bulb Peugeot 1007 Dag 2008.5 Owner's Manual
[x] Cancel search | Manufacturer: PEUGEOT, Model Year: 2008.5, Model line: 1007 Dag, Model: Peugeot 1007 Dag 2008.5Pages: 194, PDF Size: 11.23 MB
Page 17 of 194
1
20
WARNING LIGHTS
A p e r m a n e n t l y l i t w a r n i n g l i g h t o r o n e fl a s h i n g , w i t h t h e e n g i n e r u n n i n g , i n d i c a t e s a n o p e r a t i n g f a u l t o f t h e u n i t
c o n c e r n e d . T h e i l l u m i n a t i o n o f c e r t a i n w a r n i n g l i g h t s m a y b e a c c o m p a n i e d b y a n a u d i b l e s i g n a l a n d a m e s s a g e o n
t h e m u l t i f u n c t i o n d i s p l a y . D o n o t i g n o r e t h i s w a r n i n g : c o n s u l t a
PEUGEOT dealer.
I f t h e c e n t r a l S T O P w a r n i n g l i g h t c o m e s o n w h e n y o u a r e d r i v i n g , s t o p y o u r v e h i c l e i m m e d i a t e l y , w h e r e i t i s s a f e t o
d o s o .
Central STOP
warning light
This comes on for a few
seconds each time the
ignition is switched on.
Linked to the warning lights:
- ''engine oil pressure and tempera- ture'',
- "punctured wheel",
- "maximum coolant temperature",
- " h a n d b r a k e ' ' , ' ' l o w b r a k e fl u i d level'', and ''electronic brake
force distribution''.
Y o u m u s t s t o p i f t h e l i g h t c o m e s
o n w i t h t h e e n g i n e r u n n i n g .
Consult a PEUGEOT dealer. E n g i n e o i l p r e s s u r e a n d
t e m p e r a t u r e w a r n i n g
light
This comes on for a few seconds each
time the ignition is switched on.
Linked to the central STOP warning
light.
If this warning light comes on, with
the engine running, it indicates one
of the following:
- i n s u f fi c i e n t o i l p r e s s u r e ,
- a lack of oil in the lubrication circuit. Top up the level,
- an oil temperature which is too high. The warning light is accom-
panied by an audible signal. To
lower the oil temperature, reduce
your speed.
Y o u m u s t s t o p .
Consult a PEUGEOT dealer.
S e r v i c e w a r n i n g l i g h t
This comes on for a few se-
conds each time the ignition
is switched on.
If this warning light comes on, with the en-
gine running, accompanied by an audible
signal and a message on the multifunc-
tion display, it indicates the occurrence of
a problem in one of the systems which
d o e s n o t h a v e a s p e c i fi c w a r n i n g l i g h t .
Consult the message on the multi-
function display to identify the system
concerned.
Check:
- the remote control battery,
- the pressure of the tyres,
- the engine oil level,
- the screenwash level,
- the condition of the bulbs.
For all other cases, contact a PEUGEOT
dealer.
The lighting of this warning light may
also indicate the start of saturation of
t h e p a r t i c l e e m i s s i o n fi l t e r ( D i e s e l ) ,
due to exceptionally prolonged urban
driving conditions: low speed, long
t r a f fi c j a m s , . . .
I n o r d e r t o r e g e n e r a t e t h e fi l t e r , y o u
are advised to drive, as soon as traf-
fi c c o n d i t i o n s p e r m i t , a t a s p e e d o f
35 mph (60 km/h) or more for at least
fi v e m i n u t e s ( u n t i l t h e w a r n i n g l i g h t
switches off).
If the warning light remains on, contact
a PEUGEOT dealer.
Page 126 of 194
9
120
CHANGING A BULB 2 - Dipped beam headlamps/Main beam headlamps
(H4 - 60/55 W)
- Remove the plastic cover B .
- Disconnect the connector.
- Push the spring D towards the
right, as indicated on the head-
lamp.
- Remove and replace the bulb. 3 - Direction indicators
(PY 21 W amber)
- Turn the bulb holder C a quarter
of a turn and remove it.
- Turn the bulb a quarter of a turn.
- Remove the bulb and change it.
In certain weather conditions
(low temperatures, humidity),
the presence of condensa-
tion on the inside of the
headlamp glass is normal ; it disap-
pears a few minutes after the lights
have been switched on.
Front lights
1 - Side lights (W 5 W)
- Remove the plastic cover A .
- Remove the bulb holder.
- Remove the bulb and change it.
Page 127 of 194
9
121
Only use H4 bulbs manufac-
tured by:
- GE/TUNGSRAM.
- PHILIPS,
- OSRAM,
to avoid damaging the headlamps.
Direction indicator side repeaters
(WY 5 W amber)
- Push the repeater cover for-wards and release it.
- Remove the repeater and change it.
Contact a PEUGEOT dealer to obtain
a new bulb. 4 - Front fog lamps (H1 - 55 W)
- O p e n t h e fl a p , l o c a t e d u n d e r t h e
mud guard, to gain access to the
screw.
- Remove the screw.
- Push the assembly outwards to extract it.
- Disconnect the connector.
- Turn the protective cover A a
quarter of a turn.
- Disconnect the connector B .
- Move aside the springs C .
- Remove the bulb and change it.
Amber coloured bulbs (di-
rection indicators and side
repeaters) must be replaced
b y b u l b s o f i d e n t i c a l s p e c i fi -
cation and colour.
These meet the anti-UV (ultra-violet)
s p e c i fi c a t i o n s n e c e s s a r y f o r t h e c o r -
rect operation and reliability of the
headlamps.
T h e h e a d l a m p s a r e fi t t e d w i t h a p o l y -
carbonate lens coated with a protec-
tive varnish. You are strongly advised
to avoid cleaning them using a dry or
abrasive cloth and using detergent
products or solvents.
Use a soft, damp cloth with soapy
water.
T o r e fi t , p r o c e e d i n t h e r e v e r s e o r d e r
to removal.
It is
essential t h a t t h e fl a p i s c l o s e d .
Page 128 of 194
9
122
Rear lights
1. Brake/side lights
(P21 W/5 W).
2. Direction indicators (P21 W).
3. Reversing light (P21 W), right
side.
Fog lamp (P21 W), left side.
These 4 bulbs are changed by re-
moving the light:
R e m o v e t h e a c c e s s fl a p i n t h e
corresponding boot side trim to
access the light,
R e m o v e t h e t w o l i g h t fi x i n g n u t s
inside the boot,
Unclip the harness,
Remove the light pressing on the
retaining tabs,
Remove the seal,
Remove the bulb holder moving
aside the two tabs A ,
Turn the bulb a quarter of a turn,
Remove the bulb and change it.
Note: if necessary, use the wheel-
brace to remove the nuts.
W h e n r e fi t t i n g , p r o c e e d i n t h e r e -
verse order and take care to position
the bulb holder, the seal and the light
correctly. Third brake light
(4 W 5 W bulbs)
Using a 10 mm box spanner, un-
s c r e w t h e 2 fi x i n g n u t s A .
Release the lamp unit by push-
ing it outwards.
Disconnect the connector and
the rear wash-wipe pipe.
Turn the bulb holder a quarter of
a turn and remove it.
Remove the bulb and change it.
W h e n r e fi t t i n g , p r o c e e d i n t h e r e -
verse order and ensure that the lamp
unit seal and the rear wash-wipe pipe
have been put back in place correctly.
Do not tighten the nuts more than is
necessary at the risk of breaking the
light.
Number plate lights (W 5 W)
Insert a thin screwdriver into one
of the external holes of the lens.
Push it outwards to unclip it.
Remove the lens.
Remove the bulb and change it.
Page 138 of 194
9
131
ACCESSORIES FOR YOUR 1007
A wide range of accessories recom-
mended by PEUGEOT and original
parts are offered by the Network.
T h e y a l l b e n e fi t f r o m P E U G E O T ' s
recommendation.
These accessories and parts, having
been tested and approved for reli-
ability and safety, are all adapted to
your PEUGEOT vehicle. T h e fi t t i n g o f e l e c t r i c a l e q u i p -
ment or accessories which
are not recommended by
PEUGEOT may result in a
failure of your vehicle's electronic
system.
P l e a s e n o t e t h i s s p e c i fi c w a r n i n g .
You are advised to contact a repre-
sentative of the Marque to be shown
the range of recommended equip-
ment and accessories.
Depending on the country in which
the vehicle is sold, it is compulsory to
have a safety jacket, warning trian-
gle and spare bulbs available in the
vehicle.
"Protection": anti-theft
alarm , engraved windows,
wheel anti-theft devices,
system which assists with
t h e i d e n t i fi c a t i o n o f a s t o l e n
v e h i c l e , fi r s t a i d k i t , w a r n -
ing triangle, high visibility
safety jacket, fog lamps kit,
snow chains, non-skid cov-
ers, audible rear parking
assistance.
"Touring": central arm-
rest, storage under the rear
shelf, mats * , boot tray, sun
blinds.
For leisure pursuits: roof
bars, transportation ac-
cessories (bicycle carrier,
ski carrier), roof box, child
seats and booster cushions, audio/
telephone console, cool box.
"In-Car Technology": hands-
free kits, satellite navigation
systems, CD changer, DVD
player, multimedia, audio
equipment, speakers, auxil-
iary audio socket permitting
the connection of a portable
MP3 player (compatible with
WIP Sound), USB socket.
"Styling": seat covers, al-
loy wheels, wheel trims,
spoiler, styling strips, door
spoilers, sill protectors,
aluminium footrest, rear si-
lencer, exhaust tail pipe.
"Universal": windscreen
w a s h fl u i d , i n t e r i o r a n d e x -
terior cleaning and mainte-
nance products.
You can obtain "Van" conver-
sion kits for conversion from
a private vehicle to a van.
You can obtain other
"Cameleo" customising kits
from PEUGEOT dealers.
You will be offered either a
complete kit, like the original kit, or a
partial kit consisting of the vent trims
only.
Should you need to change one or
more elements of the Cameleo kit of
your vehicle, due to damage..., you
will be offered replacement elements
from the exchange kits available at
that time.
This product range offered by PEUGEOT
Accessories is structured around 5 catego-
ries: PROTECTION - TOURING - IN-CAR
TECHNOLOGY - STYLING - UNIVERSAL.
* To prevent jamming under the
pedals:
- ensure that the mat is positioned and secured correctly,
- n e v e r fi t o n e m a t o n t o p o f a n - other.
T r a i l e r t o w b a r w h i c h m u s t b e fi t t e d b y
the PEUGEOT network.