remote control OPEL MERIVA 2009 User Guide
[x] Cancel search | Manufacturer: OPEL, Model Year: 2009, Model line: MERIVA, Model: OPEL MERIVA 2009Pages: 248, PDF Size: 4.46 MB
Page 36 of 248

30 Keys, doors, windows, slide and tilt sunroof
Picture no: 15335t.tif
Central locking system Unlock and lock doors, tailgate and fuel
filler flap.
To unlock
Press button q on remote control
– or from the inside –
Release lock button on driver’s door.
To open the door, pull the handle. Open
the luggage compartment by pulling the
button in the handle recess. When the mechanical anti-theft locking
system
3 is enabled, the doors cannot be
unlocked by pulling up the lock buttons.
Country-specific version 3: pressing once
unlocks the driver’s door, and pressing
twice unlocks the entire vehicle.
Picture no: 15333t.tif
To lock
Close doors, luggage compartment and
tank flap.
Press button p of the radio remote control
– or from the inside –
Press lock button on driver’s door when the
doors are closed.
Page 37 of 248

31
Keys, doors, windows, slide and tilt sunroof
Picture no: 15334t.tif
Mechanical anti-theft locking system 3
All doors must be closed.
If the ignition was on, the driver’s door
must be opened and closed once so that
the vehicle can be secured.
All doors are secured against opening. Within 10 seconds of
locking, press the
p button on the remote control again.
The mechanical anti-theft locking system is
switched off when the vehicle is unlocked.
Note
z To prevent the driver from being
inadvertently locked out, the button on
the driver’s door cannot be depressed
when the door is open.
z If the driver’s door is not closed properly,
the central locking system will unlock
again immediately after locking.
z The doors lock again automatically a
short time after unlocking the vehicle
using the remote control if no door is
opened in the meantime.
z To lock the doors from inside (e.g. to
prevent unwanted entry from outside),
push down lock button on driver’s door.
z Locked doors unlock automatically if an
accident of a certain severity occurs (to
permit outside assistance) – Prerequisite:
Ignition must not be switched off. Fault
If the central locking cannot be operated,
this can be for one of the following reasons:
z
If the central locking system is
overloaded as a result of repeated
operation at short intervals. The power
supply is cut off for a brief period.
z Faulty fuse in fuse box 3182.
To eliminate the cause of the fault, contact
a workshop.
Opening driver’s door with key.
9 Warning
Do not use the system if there are people
in the vehicle! The doors cannot be
unlocked from the inside.
Page 38 of 248

32 Keys, doors, windows, slide and tilt sunroof
Picture no: 17881s.tif
Malfunction in remote controlTo unlock
Turn key anticlockwise in driver’s door lock,
return to the vertical position and remove.
The entire vehicle is unlocked. Switch on the
ignition to deactivate the anti-theft alarm
system 3 .
To lock
With the driver’s door closed, turn the key
clockwise in the lock, return to the vertical
position and remove. The entire vehicle is
locked.
Malfunction in central
locking system To unlock
Turn key anticlockwise in driver’s door lock,
return to the vertical position and remove.
The driver’s door is unlocked. The other
doors can be unlocked by pulling the
interior lock buttons (not possible if the
anti-theft locking system is enabled 3).
Switch on the ignition to deactivate the
anti-theft alarm system 3.
To lock
With the driver’s door open, press the
interior lock button of the other doors.
Close the driver’s door. Turn the key
clockwise in the lock, re turn to the vertical
position and remove. The fuel filler flap
cannot be locked.
Picture no: 15335t.tif
Tailgate To unlock
Press button q on the remote control, the
tailgate and the doors will be unlocked.
Page 39 of 248

33
Keys, doors, windows, slide and tilt sunroof
Picture no: 17873s.tif
To open
The tailgate is opened by pulling on the
button in the handle recess.
After fitting certain accessories, it might
not be possible to keep the tailgate in the
open position.
Picture no: 17882s.tif
To close
Close the tailgate usin g the handle on the
inside of the tailgate.
Do not press the release button in the trim
recess while closing as this will unlock it
again.
Picture no: 15333t.tif
To lock
Press button p on radio remote control.
9 Warning
Do not drive with the tailgate open or
ajar, e.g. when transporting bulky
objects, since toxic exhaust gas could
penetrate the interior.
Page 40 of 248

34 Keys, doors, windows, slide and tilt sunroofAnti-theft alarm system
3
Monitors
zthe doors, luggage compartment,
bonnet.
z the passenger compartment.
z vehicle tilt, e.g. if it is raised.
z the ignition.
Picture no: 15334t.tif
To activate
All doors, windows, sun roof 3, tilting
roof 3 and bonnet must be closed. Press
button p on the radio remote control
again within 10 seconds of locking.
If the ignition was switched on, the driver’s
door must be opened and closed once so
that the anti-theft alarm system can be
switched on.
Picture no: 11575s.tif
Activation without monitoring of
passenger compartment and vehicle tilt
Switch on e.g. if animal s are to be left in the
vehicle.
1. Close tailgate and bonnet.
2. Press button in front of the courtesy lamp
(with ignition off); LED in the hazard
warning lamp button flashes a
maximum of 10 seconds.
3. Close doors.
4. Activate the anti-theft alarm system. The LED lights up. After approx. 10 seconds,
the system is activated. The LED flashes
until the system is deactivated.
9 Warning
Do not use the system if there are people
in the vehicle! The doors cannot be
unlocked from the inside.
Page 41 of 248

35
Keys, doors, windows, slide and tilt sunroof
Picture no: 14046s.tif
Light emitting diode (LED)
During the first 10 seconds of anti-theft
alarm system activation: After the first 10 seconds of anti-theft
alarm system activation:
Contact a workshop for assistance if
problems are encountered.
Picture no: 15335t.tif
To deactivate
Press button
q on remote control unit
– or –
switch on ignition.
In the case of a malfunction in the remote
control, use the key to unlock the vehicle
3 32.
If the alarm is triggered when the driver’s
door is opened, deactivate the anti-theft
alarm system by switching on the ignition.
z
LED comes on
= Test, delayed
switch-on,
z LED flashes
rapidly = Door, tailgate or
bonnet open, or
system fault.
zLED flashes
slowly =System switched on,
z LED comes on for
approx. 1 second = Switch-off function.
Page 42 of 248

36 Keys, doors, windows, slide and tilt sunroofNote
zChanges to the vehicle interior, such as
the use of seat covers, could impair the
function of passenger compartment
monitoring.
z Switch off the interior monitoring system
when the interior of a parked vehicle is
being heated.
Alarm
When triggered, the alarm gives off an
acoustic signal (horn) and a visual signal
(hazard warning flashers). The number
and duration of the alarms are stipulated
by legislation.
The alarm can be silenced by pressing a
button on the remote control or by
switching on the ignition. The anti-theft
alarm system is deactivated at the same
time.
Picture no: 16102s.tif
Child safety locks Turn rotary knob at rear door lock from
vertical position using key: door cannot be
opened from the inside.
Picture no: 13985s.tif
Exterior mirrors Adjust manually with the handles in the
front door or electrically 3 with the switch
in the driver’s door console.
Adjust exterior mirrors manually
Use the knob to move the exterior mirrors in
the appropriate direction.
9 Warning
Use the child safety lock whenever
children are occupying the rear seats.
Page 46 of 248

40 Keys, doors, windows, slide and tilt sunroof
Picture no: 14804s.tif
Operation
To operate window in stages, tap
appropriate switch. For automatic opening
or closing, keep switch pressed for slightly
longer; to stop window movement, tap
switch again.
Safety function
If the window glass encounters resistance
above the middle of the window during
automatic closing, it is immediately
stopped and the wind ow opened again.
If the windows do not move easily (e.g. on
account of frost), repeatedly tap the switch
for the window in question until the window
has been closed in stages.
Picture no: 14140s.tif
Child safety system for rear windows 3
Switch between the rocker switches in the
handle on the driver’s door
z to left (red control indicator visible): rear
windows cannot be operated with the
rocker buttons in the rear doors,
z to right (green control indicator visible):
rear windows can be operated with the
rocker buttons in the rear doors.
Picture no: 17899s.tif
Closing windows 3 from outside
On vehicles with electric windows in all
doors, the windows can be closed from
outside:
Hold button p of the remote control
depressed until all of the windows have
closed completely.
Page 113 of 248

107
Lighting
Picture no: 14302s.tif
Lead-me lighting
3
Lead-me lighting when leaving the
vehicle 3
The dipped headlamps come on for
around 30 seconds after switching on and
closing the driver’s door.
To activate:
1. Switch off ignition.
2. Remove ignition key.
3. Open driver’s door.
4. Pull turn signal stalk toward steering
wheel.
5. Close driver’s door. If the driver’s door is left open, the lamps
will go out after two minutes.
The light is switched off immediately by
inserting the key into
the ignition or pulling
the turn signal stalk towards the steering
wheel again.
Picture no: 17920S.tif
Lead-me lighting when opening the
vehicle 3
The Lead-me-to-the-car lighting function
allows the dipped headlamps to be lit for
around 30 seconds using the remote
control.
This function must be activated (once):
Unlock the vehicle, put the key in the
ignition and press the light switch for
approx. 5 seconds - see next page,
Fig. 14136 S.
To deactivate the function permanently,
contact a workshop.
Page 114 of 248

108 LightingTo activate the lead-me-to-the-car light
function, press button q on the remote
control twice with the vehicle locked.
Country-specific version 3: to enable the
lead-me-to-the-car function, press
button q on the remote control once with
the vehicle locked.
The lead-me-to-the-car light function is
deactivated immediately by pressing
button p of the remote control or
switching on the ignition.
Picture no: 14759s.tif
Instrument illumination
k,
Information display illumination
Lights come on when ignition is switched on.
Brightness can be adjusted when the
exterior lights are on: Push to release knob
k and then turn it clockwise or
anticlockwise and hold until the desired
brightness is obtained.
Display mode 3 396.
Picture no: 14136s.tif
Courtesy lamp Automatic interior light
Comes on automatically when the vehicle is
unlocked with the radi o remote control or
when a door is opened.
Goes off automatically after a delay when
the doors are closed or immediately when
the ignition is switched on or the doors are
locked.
Front courtesy lamp
To operate manually from inside when the
doors are closed: on = Press light switch 0
off = Press light switch 0 again