clock OPEL MOVANO_B 2020 Manual user

280Vehicle care
3. Detach bulb from bulb holder andrenew the bulb.
4. Insert the bulb holder and rotate clockwise to secure.
Tail lights
Turn light, tail and brake light,
reversing light, rear fog light
1. Remove the upper and lower trim panels from the rear pillar.
2. Unscrew the two nuts from the locating pins on the rear of the
lamp assembly.
3. Withdraw the lamp assembly rearwards from the outer side.
4. Detach wiring connector from lamp assembly.
5. Remove the three screws from the rear of the lamp assembly.
6. Remove bulb holder from the lamp assembly.

Vehicle care2817. Push bulb into socket slightly,rotate anticlockwise, remove and
renew bulb.
Turn light ( 1)
Tail and brake light ( 2)
Reversing light ( 3)
Rear fog light, may be on one side only ( 4)
8. Replace bulb holder in lamp assembly.
9. Replace the three screws on the rear of the lamp assembly.
10. Reattach wiring connector to lamp
assembly.
11. Replace lamp assembly from the outer side into original position,
ensuring that it is seated correctly.
12. Replace the two nuts onto the locating pins on the rear of the
lamp assembly.
13. Install the upper and lower trim panels to the rear pillar.Crew Cab, Chassis CabTurn light, tail and brake light,
reversing light, rear fog light
1. Remove the four screws from the lens.
2. Remove lens from the aperture.
3. Push bulb into socket slightly, rotate anticlockwise, remove and
renew bulb.
Turn light ( 1)
Tail and brake light ( 2)
Reversing light ( 3)
Rear fog light, may be on one side
only ( 4)
4. Install lens in aperture and replace the four screws.

284Vehicle careInterior lightsLED lights
Have lights repaired by a workshop in case of failure.
Front courtesy light
1. Remove lamp assembly using a flat blade screwdriver.
2. Renew bulb.
3. Install lamp assembly.
Load compartment light
1. Remove lamp assembly using a flat blade screwdriver.
2. Detach wiring connector from lamp assembly.
3. Remove lens cover and renew bulb.
4. Install lens cover and attach wiring connector to lamp
assembly.
5. Install lamp assembly.
Front door panel light
1. Remove lamp assembly using a flat blade screwdriver.
2. Rotate bulb holder anticlockwise to disengage.
3. Renew bulb and insert the bulb holder.
4. Install lamp assembly.
Rear courtesy lights
Have bulbs replaced by a workshop.
Glovebox light
Have bulbs replaced by a workshop.

302Vehicle care
To release the spare wheel, loosen
cable by connecting the wheel
wrench and adapters (depending on
vehicle) to the slot position illustrated
and lower the wheel fully by turning
wrench clockwise.
Caution
Only use the wheel wrench and
adapters (depending on vehicle)
to lower the spare wheel.
The use of pneumatic tools is
prohibited. This may result in
damage to the winch cable and
equipment.
Place wheel upright, unclip retainer
from wheel rim and release the wheel
from the cable and connected
retainer by routing these components through the centre of the wheel.
Twin rear wheel vehicles have an
additional mounting plate attached to
the spare wheel. Before using the
wheel, undo the nut and remove the
mounting plate.When reinstalling a spare wheel, first
attach the mounting plate (twin rear
wheel vehicles) and secure with the
nut.
Place wheel upright, then route the
cable and connected retainer from
the front of the wheel (side with tyre
valve) and through the centre of the
wheel. Attach the retainer and clip it
into place, ensuring it is correctly
positioned and that the front of the
wheel (side with tyre valve) will be
facing upwards when reinstalled.

Vehicle care303
Place wheel below the vehicle frame,
directly beneath the winch
mechanism.
Then tighten cable using the wheel
wrench and adapters by connecting
to the slot position illustrated above
and turning wrench anticlockwise
until the wheel is secured in the fully
raised position.
Note
Do not place a wheel with aluminium rim under the vehicle frame.9 Warning
Ensure the front of the wheel (side
with tyre valve) is facing upwards
when the spare wheel is
reinstalled below the vehicle
frame.
Temporary spare wheel
Caution
The use of a spare wheel that is smaller than the other wheels or in combination with winter tyres
could affect driveability. Have the defective tyre replaced as soon as
possible.
Only mount one temporary spare
wheel. Do not drive faster than
80 km/h. Take curves slowly. Do not use for a long period of time.
Separately supplied bolts must be
used for the temporary spare wheel.
These are allowed only for the
temporary spare wheel. Refer to an
label on the temporary spare wheel.
Tyre chains 3 295.
Summer and winter tyres
If you use winter tyres, the spare
wheel may still be fitted with a
summer tyre.
If you use the spare wheel when it is
fitted with a summer tyre the vehicle's driveability may be affected,
especially on slippery road surfaces.
Directional tyres Fit directional tyres such that they rollin the direction of travel. The rolling
direction is indicated by a symbol
(e.g. an arrow) on the sidewall.

306Vehicle care
Lead connection order:1. Connect the red lead to the positive terminal (1) of the booster
battery.
2. Connect the other end of the red lead to the jump start terminal (2)
of the vehicle with the discharged
vehicle battery.
3. Connect the black lead to the negative terminal (3) of the
booster battery.
4. Connect the other end of the black
lead to a vehicle grounding point
(4), such as the engine block or an
engine mounting bolt. Connect as
far away from the discharged
vehicle battery as possible,
however at least 60 cm.
Route the leads so that they cannot
catch on rotating parts in the engine
compartment.
To start the engine: 1. Start the engine of the vehicle providing the jump start.
2. After 5 minutes, start the other engine. Start attempts should be
made for no longer than
15 seconds at an interval of
1 minute.
3. Allow both engines to idle for approx. 3 minutes with the leads
connected.
4. Switch on electrical consumers (e.g. headlights, heated rear
window) of the vehicle receiving
the jump start.
5. Reverse above sequence exactly when removing leads.Towing
Towing the vehicle The towing eye and wheel wrench are
stowed with the vehicle tools 3 290.
Disengage the cover using a suitable
tool and remove.
Screw the towing eye clockwise into
the front towing point and tighten fully using the wheel wrench.
Attach a tow rope – or better still a tow
rod – to the towing eye, never to the
bumper or front suspension units.

343Battery.................... 21, 22, 216, 274
Battery discharge protection ......117
Battery, jump starting.................. 304
Battery replacement ...................166
Belts.............................................. 55 Bluetooth .................................... 193
Bluetooth connection ..........156, 197
Bluetooth device list ...................197
Bluetooth music .......................... 156
Bonnet ....................................... 270
Bottle holders................................ 74
Brake assist ............................... 246
Brake fluid .......................... 274, 313
Brakes ............................... 244, 274
Brake system ............................. 100
Breakdown.................................. 306
Browse map................................ 183
Bulb replacement ....................... 277
Bus Rear seats ................................. 52
C Cabin bulkhead grille ....................80
Call lists ...................................... 201
Call waiting ................................. 201
Capacities .................................. 317
Cargo management system ........78
Car Pass ...................................... 21
Catalytic converter .....................234
Central locking system ................24Centre high-mounted brake light 282
Change Home location ...............166
Change passkey for Bluetooth connection ............................... 197
Change system language ...129, 139
Changing tyre and wheel size ...295
Charging system .......................... 99
Child locks ................................... 29
Child restraint installation locations ................................... 67
Child restraints.............................. 65
Child restraint systems ........65, 339
Cigarette lighter ........................... 91
Cleaning ..................................... 334
Cleaning the vehicle ...................308
Climate control ............................. 16
Climate control systems .............208
Clock ................... 88, 129, 139, 166
Coat hooks ................................... 74
Compass .................................... 166
Connecting an audio device .......156
Connection ................................. 195
Control elements overview .........122
Control indicators.......................... 95
Control of the vehicle .................225
Controls ........................................ 85
Convex shape .............................. 38
Coolant ....................................... 272
Coolant and antifreeze ...............313
Coolant heater ............................ 216Co-ordinates....................... 166, 177
Country information ............183, 200
Cruise control ....................103, 249
Cupholders .................................. 74
D DAB ............................................ 151
Danger, Warnings and Cautions ...4
Dashboard .................................... 11
Data sharing settings ..................129
Daytime running lights ...............113
Daytime running lights setting ....129
Deactivating Bluetooth function ..197
Deactivating guidance ................183
Declaration of conformity ....319, 335
DEF ............................................ 234
Defining the priority phone .........195
Delete a favourite destination .....177
Delete device from Bluetooth device list ................................ 197
Demisting and defrosting ..............16
Destination.................................. 166
Destination input ........................177
Dialling a telephone number .......201
Diesel exhaust fluid ....................234
Diesel fuel ................................... 262
Diesel fuel system bleeding .......276
Diesel particle filter ....................233
Digital audio broadcasting ..........151
Disconnecting an audio device ...156