door lock OLDSMOBILE SILHOUETTE 1996 User Guide

If you have the optional power sliding door (see “Power
Sliding Door” later
in this section), your remote
transmitter will have
a third button that has a van
symbol on
it. Press it to open or close the sliding door.
If the sliding door is locked, first press the unlock
symbol twice to unlock all doors, then press the van
symbol
to open the sliding door.
You can operate the power sliding door with
the remote
transmitter only when the power sliding door
ON/OFF
switch on the overhead console is in the ON position.
atchin- n-.smitter(s) To Your Vehicle -
Each
key chain transmitter is coded to prevent another
transmitter from unlocking your vehicle.
If a transmitter
is lost or stolen, a replacement can be purchased through
your retailer. Remember
to bring any remaining
transmitters with you when you go to your retailer.
When
the retailer matches the replacement transmitter to
your vehicle, any remaining transmitters must also be
matched. Once the new transmitter is coded, the lost
transmitter will not unlock your vehicle. Each vehicle
can have only four transmitters matched to it.
n 1tt acement
Under-normal use, the battery in your key chain
transmitter should last about two years.
You can tell the battery is weak if the transmitter won’t
work at the normal range in any location.
If you have to
get close to your vehicle before the transmitter works,
it’s probably time to change the battery.
ProCarManuals.com

Replacing the Battery in the Remote Transmitter
1. Insert a coin into the slot in the back of the transmitter,
and
turn it counterclockwise to open the cover.
2. Remove the cover.
3. Remove and replace the 3-volt battery (CR2032).
4. Reassemble the transmitter.
5. Check the transmitter operation.
Illuminated Entry System (Option)
This option comes with the optional Remote Lock
Control system.
When
you open the driver’s door (by itself or in
combination with any passenger door or
the liftgate) the
interior lamps will come on and then gradually dim to
off, 10 seconds after the last door is closed. (If the
driver’s door has not been opened, the interior lamps
will immediately dim to off.)
When you press the unlock symbol on your remote
transmitter, the lamps inside your vehicle will go on,
then gradually dim to off after about
40 seconds, unless
a door or the liftgate is opened.
When you turn on the ignition, the interior lamps will
immediately dim to off.
2-11
ProCarManuals.com

Sliding Door Lock
Lock the sliding door from the inside by sliding the
manual locking lever down. Unlock it
by sliding the
lever up.
If you have the optional power door locks, the sliding
door lock has a delay feature. See “Power Door Locks”
or “Automatic Door Locks” in the Index.
Power Sliding Door (Option)
A
With this option, you can open and close the sliding
door
with switches inside your vehicle. If you have the
optional Remote Lock Control system,
you can also
operate the sliding door with your remote transmitter.
See “Remote Lock Control” in the Index.
ProCarManuals.com

Leaving young children or pets unattended in
your vehicle can be dangerous. They could operate the power sliding door.
A child or others
could be injured.
Do not leave children or pets
unattended in your vehicle.
To operate the power sliding door, the power sliding
door
ON/OFF switch must be in the ON position. This
switch is the forward-most of two power door switches
located on the side of the overhead console. (If you have
the compact overhead console, this switch is located
between the reading lamps.)
To disable the power
sliding door feature, slide the switch to
OFF.
When your vehicle goes through an automatic car wash,
be sure the power sliding door
ON/OFF switch is in the
OFF position.
To open or close the sliding door, press and release one
of two PWR DOOR switches. There is one mounted on
the wall, just in front of the sliding door; the other is the
rear-most switch on the side of the overhead console. (If
you have the compact overhead console, this switch
is
located between the reading lamps.)
The sliding door must be unlocked for the power sliding
door to operate. The ignition does not have to be on and
the key does not have to be in the ignition.
To prevent
accidental operation of the sliding door, disable the
power sliding door by placing the power sliding door
ON/OFF switch in the OFF position.
2-14
ProCarManuals.com

To manually close the power sliding door when the
sliding door
ON/OFF switch is in the ON position, pull
the inside or outside latch release or the edge
of the
door. Move the door about
4 inches (10 cm) toward the
closed position and release. The door will close
completely and latch for
you.
To manually close the power sliding door when the
ON/OFF switch is
in the OFF position, pull the inside or
outside latch release and slide the door
all the way
forward to the latch position.
Resetting the rower diding Door
The power sliding door may operate incorrectly or not
all because of the following conditions:
0 A low voltage or dead battery
0 Disconnecting the battery
0 If the GUAGES, TAIL or TURN B/U fuse is
removed or blown.
See “Fuse Panel”
in the Index for more information
about your fuse panel.
If any of these conditions occur, the power sliding door
will need to be reset. To do this, follow the directions
listed here. It will be easier
if you read through them
once before beginning this procedure.
1.
2.
3.
4.
5.
6.
Check to be sure the power sliding door is unlocked
and securely closed.
Turn the ignition switch to the
OFF position.
Turn
the power sliding door ON/OFF switch to OFF.
Remove the TAIL fuse from the fuse panel. Leave it
out for 30 seconds.
Reinstall the fuse and wait 10 seconds.
Move the
ON/OFF switch to the ON position.
2-
ProCarManuals.com

7. Push either of the PWR DOOR buttons to open the
power sliding door.
8. Wait five seconds and close the door by pushing
either PWR DOOR button.
9. Wait five seconds and repeat Steps 7 and 8.
If the door does not rest in the fully open position after
repeating Step
7, repeat Steps 7 and 8 again. If the door
still does not operate correctly, see your retailer for service.
Sliding Door Security Lock
Your Oldsmobile is equipped with a sliding door
security lock that helps prevent passengers from opening
the sliding door from the inside.
If you have the optional power sliding door, you can
override the security lock by pressing the PWR DOOR
switch when
the power sliding door ON/OFF switch is
in the ON position. See “Power Sliding Door” earlier in
this section.
The security lock lever is located on the inside
of the
sliding door, near the rear edge of the door. To access
the lever, open the sliding door. Use the security lock
label on the rear edge
of the door as a guide. Reach
around the inside rear corner
of the sliding door to
access the lever.
1
I
7
1
n
I CHILD
SECURITY
J! I
LOCK
L A
To use the security lock, move the security lock lever all
the way up and close the door.
If you have the optional power sliding door, slide the
power sliding door ON/OFF switch on the overhead
console
to the OFF position. The sliding door cannot be
opened from the inside when this feature is in use.
2-18
ProCarManuals.com

To Cancel the Sliding Door Lock
1. Unlock the sliding door from the inside and open the
door from the outside.
2. Move the security lock lever all the way down.
The sliding door lock will now work normally.
Liftgate
Open the liftgate using the handle above the license plate.
Once slightly opened,
the liftgate will rise by itself. Lamps
in the liftgate will come on, illuminating the rear cargo
area (see “Rear Interior Lamps”
in the Index).
I NOTICE:
If you want to open the sliding door when the security
lock is on, unlock the sliding door from the inside and
open the door
from the outslde.
If you have the optional power sliding door, slide the
power sliding door
ON/OFF switch to the ON position.
Press either
PWR DOOR switch.
You should let adults and older children know how the
security lock works, and how to cancel the lock. If you
don’t, adults or older children who ride in the rear won’t
be able to open the sliding door from the inside when
the security lock feature is in use.
Be sure there are no overhead obstructions, such
as a garage door, before you open the liftgate.
You could slam the liftgate into something and
break the glass.
4 2-19
ProCarManuals.com

Liftgate Lock Theft
J
To unlock the liftgate, insert the door key and turn the
lock clockwise. The liftgate will automatically lock
when you close
it.
If you have the optional power door locks or the Remote
Lock Control system, the liftgate will lock and unlock
differently. See “Power
Door Locks” in the Index. Vehicle theft is big business, especially
in some cities.
Although your Oldsmobile has a number
of theft-deterrent
features, we know that nothing we put
on it can make it
impossible to steal. However, there are ways you
can help.
Key in the Ignition
If you leave your vehicle with the keys inside, it’s an
easy target for joy riders
or professional thieves -- so
don’t do it.
When
you park your Oldsmobile and open the driver’s
door, you’ll hear a chime reminding
you to remove your
key from the ignition and take
it with you. Always do this.
Your steering wheel will be locked, and
so will your
ignition and transaxle. And remember to lock the doors.
Parking at Night
Park in a lighted spot, close all windows and lock your
vehicle. Remember
to keep your valuables out of sight.
Put them in a storage area, or take them with you.
.~ 2-21
ProCarManuals.com

Parking Lots
If you park in a lot where someone will be watching
your vehicle, it’s best to lock it up and take your keys.
But what if you have to leave your ignition key? What
if
you have to leave something valuable in your vehicle?
Put your valuables in a storage area, like your glove
box
or locking storage bin.
Lock the storage bin.
0 Lock all the doors except the driver’s.
0 Then take the door key with you.
New Vehicle “Break-In”
NOTICE:
Your modern Oldsmobile doesn’t need an
elaborate “break-in.” But it will perform better
in the long run if you follow these guidelines:
Don’t drive at any one speed -- fast or
slow
-- for the first 500 miles (804 km). Don’t
make full-throttle starts.
200 miles (322 km) or so. During this time
your new brake linings aren’t yet broken
in. Hard stops with new linings can mean
premature wear and earlier replacement.
Follow this breaking-in guideline every
time you get new brake linings.
0 Don’t tow a trailer during break-in. See
“Towing a Trailer” in the Index for more
.
information.
Avoid making hard stops for the first
2-22
ProCarManuals.com

Ignition Positions
With the ignition key in the ignition switch, you can turn
the switch to five positions.
C
A E
ACCESSORY (A): An on position in which you can
operate your electrical power accessories. Press in the
ignition switch
as you turn the top of it toward you.
LOCK (B): This is the only position in which you can
remove
the key. This locks your steering wheel, ignition
and transaxle.
OFF (C): This position unlocks the steering wheel,
ignition and transaxle, but does not send electrical
power to any accessories. Use this position
if your
vehicle must be pushed
or towed, but never try to
push-start your vehicle. A warning chime will sound if
you open the driver’s door when the ignition is
OFF and
the key is
in the ignition.
RUN (D): An on position to which the switch returns
after
you start your engine and release the switch. The
switch stays
in the RUN position when the engine is
running. But
even when the engine is not running, you
can use the
RUN position to operate your electrical
power accessories, and to display some instrument panel
warning lights.
START (E): This position starts the engine. When the
engine starts, release the key. The ignition switch will
return
to the RUN position for normal driving.
ProCarManuals.com