change key battery Peugeot 206 SW Dag 2008 Owner's Manual

57
ACCESS
-
KEYS
The keys allow you to switch on the
ignition and independently operate
the passenger air bag disarming
switch and the steering lock. Locating your vehicle
To locate your vehicle, if you have
locked it, in a car park:
F
press button A, the courtesy
lights come on and the direction
indicators lash for a few
seconds.
Changing the remote control
battery
Battery ref.: CR2016 / 3 volts.
Warning that the battery is lat is
given by an audible signal accompa-
nied by the message "Remote con-
trol battery low" on the multifunction
display.
To replace the battery, remove the
screw then unclip the casing using a
coin at the ring.
If the remote control does not work
after the battery has been changed,
reprogramme the remote control.
Key in ignition
A buzzer sounds on opening the dri-
ver's door, if the key has been left in
the ignition. Programming the remote
control
F
Switch off the ignition.
F Switch the ignition on again.
F Press button A immediately for a
few seconds.
F Switch off the ignition and
remove the remote control
key from the ignition lock. The
remote control is now working
again.
Without central
locking / unlocking by
hand
The keys also allow you to unlock/
lock the front doors, the boot and the
fuel iller cap.
With central locking /
unlocking
The keys allow you to lock or unlock
all of the doors and the tailgate, from
the front doors.
If one of the doors or the tailgate is
open, the central locking does not
work. With central locking /
unlocking via the remote
control
Press button
A to lock the vehicle.
This is conirmed by ixed lighting of
the direction indicators for approxi -
mately two seconds.
Press button B to unlock the vehicle.
This is conirmed by the rapid lash -
ing of the direction indicators.
Avoid pressing the buttons of your
remote control out of range of your
vehicle. You risk causing it not to
work and the remote control would
then have to be reprogrammed (see
corresponding section).