lock PEUGEOT 1007 DAG 2008 Owner's Guide

8
112

From outside: lift the catch A and
raise the bonnet. Bonnet strut
Secure the strut to hold the bonnet
open.
Before closing the bonnet, replace
the strut in its housing.
To close
Lower the bonnet and release it at
the end of its travel. Check that the
bonnet is properly locked.
OPENING THE BONNET

From inside: pull the handle on the
left-hand side under the fascia.
RUNNING OUT OF FUEL (DIESEL)
If your vehicle is fi tted with an HDI
engine, the fuel circuit must be rep-
rimed if you run out of fuel (refer to
the corresponding graphic).
This system consists of a repriming
pump and a transparent pipe.
1.4 litre Turbo HDI engine

 Open the bonnet.

 Fill the fuel tank with at least fi ve
litres of diesel.

 Squeeze and release the rep-
riming pump until fuel appears in
the transparent pipe.

 Operate the starter until the en-
gine starts.

 Close the bonnet.
1.6 litre Turbo HDI 16V engine

 Open the bonnet.

 Fill the fuel tank with at least
fi ve litres of diesel.

 Unclip the style cover to gain
access to the repriming pump.

 Squeeze and release the rep-
riming pump until fuel appears
in the transparent pipe with the
green connector.

 Operate the starter until the
engine starts.

 Put the style cover back in posi-
tion and clip it in place.

 Close the bonnet.
Opening the bonnet may
cause serious injuries,
please observe the following
recommendations:
- protect your hands and clothing,
- always allow the engine to cool before opening the bonnet,
- place the strut in its housing on the wing correctly,
- check that the bonnet is fi rmly secured in the open position,
- be aware of gusts of wind as they could cause the bonnet to
close suddenly.

9
124
Fuse N°RatingFunctions
115 ARear wiper.
35 AAir bags and pre-tensioners control unit.
410 ADiagnostic socket - Clutch switch - Steering wheel angle sensor - Particle emission fi lter pump.
530 AElectric windows - Sunroof.
6-Not used.
75 ACourtesy light - Glove box lighting.
820 ATyre under-infl ation detection control unit - Electric mirror folding - Alarm siren - Multifunction display - Alarm control unit - Audio equipment - Aud io/telephone.
930 AAudio equipment - Lighter/12 V socket (100 W max).
1015 ASteering wheel controls.
1115 ADiagnostic socket - Low current ignition switch - Motorised strikers.
1215 AAir bags and pre-tensioners control unit - Rain/brightness sensor.
135 AABS relay - Speed sensor - Engine Fuse Box - "2 Tronic" gear lever - Brake swit ch.
1415 AParking assistance control unit - "Sesame" doors control unit and switches - Instrument panel - Seat belt warning lights bar - Air conditioning control panel - Headlamp adjustment - Hands-free kit.
1530 ALocking - Deadlocking - Unlocking.
1740 ARear screen and exterior mirrors demisting.
SH-PARC shunt.

9
129
TOWING YOUR VEHICLE
From the rear:

 Unclip the side of the cover using
the fl at part of the towing eye,

 Screw in the towing eye until it
locks. When towing with the en-
gine switched off, there is no
braking assistance.
Special features of
the "2 Tronic" gearbox
When towing with four wheels on the
ground, the following rules must be
obeyed:
- gear lever in position
N ,
- tow the vehicle at less than 30 mph (50 km/h) over a maxi-
mum distance of 30 miles (50 km).
- do not add oil to the gearbox.
From the front:

 Unclip the bottom of the cover,
using the fl at part of the towing
eye.

 Screw in the towing eye until it
locks. Lifting
(2 wheels only on the road)
It is preferable to raise the vehicle by
the wheels.

Never use the radiator crossmember.
Without lifting
(4 wheels on the road)
You should always use a towbar.
The removable towing eye is stored
in the tool case, located in the left
boot trim.
Vehicles fitted with a manual
gearbox (diesel version)
In the case of vehicles fi tted with a
manual gearbox, the gear lever must
be in the neutral position.
Failure to observe this special condi-
tion may result in damage to certain
braking components and the absence
of braking assistance the next time
the engine is started.