ECU PEUGEOT 2008 2013 User Guide

143
6
Safety










Locations for ISOFIX child seats

In accordance with European Regulations, this table indicates the options for installing ISOFIX child seats on seats in the vehicle fitted with ISOFIX mountings.
In the case of universal and semi-universal ISOFIX child seats, the ISOFIX size category, determined by a letter from A
to G
, is indicated on the childseat next to the ISOFIX logo.
Weight of the child
/ indicative age
Less than 10 kg
(group 0)Up to approx.6 months
Less than 10 kg(group 0)
Less than 13 kg(group 0+)Up to approx. 1 year
From 9 to 18 kg (group 1)From approx. 1 to 3 years
Type of ISOFIX child seatInfant car seat"rear facing""rear facing" "for ward facing"
ISOFIX size categoryFGCDECDABB1



Front passenger seatNot ISOFIX

Outer rear seats XIL-SU*IL-SUIL-SU*IL-SUIUF
IL-SU
Centre rear seat
Not ISOFIX
IUF:seat suitable for the installation of an Isofix U
niversal seat, "F
orward facing" secured using the upper strap. IL-SU:seat suitable for the installation of an I sofix S emi-U
niversal seat either:


- "rear facing" fitted with an upper strap or a stay,

- "forward facing" fitted with a stay,

- an infant car seat fitted with an upper strap or a stay.
For advice on securing of the upper strap, refer to the paragraph "ISOFIX mountings". X:seat not suitable for the installation of a child seat for the weight group indicated.

*
Vehicle seat in a par ticular position: move the passenger seat forward.

151
7
Practical information














Changing a wheel

The tools are installed in the boot under the floor.
To gain access to them: )open the boot, )lift the floor and remove it. )remove the polystyrene spacer,)remove the carrier box containing the tools.


Access to the tools
List of tools *
3."Bolt cover" tool.
For removing the bolt protectors
(covers)on alloy wheels.4.Socket for the security bolts (located in theglove box).
For adapting the wheelbrace to the special
"security" bolts.
5.Towing eye.
See "Towing the vehicle".

Procedure for chan
ging a faulty wheel for the spare wheel using the tools provided with the vehicle.
All o
f these tools are specific to your vehicle andcan vary according to the level of equipment. Donot use them for other purposes.
1.Wheelbrace.
For removing the wheel trim and removing
the wheel bolts.
2. Jack with integral handle.For raising the vehicle.

*
Depending on country of sale.

154
Practical information
Removing a wheel

Parking the vehicle

Immobilise the vehicle where it does notblock traffic: the ground must be level,stable and not slippery. Apply the parking brake, switch off the
ignition and engage first gear *
to blockthe wheels. Check that the parking brake warninglamps in the instrument panel come on.
The occupants must get out of the vehicle and wait where they are safe.
Never go underneath a vehicle raised using a jack; use an axle stand.


List of operations
)
Remove the bolt cover from each of
the bolts using the tool 3(according toequipment). ) Fit the security socket 4
on thewheelbrace 1
to slacken the security bolt (if fitted).)
Slacken the other bolts using the
wheelbrace 1 only.
*
position R
for an electronic
gearbox; P
for an automatic gearbox.

156
Practical information
Fitting a wheel
Fitting the "space-saver"spare wheel
If your vehicle is fitted with alloy wheels, when tightening the bolts on fitting, it is normal to notice that the washers
do not come into contact with the"space-saver" spare wheel. The wheel is secured by the conical surface of each bolt.
After changing a wheel
To store the punctured wheel in the boot correctly, first remove the central cover. When using the "space-saver" typespare wheel, do not exceed 50 mph(80 km/h). Have the tightening of the bolts and thepressure of the spare wheel checked by a PEUGEOT dealer or a qualified workshop without delay. Have the punctured wheel repairedand refitted to the vehicle as soon as possible.


List of operations
)Put the wheel in place on the hub. )Screw in the bolts fully by hand.)Pre-tighten the security bolt using the
wheelbrace 1fitted with the security socket 4 (if your vehicle has them). )Pre-tighten the other bolts using the
wheelbrace 1only.

157
7
Practical information
)Lower the vehicle fully.)Fold the jack 2 and detach it. )
Tighten the security bolt using the
wheelbrace 1 fitted with the securitysocket 4(if your vehicle has them). )
Tighten the other bolts using the
wheelbrace 1 only.
)
Refit the bolt covers on each of the bolts(according to equipment). )
Store the tools in the box.

172
Practical information




Battery
The presence of this label indicatesthe use of a 12 V lead-acid battery withspecial technology and specification, for which the involvement of a PEUGEOT dealer or qualified workshop is requiredwhen replacing or disconnecting thebattery.
Failure to observe this recommendation may cause premature wear of thebattery.

After refitting the battery, the Stop & Start system will only be active after
several hours depending on the climaticconditions and the state of charge of the battery (up to about 8 hours).
)Raise the locking tab fully.




Disconnecting the cables

Reconnecting the cables
)Position the open clip 1of the cable on the positive terminal (+) of the battery.
)Press ver tically on the clip 1
to position it correctly against the battery.)Lock the clip by spreading the positioning
lug and then lowering the tab 2.
Do not force the tab as locking will not be possible if the clip is not positionedcorrectly; start the procedure again.
Procedure for char
ging your battery when it is flat or for star ting the engine using another battery.

The battery is located under the bonnet.
To gain access to it:) open the bonnet using the interior releaselever, then the exterior safety catch, )
secure the bonnet stay, )
remove the plastic cover on the (+)
t
erminal.

Access to the battery

182
Practical information




Accessories
A wide range of accessories and genuine par ts is available from the PEUGEOT dealer network.
These accessories and par ts have been tested and approved for reliability and safety.
They are all adapted to your vehicle and benefit from PEUGEOT's recommendation and warranty.
Conversion kits
You can obtain an "Enterprise" kit to conver t a
private car into a trade vehicle.

"Comfort":
door deflectors, side blinds and rear blind,
cigarette lighter, boot dividers, coat hanger
fixed to head restraint, front and rear parkingsensors...

"Transport solutions":

boot liner, luggage net, roof bars, bicycle carrier
on roo
f bars, ski carrier, roof box, towbars....

* To avoid an
y risk of jamming of the pedals:
- ensure that the mat is positioned and
secured correctl
y,
- never fit one mat on top of another.


"Styling":
gear lever knob, spoiler, styling strips, alloy
wheels, trims, chromed mirror shells...


"Security":

anti-theft alarm, window engraving, wheel
security bolts, child seats and booster cushions, breathalyzer, first aid kit, warning
triangle, high visibility jacket, stolen vehicle
tracking system, temporary puncture repair kit,snow chains, non-slip covers, front foglamps
kit, dog guard...


"Protection":

mats * , seat covers compatible with lateral
airba
gs, mud flaps, door sill protectors,stainless steel boot sill protector, bumper protection strips, aluminium foot rest...
Tow bar, which mst be fitted byPEUGEOT dealer or a qualified workshop.

11-12
This handbook describes all of theequipment available in the whole range. This document is an integral part of your
vehicle. It should be passed on to the new
user in the event of sale or transfer. Reproduction or translation o
f all or part of
this handbook is prohibited without written
authorisation
from Automobiles PEUGEOT.
Printed in the E
U Y
our vehicle will be fitted with some of this
equipment described in this document,
depending on its trim level, version and thespecification for the country in which it issold.
Automobiles PEUGEOT declares, by
application of the provisions of the European
regulation (Directive 2000/53) relating
to End of Life Vehicles, that it achieves
the ob
jectives set by this regulation and
that recycled materials are used in the manufacture of the products that it sells. The descri
ptions and illustrations are given without any obligation. Automobiles
PEUGEOT reserves the right to modify the
technical specifications, equipment and accessories without having to update thecurrent handbook.

Anglais
For an
y work on your vehicle, use a qualified workshop that has the technical information,competence and equipment required, which
a PEUGEOT dealer is able to provide.