warning lights OPEL MERIVA 2009 Owners Manual

11
In Brief
Picture no: 14727s.tif
Exterior lights Rotate
Press
Lighting 3102, headlamp warning device
3 17.
Picture no: 18475s.tif
Headlamp flash, main beam and
dipped beam Main beam, headlamp flash 3103.
Picture no: 14054h.tif
Turn signals Turn signal lamps 3103.
7
=Off
8 = Parking lamps
9 = Dipped or main beam
> =Fog lamps 3
r = Fog tail lamp
Headlamp flash = Pull stalk towards
steering wheel
Main beam = Push stalk forwards
Dipped beam = Push stalk forwards again
Right = Lever upwards
Left = Lever downwards

34 Keys, doors, windows, slide and tilt sunroofAnti-theft alarm system
3
Monitors
zthe doors, luggage compartment,
bonnet.
z the passenger compartment.
z vehicle tilt, e.g. if it is raised.
z the ignition.
Picture no: 15334t.tif
To activate
All doors, windows, sun roof 3, tilting
roof 3 and bonnet must be closed. Press
button p on the radio remote control
again within 10 seconds of locking.
If the ignition was switched on, the driver’s
door must be opened and closed once so
that the anti-theft alarm system can be
switched on.
Picture no: 11575s.tif
Activation without monitoring of
passenger compartment and vehicle tilt
Switch on e.g. if animal s are to be left in the
vehicle.
1. Close tailgate and bonnet.
2. Press button in front of the courtesy lamp
(with ignition off); LED in the hazard
warning lamp button flashes a
maximum of 10 seconds.
3. Close doors.
4. Activate the anti-theft alarm system. The LED lights up. After approx. 10 seconds,
the system is activated. The LED flashes
until the system is deactivated.
9 Warning
Do not use the system if there are people
in the vehicle! The doors cannot be
unlocked from the inside.

72 Seats, InteriorThe curtain airbags will not be triggered in
the event of
zthe ignition is switched off,
z frontal collisions,
z accidents in which the vehicle overturns,
z collisions involving a rear impact,
z collisions involving a side impact outside
the passenger cell.
Picture no: 17885s.tif
Control indicator v for airbag systems
The function of the airbag systems and
seat occupancy recognition 3 is monitored
electronically and indicated via control
indicator v. When the ignition is turned on,
the control indicator comes on for
about 4 seconds. If it does not light, does
not go out after 4 seconds or comes on
during driving, there is a fault in the airbag
systems, the seat occupancy recognition
system 3 or the belt tensioners 361. The
systems may fail to deploy in the event of
an accident.
Deployed airbags are indicated by
continuous illumination of v. The system’s integrated self-diagnostics
allows faults to be quickly remedied.
Seat occupancy recognition
3
The seat occupancy recognition system
deactivates the front and side front
passenger airbags if the front passenger
seat is unoccupied or an Opel child
restraint system with transponders 3 has
been fitted to the front passenger seat. The
curtain airbag system 3 remains activated.
The control indicator for seat occupancy
recognition
y is located in the courtesy
lamp. If this control indicator
y illuminates
for approx. 4 seconds after the ignition is
switched on, the vehicle is equipped with
seat occupancy recognition 373,
Fig. 12097 S.
If an Opel child restraint system with
transponders 3 is fitted, this control
indicator
y lights permanently after the
ignition is switched on as soon as the
system has detected the child restraint
system. Only then may the child restraint
system with transponders 3 be used on the
passenger seat.
9 Warning
Keep the area in which the airbag
inflates clear of obstructions.
9 Warning
Have the cause of the fault remedied
immediately by a workshop.

82 Instruments, ControlsInstruments, ControlsControl indicators ................................ 82
Instrument display ............................... 87
Information display ............................. 90
Warning buzzers.................................. 100
Windscreen wipers ............................... 100
Picture no: 17876s.tif
Control indicators The control indicators described here are
not present in all vehicles. The description
applies to all instrument versions.
The colours of the control indicators mean:
Picture no:
X
Seat belt 3
Control indicator lights up red.
This comes on after turning on the ignition
(with warning tone) until the seat belt is
done up.
Fasten seat belt 362. B
Adaptive headlamp 3 (AFL)
Control indicator lights up and/or flashes
yellow.
Lamps

Fault in system. Contact a workshop for
assistance.
z
Red
Danger, important reminder.
z Yellow
Warning, information, fault.
z Green
Switch-on confirmation.
z Blue
Switch-on confirmation.

84 Instruments, Controls
Picture no: 17876s.tif
I

Engine oil pressure
Control indicator lights up red
It illuminates when the ignition is switched
on and goes out shortly after the engine
starts.
Illuminates when the engine is running
1. Depress clutch.
2. Move gearshift lever to neutral, or with
manual transmissi on automated 3 place
selector lever in N.
Picture no:
3. Move out of the flow of traffic as quickly
as possible without impeding other
vehicles.
4. Switch off ignition.
Contact a workshop for assistance.
Caution
Engine lubrication may be interrupted.
This may result in damage to the engine
and/or locking of the drive wheels.
9 Warning
When the engine is off, considerably
more force is needed to brake and steer.
Do not remove key until vehicle has
come to a standstill, otherwise the
steering column lock could engage
unexpectedly.
O

Turn signal lamps
Control indicator flashes green.
The control indicator flashes if a turn signal
or the hazard warning flashers are
activated.
Rapid flashing: failure of a direction
indicator lamp or associated fuse.
Change bulbs 3 185. Fuses 3182.
C

Main beam
Control indicator lights up blue.
It is illuminated when main beam is on and
during headlamp flash 311, 3102.
j

Automatic transmission 3, start engine.
Control indicator lights up yellow.
The engine can only be started if the foot
brake is depressed. If the foot brake is not
depressed, the control indicator illuminates
3 130.

85
Instruments, Controls
Picture no: 18385s.tif
T
Winter mode for manual transmission
automated 3
Control indicator lights up yellow.
Control indicator lights up when winter
program is enabled 3132. m

Cruise control 3
Control indicator lights up green
This comes on when the system is switched
on 3148.
r
Fog tail lamp
Control indicator lights up yellow.
This comes on when the fog tail lamp is
switched on 3104.
Picture no:
p

Alternator
Control indicator lights up red.
It illuminates when the ignition is switched
on and goes out shortly after the engine
starts.
Illuminates when the engine is running
Stop, switch off engine. Battery is not
charging. Contact a workshop
immediately. R

Brake system, clutch system
Control indicator lights up or flashes red.
Illuminated
Illuminates when the ignition is switched on
if the hand brake is applied 3151.
Lights up when the hand brake is released
when the fluid level for the brake or clutch
systems is low 3214.
FlashesOn vehicles with manual transmission
automated 3, control indicator R flashes
for a few seconds after the ignition is
switched off when the hand brake has not
been applied. u

Anti-lock brake system
Control indicator lights up red.
Illuminates while driving
Fault in anti-lock braking system 3152. S

Engine oil level 3
Control indicator lights up yellow.
The engine oil level is checked
automatically 3.
Illuminates when the engine is running

Engine oil level too lo w. Check engine oil
level and top up engine oil if necessary
3 210.
9 Warning
Stop. Do not continue your journey.
Consult a workshop.

88 Instruments, Controls
Picture no: 17906s.tif
Coolant temperature display
Coolant temperature display For physical reasons, the engine
temperature gauge shows the coolant
temperature only if the coolant level is
adequate.
During operation the system is pressurised.
The temperature may therefore rise briefly
to over 100 C.
Picture no: 17907s.tif
Fuel gauge
Fuel tank level display.
If the fuel level is too low, a warning lamp
lights up
Y. When the light flashes, refuel as
soon as possible.
Never run the tank dry!
Because of the fuel remaining in the tank,
the amount of fuel required to fill the
tank may be less than the specified tank
capacity.
Pointer in zone at
left
= Engine operating
temperature not yet
reached.
Pointer between
the zones = Normal operating
temperature.
Pointer in zone at
right (warning
zone) = Temperature too
high: Stop vehicle
and switch off
engine. Danger to
engine. Check
coolant level
immediately 3 213.

102 LightingLighting
Picture no: 14756s.tif
Exterior lightsTurn light switch:
In positions 8 and 9, the tail lamps and
number plate lamps are also on.
If the ignition is switched off when main
beam or dipped beam is on, the parking
lamps come on. Model with daytime running lights
3
With ignition on and lights turned on 7, the
dipped headlamps are on without
instrument illumination.
The daytime running lig hts switch off when
the ignition is switched off.
Follow the regulations of the country in
which you are driving when using daytime
running lights and fog lamps 3.
Driving abroad 3110.
Exterior lights ....................................... 102
Main beam, headlamp flash .............. 103
Turn signal lamps ................................ 103
Fog lamps > 3
.................................... 103
Fog tail lamp r................................... 104
Reversing lamps................................... 104
Hazard warning lamps ....................... 104
Headlamp range adjustment ?......... 104
Adaptive Forward Lighting 3 (AFL) .. 106
Lead-me lighting 3............................. 107
Instrument illumination k,
Information display illumination ...... 108
Courtesy lamp...................................... 108
Battery discharge protection 3.......... 110
Misted light covers............................... 110
Headlamps when driving abroad ...... 110 7
=Off
8 = Parking lamps
9 = Dipped or main beam

133
Driving and operation
Picture no: 14083j.tif
Manoeuvring the vehicle
For accurate manoeuvring when parking,
at garage entrances etc., the creeping
movement can be utilised by releasing the
foot brake with a gear selected.
Never actuate accelerator and brake
pedals simultaneously.
To prevent damage, the manual
transmission automated deactivates the
"creep function" when the temperature of
the automatic clutch is extremely high. Vehicle storage
Apply the handbrake and remove the key
from the ignition. The most recently
engaged gear (indicator in transmission
display) remains engaged. With
N, no gear
is engaged.
When the ignition is switched off the
manual transmission automated no longer
responds to movement of the selector
lever.
If the ignition key is not removed, the
battery may be discharg ed if the vehicle is
then left to stand for a lengthy period of
time.
If the hand brake has not been applied, the
control indicator R flashes for a few
seconds after the ignition is switched off.
Picture no: 17890s.tif
Fault
To prevent damage to the automated
manual transmission, the clutch is closed
automatically at high clutch temperatures.
Warning light A lights up if there is a fault.
It is possible to continue driving but manual
mode can no longer be used for changing
gear.
If "F" also appears in the transmission
display, it is not possible to continue
driving.
Have cause of fault remedied by a
workshop. The system’s integrated self
diagnostics allow faults to be quickly
remedied.

147
Driving and operation
Control indicator
v
The warning light lights up for a few
seconds when ignition is switched on. Once
it goes out, the system is ready for
operation.
Flashing during driving:
This shows the system has come into
action. The engine output may be reduced
(the sound of the engine changes) and the
vehicle may be braked automatically to a
small degree.
Picture no: 17892s.tif
Illuminates while driving:
Fault in the system. Driving can be
continued. Poor road surface conditions
may however still cause vehicle stability to
be impaired.
Have the cause of the fault eliminated.
Self-diagnosis integrated into the system
allows rapid fault identification. Illuminates after interruption of power
supply e.g. after disconnecting battery.
After a power supply interruption the
steering angle sensor must be calibrated to
make the system operational:
z
Automatic calibration driving in straight
line at constant slow (20 to 40 km/h)
speed on level, dry road.
z Manual calibration by turning steering
wheel from limit position to limit position.
If the indicator lamp does not go off after
successful calibration , observe notes in
middle column.