light PEUGEOT 106 2001 Owner's Manual

YOUR 106 IN DETAIL66
5
78
10
9
1
6
1112
432
CENTRAL PANEL1- Radio cassette player.
2- Central adjustable vents for heating,
ventilation and air ßow.
3- Heating and ventilation controls.
4- Passenger airbag disarming switch.
5- Interior air recirculation or left-hand heated seat control*.
6- Ashtray. 7-
Demisting control for rear screen and mirrors*.
8- Hazard warning switch.
9- Lighter.
10 - Air conditioning* or right-hand heated seat control*
11 - Headlamps height adjustment.
12 - Lighting rheostat.
* According to speciÞcation
06-05-2002

Heated seats*
Press the switch to operate the seat heating. Pressing it again stops the opera- tion. * According to speciÞcation
Lighting rheostat Adjustment can only be done with the engine running and the side-lights on, by pressing button
12on
the instrument panel, to increase ordecrease the instrument panel ligh-ting level.
Adjusting the headlamps
Depending on the load in your vehicle, it is recommended that theheadlamp beam is adjusted. 0- 1 or 2 people in the front seats.
–- 3 people.
1- 5 people.
2- 5 people + maximum authori- sed load.
3- Driver + maximum authorised load.
This adjustment can only be carriedout when the lighting control is inthe dipped/main beam position. Initial setting is position 0.
Hazard warning lights
The switch and the direction indica- tors ßash. Controls the direction indicators
simultaneously and continuously.
Use only in cases of danger, for an emergency stop or for driving inunusual conditions. Can operate with the ignition swit-
ched off.
Rear screen demister
Control for demisting the rearscreen (and exterior mirrors)*. Goes out automatically after approximately twelve minutes inorder to avoid excessive currentconsumption. Pushing it again restarts the opera- tion for twelve minutes.
YOUR 106 IN DETAIL67
06-05-2002

YOUR 106 IN DETAIL70
Handbrake Application: When you have completed your parking manoeuvre, pull up thehandbrake to apply it.
To make application and release of
the handbrake easier, press the brake pedal and pull the handbrakewith the engine running. Release: Press the button before releasing the handbrake. Anti-lock brake system(ABS)* In conjunction with approved tyres in good condition, the anti-lockbrake system improves the stabilityand handling of your 106, particu-larly on poor or slippery surfaces. The anti-lock brake system ope- rates automatically if there is a riskof wheel locking. Lighting of the ABS warning lamp may be due to the turning of awheel during an operation on thevehicle (changing a wheel, forexample) with the ignition on (posi-tion
M).
Note: In certain conditions, normal
operation of the system can berecognised by a light vibration ofthe brake pedal. Should an emergency stop be
necessary, press the brake pedal
Þrmly and continuously. Power steering*
This is a driving aid which offers the best compromise when parking andwhen driving at high speeds. Manual gearbox The gear positions are indicated on the gear lever knob.
1- R
everse gear can only be
engaged with the vehicle stationary and the engineidling.
* According to speciÞcation.
1
06-05-2002

YOUR 106 IN DETAIL71
AIR BAGS* The airbag system has been desi- gned to maximise the safety of theoccupants in the event of seriouscollisions. It works in conjunctionwith the seat belts. The electronic detectors register and analyse any abrupt deceleration ofthe vehicle; if the triggering thresholdis reached the airbags inßate instant-ly and come between the occupantsand the vehicle. Immediately after the impact, the air-
bags deßate rapidly, so that they donot hinder the visibility of the occu-pants and their exit if necessary fromthe vehicle. The airbags are not deployed in the case of collisions which are notserious, for which the seat belt is suf-Þcient to ensure maximum protec-tion. The seriousness of a collisiondepends on the nature of the obs-tacle and the speed of the vehicle atthe moment of the collision. Airbags only operate when the ignition is switched on. Note: the gas escaping from the
cushion can be a minor irritant. FRONT AIR BAGS* These are folded in the centre of the steering wheel for the driver and in
the fascia for the front passenger.They are deployed simultaneously(except in cases where the airbag isdisarmed), for frontal impacts wherethere is a risk of injury to the head orchest.
-
Remove the ignition key, insert itinto the passenger airbag switch 1
and turn it to the “OFF”position.
- One of these two warning lights* on the instrumentpanel is lit throughout thedisarming process.
In the “OFF” position, the passenger
airbag will not be triggered in theevent of an impact. As soon as you remove the rearwards-facing child seat from thefront passenger seat, turn the airbagswitch to the ÒONÓ position, to armthe airbag and thus ensure thesafety of your passenger in animpact. * According to speciÞcation.
Disarming the passenger airbag*
To ensure the safety of your child,
it is essential to disarm the pas- senger airbag when you install arearwards-facing child seat on thefront passenger seat.
1
AIR
BAG
06-05-2002

YOUR 106 IN DETAIL72
Passenger airbag precautions Vehicle fitted with a passenger
airbag disarming switch:
- disarm the airbag if you install arearwards-facingchild seat on thefront passengerseat,
-arm the airbagwhen you trans-port an adult onthe front pas-senger seat.
V ehicle not fitted with a passenger
airbag disarming switch:
-do not install a rear-wards-facing child seaton the front passengerseat.
Never place your feet or any objecton the fascia.
Front* and side* airbag operational check Operation of the airbags is indicated by the warning light on the instrument panel. If the passenger airbag is armed (passenger airbag switch in the "ON"
position), the warning light will come on for six seconds when the ignition is switched on. If the warning light:- does not come on when the ignition is switched on or,
- does not switch off after six seconds or,
-ß ashes for Þve minutes then remains on.
Consult your PEUGEOT dealer.
SIDE AIR BAGS* The side airbags are incorporated in the backrest frames of the front seat, on the
side nearest the door. They are triggered independently of each other depending on the side on which the collision occurs, in the case of side impacts which could cause injury to the thorax,the abdomen and the head. * According to speciÞcation
06-05-2002

YOUR 106 IN DETAIL72
Passenger airbag precautions Vehicle fitted with a passenger
airbag disarming switch:
- disarm the airbag if you install arearwards-facingchild seat on thefront passengerseat,
-arm the airbagwhen you trans-port an adult onthe front pas-senger seat.
V ehicle not fitted with a passenger
airbag disarming switch:
-do not install a rear-wards-facing child seaton the front passengerseat.
Never place your feet or any objecton the fascia.
Front* and side* airbag operational check Operation of the airbags is indicated by the warning light on the instrument panel. If the passenger airbag is armed (passenger airbag switch in the "ON"
position), the warning light will come on for six seconds when the ignition is switched on. If the warning light:- does not come on when the ignition is switched on or,
- does not switch off after six seconds or,
-ß ashes for Þve minutes then remains on.
Consult your PEUGEOT dealer.
SIDE AIR BAGS* The side airbags are incorporated in the backrest frames of the front seat, on the
side nearest the door. They are triggered independently of each other depending on the side on which the collision occurs, in the case of side impacts which could cause injury to the thorax,the abdomen and the head. * According to speciÞcation
06-05-2002

PRACTICAL INFORMATION80
CHANGING A WHEEL Access to the spare wheel The spare wheel is outside, under the luggage compartment, in a
metal carrier. ÐTake out the wheel-brace 1.
Ð Using the wheel-brace 1, slacken
the spare wheel carrier bolt inside the luggage compartment,under the carpet.
ÐL
ift the carrier to disengage the
hook towards the rear, then lower it.
ÐT ake out the jack storage box 2
located in the spare wheel. Remove the wheel Ð
Use the wheel-brace to remove the wheel trim by pulling at thevalve location.
Ð Loosen the wheel bolts.
Ð
Use the jack storage box to chockthe wheel at the opposite corner tothe wheel being changed.
Ð Position the jack head in the jac-king point nearest to the wheelbeing changed, taking care thatthe entire base of the jack is incontact with the ground.
Ð Raise the jack, remove the wheelbolts and remove the wheel. Fit the spare wheel Ð
Position the wheel, then lightly pre-tighten the bolts using thewheel-brace.
Ð Lower the jack and release it.
ÐT ighten the bolts using the
wheel-brace.
Ð Fit the wheel trim, starting withthe valve location, and press withthe palm of the hand.
Replacing the wheel in the carrier Ð Lift the wheel to aid re-positio-
ning of the carrier.
Ð Do not forget to retighten thespare wheel carrier bolt.
80
3
2
1
06-05-2002

PRACTICAL INFORMATION83
CHANGING A BULB Side lights W5W Turn the plastic protector 1/8 turn
and remove it. Change the bulb. Dipped/main headlamps H4 55/60 W T
urn the plastic protector 1/8 turn
and remove it.
Disconnect the connector.Press the spring to unhook it then change the bulb.
When reÞtting the plastic protector, ensure that the locating notchesare correctly positioned and thatthe protector is properly secured. Only touch the bulb with a dry cloth.
There is a risk of damage to the dipped/mainheadlamps. Only usebulbs supplied by thefollowing manufacturers:
Ð TUNGSRAM
Ð PHILIPS
Ð OSRAM
Ð NORMA
These comply with the anti-UV
(Ultra-Violet) requirementsnecessary for correct operationand reliability of the headlamps. The headlamps are Þtted with polycarbon glass with a
protective coating. We stronglyadvise against cleaning themwith a dry or abrasive cloth orwith products containingdetergents or solvents.
06-05-2002

PRACTICAL INFORMATION
Direction indicator bulbs PY21W Access to the bulbs is from inside the wheel arch. Turn the wheels to full lock (to the
left to change the right hand bulb and vice versa). Open the access ßap.T urn the socket 1/4 turn.
Change the bulb. Ensure that the flap is closed
correctly. Side repeater W5W* Pull the rear part of the transparent
cover and detach the assembly. Support the connector and turn the transparent cover 1/4 turn. Change the bulb.
Rear lights Direction indicators
PY21W
Reversing lights P21W
Fog lamp P21W
T ail lights P5W
Brake/tail lights P21/5W
From inside the luggage com- partment: Remove the plastic protector 1.
Remove the air outlet grille 2using
a cross-head screwdriver. Slacken the two wing nuts 3and
release the light block 4.
Pinch the lugs 5to remove the
bulb-holder. Change the bulbs. * According to speciÞcation
84
4
3
1
2
5
06-05-2002

PRACTICAL INFORMATION
Additional brake light 5 W5W bulbs Access to the light is easier if the luggage compartment is open. Remove the plastic protector by pressing the side tabs. Pinch the lugs to release the bulb-
holder. Change the bulbs.Front fog lamps/long range lights H1/55W* Access to the bulbs is from under- neath the vehicle. T
urn the socket a 1/4 turn.
Change the bulb. * According to speciÞcation
85
06-05-2002