battery PEUGEOT 2008 2015 Owners Manual

.
2008_en_Chap00a_sommaire_ed01-2015
Direction indicators 128
Hazard warning lamps 1 28
H or n


129
Emergency or assistance call

1
29
Tyre under-inflation detection

1
30
ESC system

1
33
Grip control

1
36
Front seat belts

1
38
Airbags
1

41
Safety
Fuel tank 159
Misfuel prevention (Diesel) 1 61
Running out of fuel (Diesel)

1
63
AdBlue
® additive and SCR system 1 64
(BlueHDi Diesel) 1 64
Temporary puncture repair kit
1

72
Changing a wheel
1

77
Snow chains

1
84
Changing a bulb
1

85
Changing a fuse
1

92
Battery


198
Electrical energy economy mode
20

1
Changing a wiper blade
2

02
To w i n g


2 0 3
Towing a trailer

2
05
Fitting roof bars

2
07
Advice on care and maintenance
2

07
Accessories


208
Practical information
B o n n e t 2 11
Petrol engines 2 12
Diesel engines
2

13
Checking levels

2
14
C h e c ks
2

17
Checks
General information 219
Petrol engines 2 20
Petrol weights

2
22
Diesel engines
2

24
Diesel weights
2

26
Dimensions


229
Identification markings
2

30
Technical data
Emergency call 2 32
Assistance call 2 33
7-inch touch screen

2
35
Audio system / Bluetooth

2
97
Audio system

3
17
Audio equipment and telematics
Alphabetical index
Child seats 1 45
Deactivating the passenger's front airbag 1 47
ISOFIX child seats

1
54
Child lock

1
58
Child safety
Lighting controls 1 11
Headlamp adjustment 1 18
Cornering lighting
1

19
Wiper controls
1

20
Lighting dimmer

1
24
Courtesy lamps

1
25
Interior mood lighting
1

26
Panoramic glazed sunroof

1
27
Visibility
Contents

4
2008_en_Chap00b_vue-ensemble_ed01-2015
Exterior
Remote control key 42- 46
- locking/unlocking
the vehicle
-

l
ocating the vehicle
-
gu

ide-me-home lighting
-
a

nti-theft protection
-


alarm
-


battery
Starting - Switching off the engine

7
9 - 80 Boot
4

9
-
ope

ning / closing
-
em

ergency release
Temporary puncture repair kit
1

72-176
Wipers


120-123
Changing a wiper blade
1

23, 202
Changing bulbs
1

89-191
-
r

ear lamps
-
3
rd brake lamp
-
n
umber plate lamps
-


foglamp
-
r

eversing lamp
Fuel tank, misfuel prevention
1

59-163
Panoramic glazed sunroof

1

27
Roof bars

2

07
Accessories


208-209
Electronic stability programme (ESC)

1

33 -135
Snow chains

1

84
Tyre pressures

1

75, 230
Changing a wheel
1

77-183
-

tools
-

r

emoving / refitting
L i g h t i n g c o n t r o l s
111

-117
LED lamps


115
Daytime running lamps
1

15
Headlamp beam adjustment
1

18
Cornering lighting
1

19
Changing bulbs
1

85-188
-

f

ront lamps
-


foglamps
-
d

irection indicator repeaters
Door mirrors
5
9
D o o r s


47- 4 8
-
ope

ning / closing
-
em

ergency control
Locking/unlocking from the inside

5

0
Alarm


51-52
Electric windows

5

3 -54 Parking sensors
1

05-106
Park Assist
10
7-110
Towbar

205-206
Towing
20
3-204
Over view

10
2008_en_Chap00b_vue-ensemble_ed01-2015
Maintenance - Technical data
Identification markings 230
Dimensions 229
Changing bulbs
1

85-191
-

front
-

rear Running out of fuel, Diesel

1

63
Opening the bonnet

2

11
Under the bonnet, petrol

2

12
Under the bonnet, Diesel

2

13
Petrol engines

2

20 -221
Diesel engines
2

24-225 12V battery

1
98 -200
Load reduction, energy economy mode
20
1
Engine compartment fuses
19
2-193, 197
Petrol weights
2
22-223
Diesel weights
2
26-228
AdBlue
® additive and SCR system
(B lue H D i D i e s e l) 1 6 4 -171
Checking levels
21

4 -216
-

oil
-

b

rake fluid
-


coolant
-

s

creenwash fluid
-

additive (Diesel with particle emissions filter)
Checking components 2 17-218
- battery
-
a

ir / passenger compartment filter
-

o
il filter
-

p
article filter (Diesel)
-

b
rake pads / discs
Over view

26
Warning / indicator lampStateCause Action / Observations
Engine oil
pressure fixed.
There is a fault with the engine
lubrication system. You must stop as soon it is safe to do so.
Park, switch off the ignition and contact a PEUGEOT
dealer or a qualified workshop.
Battery charge fixed. The battery charging circuit has a
fault (dirty or loose terminals, slack or
cut alternator belt, ...). The warning lamp should go off when the engine is
started.
If it does not go off, contact a PEUGEOT dealer or a
qualified workshop.
Low fuel level
fixed with the needle
in the red zone. There remains approximately 5 litres
of fuel in the tank.
At this point, you begin to use the fuel
reserve. Refuel as soon as possible to avoid running out of
fuel.
This warning lamp will come on every time the ignition
is switched on, until a sufficient addition of fuel is
made.
Fuel tank capacity: approximately 50 litres
.
Never continue to drive until you run out of fuel, as
this could damage the emission control and injection
systems.
flashing with the
needle in the red
zone.
There remains very little fuel in the
tank.
Under-inflation fixed. The pressure in one or more wheels
is too low. Check the pressure of the tyres as soon as possible.
This check should preferably be carried out when the
tyres are cold.
+ flashing then fixed,
accompanied by the
Service warning lamp.The tyre pressure monitoring system
has a fault or no sensor is detected
on one of the wheels. Under-inflation detection is not assured.
Have the system checked by a PEUGEOT dealer or a
qualified workshop.
Monitoring

30
Retrieving the service
information
You can access the service information at any
time.
F
P
ress the trip distance recorder zero reset
button.
T

he service information is displayed for a
few seconds, then disappears.
If you have to disconnect the battery
following this operation, lock the vehicle
and wait at least five minutes for the
reset to be registered.
Resetting the service indicator
After each service, the service indicator must
be reset to zero.
If you have carried out the service on your
vehicle yourself:
F
s
witch off the ignition,
F

p
ress and hold the trip distance recorder
zero reset button,
F

s
witch on the ignition; the distance recorder
display begins a countdown,
F

w
hen the display indicates "=0" , release
the button; the spanner disappears.
Monitoring

45
2008_en_Chap02_ouvertures_ed01-2015
Changing the battery
Battery ref.: CR1620 / 3 volts.Do not throw the remote control
batteries away, they contain metals
which are harmful to the environment.
Take them to an approved collection
point.
Remote control problem
Reinitialisation
F Switch off the ignition.
F
T urn the key to position 2 (Ignition) .
F

P
ress the closed padlock immediately for a
few seconds.
F

S
witch off the ignition and remove the key
from the ignition switch.
The remote control is fully operational again. Following disconnection of the vehicle battery,
replacement of the remote control battery or
in the event of a remote control malfunction,
you can no longer unlock, lock or locate your
vehicle.
F
F
irst of all, use the key in the lock to unlock
or lock your vehicle.
F
T
hen, reinitialise the remote control.
If the problem persists, contact a PEUGEOT
dealer as soon as possible.
If the battery is flat, you are informed
by lighting of this warning lamp in the
instrument panel, an audible signal
and a message in the screen.
F
U
nclip the cover using a screwdriver in the
cutout.
F
R
emove the cover.
F
E
xtract the flat battery from its location.
F P lace the new battery into its location
observing the original direction.
F

C
lip the cover in place.
2
Access

48
2008_en_Chap02_ouvertures_ed01-2015
Back-up control
For mechanically locking and unlocking the
doors in the event of a fault with the central
locking system or a battery failure.Driver's door
Insert the key in the lock to lock or unlock
the door.
Passenger doors
Locking
F On the rear doors, check that the child lock is not on.
F

R
emove the black cap located on the edge
of the door, using the key.
F

I
nsert the key into the aperture without
forcing, then without turning, move the
latch sideways towards the inside of the
d o o r.
F

R
emove the key and refit the cap.
Unlocking
F Pull the interior door lever.
In the event of a fault with the central
locking, it is essential to disconnect the
battery to lock the boot and so assure
the complete locking of the vehicle.
Access

51
2008_en_Chap02_ouvertures_ed01-2015
System which protects and provides a deterrent
against theft and break-ins. It provides the
following types of monitoring:
Alarm
- Exterior perimeter
The system checks for opening of the vehicle.
The alarm is triggered if anyone tries to open
a door, the boot, the bonnet...
- Interior volumetric
The system checks for any variation in the
volume in the passenger compartment.
The alarm is triggered if anyone breaks
a


window, enters the passenger compartment
or moves inside the vehicle.
Self-protection function
The system checks for the putting out of
service of its components.
The alarm is triggered if the battery, the
central control or the wires of the siren
are put out of service or damaged.
For all work on the alarm system,
contact a PEUGEOT dealer or a
qualified workshop.
Locking the vehicle with full
alarm system
Activation
F Switch off the ignition and get out of the vehicle.
F Press the locking button on the remote control. After the locking button on the remote control
is pressed, the exterior perimeter monitoring
is activated after a delay of 5 seconds and the
interior volumetric monitoring after a delay of
45 seconds.
If an opening (door, boot...) is not closed
fully, the vehicle is not locked but the exterior
perimeter monitoring will be activated after a
delay of 45 seconds at the same time as the
interior volumetric monitoring.
F P ress the unlocking button on
the remote control.
Deactivation
The alarm system is deactivated: the
indicator lamp in the button goes off.
The monitoring system is active: the
indicator lamp in the button flashes
once per second.
2
Access

54
2008_en_Chap02_ouvertures_ed01-2015
Reinitialising the electric
windows
Following reconnection of the battery, the
safety anti-pinch function must be reinitialised.
The safety anti-pinch is not active during these
operations:
-
l
ower the window completely, then raise
it, it will rise in steps of a few centimetres
each time the switch is pressed. Repeat
the operation until the window closes
completely,
-

p
ress and hold the switch upwards for
at least one second after reaching this
position, window closed. Always remove the key when leaving the
vehicle, even for a short time.
In the event of contact during operation
of the windows, you must reverse the
movement of the window. To do this,
press the switch concerned.
When operating the passenger electric
window switches, the driver must ensure
that no one is preventing correct closing
of the windows.
The driver must ensure that the
passengers use the electric windows
c o r r e c t l y.
Be aware of children when operating
the


windows.
Access

85
2008_en_Chap05_conduite_ed01-2015
You must press the brake pedal firmly
while starting the engine.
Never select neutral N while the vehicle
is moving.
Only engage reverse gear R when the
vehicle is immobilised, with your foot on
the brake pedal.
In all cases, you must apply the parking
brake to immobilise the vehicle.
"Auto sequential" mode
In the automated mode, you can resume
control temporarily at any time using the
steering mounted control paddles.
The use of these paddles permits manual
selection of the gears in situations which
require a more rapid change-down than in
the automated mode (arrival at a roundabout,
leaving a car park with a steep gradient,
over taking...).
The gearbox engages the required gear if
the engine speed permits. AUTO remains
displayed on the instrument panel.
After a few moments, the gearbox resumes
automatic control of the gears.
Stopping the vehicle
Before switching off the engine, you can
change to position N to be in neutral.
In this case, you must apply the parking
brake to immobilise the vehicle.
AUTO and - appear in the instrument
panel.
Operating fault
With the ignition on, if this
warning lamp comes on and
AUTO flashes, accompanied by
an audible signal and a message in the screen,
this indicates a gearbox fault.
Have it checked by a PEUGEOT dealer or a
qualified workshop.
For best acceleration, when overtaking
another vehicle for example, press the
accelerator pedal firmly to pass the
point of resistance.
F

Sel

ect position N .
F

P

ress the brake pedal.
F

W

ait approximately 30 seconds until N or a
gear appears in the instrument panel.
F

R

elease the brake pedal.
The gearbox is operational again.
Reinitialisation
Following disconnection of the battery, the
gearbox must be reinitialised.
F

S
witch on the ignition.
5
Driving