and air conditioning condenser.
To help ensure
proper operation, a pressure
test of the cooling system
and pressure cap
is recommended at least once a year.
Throttle System Inspection
Inspect the throttle system for interference or binding,
and for damaged or missing parts. Replace parts as
needed. Replace any components that have high effort
or excessive wear. Do not lubricate accelerator and
cruise control cables.
Brake System Inspection
Inspect the complete system. Inspect brake lines and
hoses for proper hook-up, binding, leaks, cracks,
chafing, etc. Inspect disc brake pads for wear and rotors
for surface condition. Inspect other brake parts,
including calipers, parking brake, etc. Check parking
brake adjustment. You may need to have your brakes
inspected more often if your driving habits
or conditions
result in frequent braking.
7-17
ProCarManuals.com