warning light Peugeot 208 2012 Owner's Manual - RHD (UK, Australia)

.
.
Contents
Instrument panels 21
Indicator and warning lamps 23
Gauges and indicators 33
Tr i p c o m p u t e r 38
Trip computer with touch screen 40
Setting the date and time 43
Instruments and controlsFamiliarisation
Remote control key 44
Alarm 51
Electric windows 53
Boot 55
Panoramic sunroof 56
Access
Front seats 57
Rear seats 60
Rear seats 62
Mirrors 63
Steering wheel adjustment 65
Ventilation 66
Heating 68
Manual air conditioning 68
Dual-zone digital air conditioning 70
Rear screen demist - defrost 73
Interior fi ttings 74
Boot fi ttin
gs 78
Comfort
Starting-stopping the engine 81
Manual parking brake 82
Manual gearbox 83
Gear shift indicator 84
5-speed electronic gearbox 85
6-speed electronic gear control gearbox 88
Automatic gearbox 92
Stop & Star t 95
Hill star t assist 98
Speed limiter 99
Cruise control 101
Parking sensors 104
Driving
Lighting controls 106
LED lamps 110
Daytime running lamps 110
Automatic illumination of headlamps 112
Headlamp adjustment 113
Cornering lighting 114
Wi
per controls 115
Automatic rain sensitive wipers 117
Courtesy lamp 119
Interior mood lighting 120
Visibility Eco-driving

.
5
Familiarisation

Te m p o r a ry puncture repair kit

This kit is a complete system consisting of a compressor and a sealant car tridge, to allow
the temporary repair of a tyre.
14 3

Panoramic sunroof

Equipped with configurable light guides, this
large sunroof provides incomparable visibilityand lighting in the passenger compartment.
5
6
Rear parking sensors
This system provides a warning whenmanoeuvring backwards by detecting obstacles located behind the vehicle.
104
Exterior

8
Familiarisation
10. Side adjustable air vents.
11.Front side window demisting/defrosting
vent.
12 .Instrument panel.
13. Windscreen demisting/defrosting vent. 14 .
Sunshine sensor.
15. Glove box / Passenger's airbagdeactivation.
16.Passenger's airbag.
17. Multifunction screen / Audio system.
18. Central adjustable air vents.
Instruments and controls
1.
Cruise control / speed limiter controls. 2.
Steering mounted controls for the touch screen.
3.
Wiper / screenwash / trip computer stalk. 4.
Lighting and direction indicator stalk5.
Bonnet release lever.
6.Steering wheel adjustment control.
7. Driver's airbag.
Horn. 8.Headlamp height adjustment. 9. Switch panel.
19.
Central locking and hazard warning buttons. 20.
Heating / air conditioning controls.
21.12 V accessory socket.
USB por t / auxiliary socket.
Additional USB por t.22. Open storage.
Cup holder. 23. Gear lever. 24.
Central armrest with storage. 25.Parking brake.

1
23
Instruments and controls
Indicator and warning lamps
Visual indicators informing the driver that a system is in operation, switched off or has a fault.
Cer tain warning lamps may come on inone of two modes. Only by relating thetype of lighting to the operating statusof the vehicle can it be ascertainedwhether the situation is normal or whether a fault has occurred.

When the ignition is switched on
Certain warning lamps come on for a few seconds in the instrument panel and/or
instrument panel screen when the vehicle's
ignition is switched on.
When the engine is started, these same
warning lamps should go off.
If they remain on, before moving off, refer to the
information on the warning lamp concerned.
Associated warnings
The switching on of cer tain warning lamps
may be accompanied by an audible signal
and a message in the instrument panel or
multifunction screen.
The warning lamps may come on continuously (fixed) or flash.

24
Instruments and controls
Operation indicator lamps
If one of the following indicator lamps comes on in the instrument panel and/or instrument panel screen, this confirms that the corresponding system has come into operation.

Warning / indicator lampStateCauseAction / Observations



Left-hand direction indicator
flashing with buzzer. The lighting stalk is pushed down.



Right-hand direction indicator
flashing with buzzer. The lighting stalk is pushed up.
Sidelampsfixed.The lighting stalk is in the
"Sidelamps" position.
Dipped beamheadlampsfixed.The lighting stalk is in the "Dipped
beam headlamps" position.
Main beam headlampsfixed.The lighting stalk is pulled towards
you. Pull the stalk to return to dipped beam headlamps.
Front foglampsfixed.The front foglamps are switched on. Turn the ring on the stalk rear wards twice to switch off
the front foglamps.
Rear foglampfixed.The rear foglamp is switched on. Turn the ring on the stalk rear wards to switch off the
rear foglamp.

For more information on the lighting controls, refer to the "Visibility" section.

26
Instruments and controls
Warning / indicator lampStateCauseAction / Observations
Foot on theclutch *fixed.In the STOP mode of Stop & Star t,changing to START mode is refused
because the clutch pedal is not fully
down.You must declutch full
y to allow the change to engineSTA R T m o d e .
Stop & Startfixed. When the vehicle stops (red lights,
traffic jams, ...) the Stop & Start system has put the engine into STOPmode.The warnin
g lamp goes off and the engine restarts
automatically in START mode, as soon as you want tomove off.
flashes for a few seconds, then goesoff.
STOP mode is temporarily unavailable. or STA R T m o d e i s i n v o ke dautomatically. Re
fer to "Driving - § Stop & Start" for special cases
with STOP mode and STA R T m o d e .
Automatic wipingfixed. The wiper control is pushed downwards. Automatic front wiping is activated.
To deactivate automatic wiping, operate the controlstalk downwards or put the stalk into another position.
*
Except for the active matrix instrument panel.

1
33
Instruments and controls
Coolant temperature
gauge
With the engine running, when the needle is:


- in zone A
, the temperature is correct,

- in zone B, the temperature is too high;
the maximum temperature and the central STOP
warning lamps come on,accompanied by an audible signal and a
warning message in the screen.
You MUST stop as soon as it is safeto do so. Wait a few minutes before switching off theengine.
Contact a PEUGEOT dealer or a qualified
wor
kshop.
After drivin
g for a few minutes, the temperatureand pressure in the cooling system increase.
To top up the level:
) wait for the engine to cool, )
unscrew the cap slightly to allow the
pressure to drop,
) when the pressure has dropped, remove
the cap,) top up the level to the "MA X" mark.

Be aware of the risk of burns whentopping up the cooling system. Do not fill above the maximum level (indicatedon the reservoir).

47
2
Access
Electronic engine immobiliser
The key contains an electronic chip which has
a special code. When the ignition is switched on, this code must be recognised in order for star ting to be possible.
This electronic engine immobiliser locks theengine management system a few minutes
after the ignition is switched off and preventsstarting of the engine by anyone who does not
have the key.

Folding the key
)First press this button to fold the key.
)Press the closed padlock to
locate your locked vehicle in a car park.
Locating your vehicle
This is indicated by lighting of the cour tesy lamps and flashing of the direction indicators
for a few seconds.
Guide-me-home lighting
With the remote control
Make a long press this button to
operate the
guide-me-home lighting (switching on the sidelamps, dipped
beams and number plate lamps).
A second press be
fore the end of the timed period cancels the guide-me-home lighting.
Anti-theft protection
In the event of a fault, you are
informed by illumination of this
warning lamp, an audible signal and a message in the screen.
In this case, your vehicle will not start; contact
a PEUGEOT dealer as soon as possible.
If you do not press the button when folding the key, there is a risk of damageto the mechanism.

Keep safely the label attached to the keys given to you on acquisition of thevehicle.

49
2
Access
Secondary control
doors in the event of a fault with the central
locking system or a battery failure.


Driver's door

Inser t the key in the lock to lock or unlock
the door.

Passenger doors
)On the rear doors, check that the child lock
is not on.)Remove the black cap located on the edge
of the door, using the key. )Inser t the key into the aper ture without forcing, then without turning, move the
latch sideways towards the inside of thedoor.
)Remove the key and refit the cap.




Changing the battery

Battery ref.: CR1620 / 3 volts.
Do not throw the remote control batteries away, they contain metalswhich are harmful to the environment.
Take them to an approved collectionpoint.
Remote control problem
Reinitialisation
)
Switch off the ignition.)
Turn the key to position 2 (Ignition).)
Press the closed padlock immediately
for a few seconds.) Switch off the ignition and remove the key
from the ignition switch.
The remote control is fully operational again. Followin
g disconnection of the vehicle battery,replacement of the remote control battery or in the event of a remote control malfunction, you can no longer unlock, lock or locate your
vehicle.) First of all, use the key in the lock to unlock
or lock your vehicle.) Then, reinitialise the remote control.
I
f the problem persists, contact a PEUGEOT
dealer as soon as possible.
If the batter
y is flat, you are informed
by lighting of this warning lamp in the
instrument panel, an audible signal
and a message in the screen.) Unclip the cover using a screwdriver in thecutout.)
Remove the cover.)
Extract the flat battery from its location.
)
Place the new battery into its location
observing the original direction. ) Clip the cover in place.

80
Comfort











Warning triangle (stowing)

Before leaving your vehicle to set up
and install the triangle, put on your high visibility vest.
The dimensions o
f the triangle (once folded) or
its storage box must be:
- A: length = 438mm,
- B: height = 56
mm, -C: width = 38mm.To use the triangle, refer to the manufacturer'sinstructions.


Placing the triangle in the road
The location for stowing a folded triangle or its box is under the front seat.
Distance from your vehicle (in metres)
Road
Motorway
DayNight

50 m 80 m 150 m

These are the internationally recognisedvalues.
Use the triangle in line with local driving regulations.

The trian
gle is available as an accessory, contact a PEUGEOT dealer or a qualified
workshop.
) Place the triangle at a distance behindthe vehicle, as shown in the table below,
according to the type of road and the levelof ambient light.