parking brake OPEL CASCADA 2017 Manual user

Vehicle care213If w flashes for 60-90 seconds then
illuminates continuously, there is a fault in the system. Consult a
workshop.
After inflating, driving may be
required to update the tyre pressure
values in the Driver Information
Centre. During this time w may
illuminate.
If w illuminates at lower temperatures
and extinguishes after driving, this
could be an indicator for approaching
a low tyre pressure condition. Check
tyre pressure.
Vehicle messages 3 102.
If the tyre pressure must be reduced
or increased, switch off ignition.
Only mount wheels with pressure
sensors, otherwise the tyre pressure
will not be displayed and w
illuminates continuously.
A spare wheel or temporary spare
wheel is not equipped with pressure
sensors. The tyre pressure
monitoring system is not operational
for these tyres. Control indicator willuminates. For the further three
wheels the system remains
operational.
The use of commercially-available
liquid tyre repair kits can impair the
function of the system. Factory-
approved repair kits can be used.
Operating electronic devices or being close to facilities using similar wave
frequencies could disrupt the tyre
pressure monitoring system.
Each time the tyres are replaced, tyre pressure sensors must be
dismounted and serviced. For the
screwed sensor: replace valve core
and sealing ring. For clipped sensor:
replace complete valve stem.
Vehicle loading status Adjust tyre pressure to load condition
according to the tyre information label or tyre pressure chart 3 247, and
select the appropriate setting in the Tyre load menu in the Driver
Information Centre 3 95. This setting
is the reference for the tyre pressure
warnings.The menu Tyre Load only appears if
the vehicle is at a standstill and the
parking brake is applied. On vehicles
with automatic transmission, the
selector lever must be in P.
Select:
● Light for comfort pressure up to
3 people
● Eco for Eco pressure up to
3 people
● Max for full loading

214Vehicle careTyre pressure sensor matching
process
Each tyre pressure sensor has a
unique identification code. The
identification code must be matched
to a new wheel position after rotating the wheels or exchanging the
complete wheel set and if one or more
tyre pressure sensors were replaced. The tyre pressure sensor matching
process should also be performed
after replacing a spare wheel with a
road wheel containing a tyre pressure sensor.
The malfunction light w and the
warning message or code should extinguish at the next ignition cycle.The sensors are matched to the
wheel positions using a relearn tool,
in the following order: left side front
wheel, right side front wheel, right
side rear wheel and left side rear
wheel. The turn signal light at the
current active position is illuminated
until the sensor is matched.
Consult your workshop for service.
There are two minutes to match the
first wheel position, and five minutes
overall to match all four wheelpositions. If it takes longer, the
matching process stops and must be restarted.
The tyre pressure sensor matching
process is as follows:
1. Apply the parking brake.
2. Turn the ignition on.
3. On vehicles with automatic transmission: set the selector
lever to P.
On vehicles with manual
transmission: select neutral.
4. Use MENU on the turn signal
lever to select the Vehicle
Information Menu in the Driver
Information Centre.
5. Turn the adjuster wheel to scroll to
the tyre pressure menu.
6. Press SET/CLR to begin the
sensor matching process. A
message requesting acceptance
of the process should be
displayed.
7. Press SET/CLR again to confirm
the selection. The horn sounds
twice to indicate that the receiver
is in relearn mode.8. Start with the left side front wheel.
9. Place the relearn tool against the tyre sidewall, near the valve stem.Then press the button to activate
the tyre pressure sensor. A horn
chirp confirms that the sensor
identification code has been
matched to this wheel position.
10. Proceed to the right side front wheel, and repeat the procedure
in Step 9.
11. Proceed to the right side rear wheel, and repeat the procedure
in Step 9.
12. Proceed to the left side rear wheel, and repeat the procedure
in Step 9. The horn sounds twice
to indicate the sensor
identification code has been
matched to the left side rear tyre,
and the tyre pressure sensor
matching process is no longer
active.
13. Turn off the ignition.

Vehicle care2179Warning
Use of unsuitable tyres or wheels
may lead to accidents and will
invalidate the vehicle type
approval.
Wheel covers
Wheel covers and tyres that are
factory approved for the respective
vehicle and comply with all of the
relevant wheel and tyre combination
requirements must be used.
If the wheel covers and tyres used are
not factory approved, the tyres must
not have a rim protection ridge.
Wheel covers must not impair brake
cooling.
9 Warning
Use of unsuitable tyres or wheel
covers could lead to sudden
pressure loss and thereby
accidents.
Vehicles with steel wheels: When
using locking wheel nuts, do not
attach wheel covers.
Tyre chains
Use tyre chains only on front wheels.
Always use fine mesh chains that add no more than 10 mm to the tyre tread
and the inboard sides (including chain
lock).
9 Warning
Damage may lead to tyre blowout.
Tyre chains are permitted on tyres of
sizes 225/55 R17 and 245/45 R18.
The use of tyre chains is not permitted on the temporary spare wheel.
Tyre repair kit
Minor damage to the tyre tread can be
repaired with the tyre repair kit.
Do not remove foreign bodies from
the tyres.
Tyre damage exceeding 4 mm or that
is at tyre's sidewall cannot be repaired with the tyre repair kit.9 Warning
Do not drive faster than 80 km/h.
Do not use for a lengthy period.
Steering and handling may be
affected.
If you have a flat tyre:
Apply the parking brake and engage
first gear, reverse gear or P.

Vehicle care221Make the following preparations and
observe the following information:
● Park the vehicle on a level, firm and non-slippery surface. The
front wheels must be in the
straight-ahead position.
● Apply the parking brake and engage first gear, reverse gear or
P .
● Remove the spare wheel 3 223.
● Never change more than one wheel at once.
● Use the jack only to change wheels in case of puncture, not
for seasonal winter or summer
tyre change.
● The jack is maintenance-free. ● If the ground on which the vehicle
is standing is soft, a solid board
(max. 1 cm thick) should be
placed under the jack.
● Remove heavy objects from the vehicle before jacking up.
● No people or animals may be in the vehicle when it is jacked-up.
● Never crawl under a jacked-up vehicle.●Do not start the vehicle when it is
raised on the jack.
● Clean wheel nuts and thread with
a clean cloth before mounting the wheel.9 Warning
Do not grease wheel bolt, wheel
nut and wheel nut cone.
1. Disengage wheel nut caps with a
screwdriver and remove. Pull off
the wheel cover. Vehicle tools
3 210.
Alloy wheels: Disengage wheel
nut caps with a screwdriver and
remove. To protect the wheel,
place a soft cloth between the
screwdriver and the alloy wheel.Alloy wheels with centre wheel
bolt cap: Disengage centre cap by
inserting and pulling the extractor
3 210 in the recess of the brand
emblem.

Vehicle care227● A discharged vehicle battery canalready freeze at a temperature
of 0 °C. Defrost the frozen battery before connecting jump leads.
● Wear eye protection and protective clothing when
handling a battery.
● Use a booster battery with the same voltage (12 Volts). Its
capacity (Ah) must not be much
less than that of the discharged
battery.
● Use jump leads with insulated terminals and a cross section of
at least 16 mm 2
(25 mm 2
for
diesel engines).
● Do not disconnect the discharged
battery from the vehicle.
● Switch off all unnecessary electrical consumers.
● Do not lean over the battery during jump starting.
● Do not allow the terminals of one
lead to touch those of the other
lead.
● The vehicles must not come into contact with each other during
the jump starting process.● Apply the parking brake, transmission in neutral,
automatic transmission in P.
● Open the positive terminal protection caps of both batteries.
Lead connection order:
1. Connect the red lead to the positive terminal of the booster
battery.
2. Connect the other end of the red lead to the positive terminal of the
discharged battery.
3. Connect the black lead to the negative terminal of the booster
battery.
4. Connect the other end of the black
lead to a vehicle grounding point,
such as the engine block or an
engine mounting bolt. Connect as far away from the discharged
battery as possible, however at
least 60 cm.
Route the leads so that they cannot
catch on rotating parts in the engine
compartment.
To start the engine: 1. Start the engine of the vehicle providing the jump.
2. After 5 minutes, start the other engine. Start attempts should be
made for no longer than
15 seconds at an interval of
1 minute.
3. Allow both engines to idle for approx. 3 minutes with the leads
connected.

257Clock............................................. 82
Code ........................................... 102
Collision damage repair ..............252
Control indicators.......................... 88
Control of the vehicle .................137
Controls ........................................ 79
Convex shape .............................. 31
Coolant and antifreeze ...............234
Cruise control ...................... 95, 158
Cupholders .................................. 71
Curve lighting.............................. 117
D Danger, Warnings and Cautions ...4
Daytime running lights ...............117
Declaration of conformity ............249
DEF ............................................ 144
Diesel exhaust fluid ....................144
Diesel fuel system bleeding .......195
Diesel particle filter ...............93, 143
Door open .................................... 95
Doors ............................................ 26
Driver assistance systems ..........158
Driver Information Centre .............95
Driving characteristics and towing tips .............................. 183
Driving hints ................................ 137
E Electric adjustment ......................31
Electrical system......................... 204Electric parking brake ...........91, 152
Electric parking brake fault ...........91
Electronic climate control system 129
Electronic driving programmes ..149
Electronic Stability Control.......... 155
Electronic Stability Control and Traction Control system ............92
Electronic Stability Control off....... 92 End-of-life vehicle recovery .......190
Engine compartment fuse box ...205
Engine coolant ........................... 192
Engine coolant temperature gauge ....................................... 87
Engine data ............................... 241
Engine exhaust .......................... 143
Engine identification ...................237
Engine oil ................... 191, 234, 238
Engine oil pressure ......................93
Entry lighting .............................. 124
Event data recorders ..................254
Exit lighting ................................ 124
Exterior care .............................. 230
Exterior light ................................. 94
Exterior lighting ....................14, 113
Exterior mirrors ............................. 31
F
Fault ........................................... 150
First aid ......................................... 76
First aid kit ................................... 76Fixed air vents ........................... 134
Fog light ....................................... 95
Fog lights ................................... 199
Folding mirrors ............................. 31
Following distance indication ......163
Forward collision alert................. 161
Front airbag system .....................62
Front fog lights ........................... 121
Front seats.................................... 49
Front storage ................................ 71
Front turn signal lights ...............200
Fuel............................................. 179
Fuel consumption - CO 2-
Emissions ............................... 182
Fuel for diesel engines ..............180
Fuel for petrol engines ...............179
Fuel gauge ................................... 86
Fuses ......................................... 204
G Gauges ......................................... 85
General information ...................183
Glovebox ..................................... 70
Graphic-Info-Display, Colour- Info-Display ............................ 100
Ground clearance .......................137
H Halogen headlights ....................196
Hand brake ......................... 151, 152
Hazard warning flashers ............120

258Headlight flash ........................... 116
Headlight range adjustment ......116
Headlights................................... 113 Headlights when driving abroad 116
Head restraint adjustment .............8
Head restraints ............................ 47
Heated mirrors ............................. 32
Heated rear window ..................... 36
Heated steering wheel .................79
Heating ........................................ 55
Heating and ventilation system . 126
High beam ........................... 94, 115
High beam assist ..................94, 115
Hill start assist ........................... 154
Horn ....................................... 15, 80
I Identification plate .....................236
Ignition switch positions .............138
Immobiliser ............................ 30, 94
Indicators ...................................... 85
Information displays...................... 95
Instrument cluster ........................85
Instrument panel fuse box .........207
Instrument panel illumination .....204
Instrument panel illumination control .................................... 122
Instrument panel overview ........... 10
Interactive driving system ...........156
Interior care ............................... 232Interior lighting............................ 122
Interior lights ...................... 123, 204
Interior mirrors .............................. 32
Interruption of power supply ......150
Introduction .................................... 3
ISOFIX child restraint systems ....69
J Jump starting ............................. 226
K Key, memorised settings ..............23
Keys ............................................. 21
Keys, locks ................................... 21
L
Lane departure warning .......92, 178
Lashing eyes ............................... 76
Light switch ................................ 113
Load compartment ................26, 73
Load compartment fuse box ......208
Loading information .....................77
Low fuel ....................................... 94
M
Malfunction indicator light ............90
Manual anti-dazzle ......................32
Manual mode ............................. 149
Manual seat adjustment ...............50
Manual transmission .................. 151
Memorised settings ......................23Mirror adjustment ........................... 8
Misted light covers .....................122
N
New vehicle running-in ..............138
Number plate light .....................203
O Object detection systems ...........164
Odometer ..................................... 85
Oil, engine .......................... 234, 238
OnStar ........................................ 108
Operate pedal ............................... 91
Outside temperature ....................82
Overrun cut-off ........................... 139
P Parking ................................ 19, 141
Parking assist ............................ 164
Parking brake ............................ 152
Parking lights ............................. 122
Particulate filter ........................... 143
Performance .............................. 242
Performing work ........................190
Pollen filter ................................. 134
Power outlets ............................... 84
Power seat adjustment ................53
Power steering.............................. 92
Power windows ............................ 33
Preheating ................................... 93
Puncture ..................................... 220