fold seats OPEL MERIVA 2009 User Guide

54 Seats, Interior
Picture no: 14182s.tif
Grasp the backrest, pull the handle at the
outboard side of the seat and fold the
backrest onto the seat. Release the handle
and engage the backrest.
To raise, pull the handle on the outboard
side of the seat and raise the backrest.
Release the handle and engage.
Insert the seat belt into the belt guide at
backrest.
Picture no: 14728s.tif
Fold the centre seat forward and lower.
House centre seat belt in the holder in the
ceiling 363.
Insert seat belts into recesses in seat
cushion.
Slide centre seat head rest all the way
down 347.
Pull release handle on the back of the
centre seat backrest, see figure. Fold
backrest forward and engage. The entire
seat is lowered.
Picture no: 14716s.tif
Raise centre seat
Pull release handle on the back of the
backrest, erect the ba ckrest and engage,
the outer seats must be in the outer
position, see Variant 1: Three rear seats
3 52.
Lower outboard seats
Push front seat forward and fully lower or
remove head restraints on the rear
outboard seats 347.
Fold outer rear seat backrests onto seat
bases.
To achieve a level loading surface, pull
release handle on back of backrest and
push seat down until it latches into
position.
9 Warning
To prevent injuries, always hold the seat
backrest firmly and guide downward
when folding.
9 Warning
The load must not hinder the operation
of the hand brake or gear lever 358.

55
Seats, Interior
Raise outboard seats
Pull release handle on back of backrest
and pull seat upward until it engages.
Pull handle on outboard side of rear seat
and move rear seat backrest upright.
Release handle and latch.
Insert the seat belt in to the belt guide at
backrest.
The backrest can be raised to an upright
position even with the seat lowered. We
recommend however only using the seat as
a seat in the higher position.
Picture no: 14107S.tif
Fold down passenger seat backrest 3
Push head restraint all the way down or
remove 33, 346.
Push front passenger seat back.
Lift release lever and fold front passenger
seat backrest down.
Raise front passenger seat backrest 3
Press release lever forward, restore
passenger seat backrest to upright
position and engage audibly.
Picture no: 14735S.tif
Luggage compartment cover
3
Do not place any heavy or sharp-edged
objects on the cover.
To open
Lift cover at rear and tilt forward segment
by segment.
To close
Tilt top part of cover backward and latch
into position.

56 Seats, Interior
Picture no: 15272s.tif
Removing
Open cover, disengage toward the rear
and remove from above.
Fitting
Insert the cover from the rear, clip into
place and fold back.
Picture no: 14736s.tif
Safety net
3
The safety net can be mounted behind the
front seats. The rear seat backrests are
folded forward.
Passengers must not be carried behind the
safety net.
Fitting
The safety net is in the luggage
compartment below the floor covering, see
right-hand column.
Fold all rear seat backrests forward, see
Extending the luggage compartment 353.
The roof frame contains two mounting
openings: Open covers. Hang the upper
net rod first in one opening and then in the
other side; clip in place forwards.
Picture no: 17952S.tif
Hook the net straps into slots on the outer
seat bracket of the front seats and tighten.
When the safety net is fitted for the first
time, the slots on the outer seat consoles of
the front seats must be opened once: press
marked area on upper edge with a blunt
object and bend inward.
Removing
Tilt strap length adjuster upwards and
unhook straps at bottom. Unhook upper
net rod and close mounting openings.

58 Seats, Interior
Picture no: 14110s.tif
Notes on loading the vehicle zHeavy objects in the luggage
compartment should be placed as far
forward as possible against the properly
engaged rear seat backrests or, if the
rear seat backrests are folded down,
against the front seat backrests. If
objects are to be stacked, the heavier
objects should be placed at the bottom.
z Secure heavy objects with lashing
straps 3 attached to lashing eyes 357.
z When transporting objects with rear seat
backrests tilted forward, fit the safety net
356. z
Close luggage compartment cover 3
3 55.
z If the backrests are not folded down
when transporting objects in the
luggage compartment, they must be
engaged in an upright position 355.
z Do not allow the load to protrude above
the upper edge of the backrests.
z The warning triangle 3 and first-aid kit
(cushion) 3 must always be freely
accessible.
z Do not place any objects on the luggage
compartment cover 3 or the instrument
panel.
z No objects must be placed in the airbag
inflation area, since they could cause
injury when the systems are triggered.
z Items loaded must not prevent operation
of the pedals, hand brake and gears or
obstruct the freedom of movement of
the driver. Do not place loose objects in
the interior.
z Do not drive with luggage compartment
open when transporting bulky objects,
for example, since toxic exhaust fumes
could penetrate the interior.
z The payload is the difference between
the permitted gross vehicle weight (see
identification plate 3218) and the EC
kerb weight. z
To calculate the EC kerb weight, enter
the data for your vehicle on page 3 226.
z The EC kerb weight includes allowances
for the driver (68 kg), luggage (7 kg) and
all fluids (tank 90 % full).
z Optional equipment and accessories
increase the kerb weight.
z Weights and loads 3226.
z Driving with a roof load increases the
sensitivity of the vehicle to cross-winds
and has a detrimental effect on vehicle
handling due to the vehicle’s higher
centre of gravity. Distribute the load
evenly and secure it properly with
retaining straps. Adjust the tyre pressure
to the load conditions. Do not drive
faster than 120 km/h. Check and re-
tighten the straps frequently. Observe
country-specific regulations.
z The permissible roof load is 100 kg. The
roof load consists of the weight of the
roof rack plus the load carried.

64 Seats, Interior
Picture no: 14739S.tif
To remove the seat belt, press the button
on the left buckle (2). If the centre seat is
lowered, press the button on the right
buckle ( 1). The seat belt retracts
automatically.
Push the upper latch pl ate into the holder
for the lower latch plate. Fold over locked
together latch plates against the seat belt.
Picture no: 14740S.tif
Insert in the seat belt holder in the roof with
the lower latch plate pointing forward.
Mounting clips
3 for ISOFIX child
restraint systems
The ISOFIX points for fitting a child seat are
located between the seat backrest and the
seat surface.
Fasten permitted ISOF IX child restraint
systems to the mounting brackets.
Closely follow the installation instructions
accompanying the ISOFIX child restraint
system.

81
Seats, Interior
Picture no: 11701s.tif
Stowage compartment for glasses 3
On driver’s side: fold down to open.
Do not store heavy objects in the stowage
compartment.
Picture no: 18601s.tif
Foldaway tables
3
These are located in the front seat
backrests.
Open by pulling upward until it engages.
Fold away by pressing down past the
resistance point.
Do not place any heavy objects on the
table.
Picture no: 14116s.tif
Coin holder
3
In the centre console. Sun visors Use the sun visor to protect from glare by
pulling it down and swivelling it to the side.
The mirror covers in the sun visors should
be closed while driving.