warning light Peugeot 208 2013 Owner's Manual - RHD (UK, Australia)

.
.
Contents
Instrument panels 21Indicator and warning lamps 23Gauges and indicators 33Tr i p c o m p u t e r 38Tr ip computer with touch screen 40Setting the date and time 43
Instruments and controlsFamiliarisation
Remote control key 44Alarm 51Electric windows 53Boot 55Panoramic sunroof 56
Access
Front seats 57Rear seats 60Rear seats 62Steering wheel adjustment 63Ventilation 64Heating 66Manual air conditioning 66Dual-zone digital air conditioning 68Rear screen demist - defrost 71Interior fi ttings 72Boot fi ttings 76
Comfort
Starting-stopping the engine 79Manual parking brake 80Manual gearbox 81Gear shift indicator 825-speed electronic gearbox 836-speed electronic gear control gearbox 86Automatic gearbox 90Stop & Start 93Hill start assist 96Speed limiter 97Cruise control 99Park Assist 102Parking sensors 106
Driving
Mirrors 108Lighting controls 110LED lamps 114Daytime running lamps 114Automatic illumination of headlamps 116Headlamp adjustment 117Cornering lighting 118Wiper controls 119Automatic rain sensitive wipers 121Courtesy lamp 123Interior mood lighting 124
Visibility Eco-driving

.
5
Familiarisation

Te m p o r a ry puncture repair kit

This kit is a complete system consisting of a compressor and a sealant car tridge, to allow
the temporary repair of a tyre.
147

Panoramic sunroof

Equipped with configurable light guides, this sunroof provides incomparable visibility andlighting in the passenger compartment.
5
6
Rear parking sensors
This system provides a warning whenmanoeuvring backwards by detecting obstacles located behind the vehicle.
106
Exterior

8
Familiarisation
10. Side adjustable air vents.
11.Front side window demisting/defrosting
vent.
12 .Instrument panel.
13. Windscreen demisting/defrosting vent. 14 .
Sunshine sensor.
15. Glove box / Passenger's airbagdeactivation.
16.Passenger's airbag.
17. Multifunction screen / Audio system.
18. Central adjustable air vents.

Instruments and controls
1.
Cruise control / speed limiter controls. 2.
Steering mounted controls for the touch screen.
3.
Wiper / screenwash / trip computer stalk. 4.
Lighting and direction indicator stalk5.
Bonnet release lever.
6.Steering wheel adjustment control.
7. Driver's airbag.
Horn. 8.Headlamp height adjustment. 9. Switch panel.
19.
Central locking and hazard warning buttons. 20.
Heating / air conditioning controls.
21.12 V accessory socket.
USB por t / auxiliary socket.
Additional USB por t.22. Open storage.
Cup holder. 23. Gear lever. 24.
Central armrest with storage. 25.Parking brake.

1
23
Instruments and controls








Indicator and warning lamps
Cer tain warning lamps may come on inone of two modes. Only by relating thetype of lighting to the operating statusof the vehicle can it be ascertainedwhether the situation is normal or whether a fault has occurred.

When the ignition is switched on
Certain warning lamps come on for afew seconds in the instrument panel and/or
instrument panel screen when the vehicle's
ignition is switched on.
When the engine is started, these same
warning lamps should go off.
If they remain on, before moving off, refer to the
information on the warning lamp concerned.
Associated warnings
The switching on of cer tain warning lamps
may be accompanied by an audible signal
and a message in the instrument panel or
multifunction screen.
The warning lamps may come on continuously (fixed) or flash.
Visual indicators in
forming the driver that a system is switched on (indicator or deactivation lamp) or has a fault(warning lamp).

24
Instruments and controls
Operation indicator lamps
If one of the following indicator lamps comes on in the instrument panel and/or instrument panel screen, this confirms that the corresponding system has come into operation.

Warning / indicator lampStateCauseAction / Observations



Left-hand direction indicatorflashing with buzzer. The lighting stalk is pushed down.



Right-handdirection indicatorrflashing with buzzer. The lighting stalk is pushed up.
Sidelampsfixed.The lighting stalk is in the
"Sidelamps" position.
Dipped beamheadlampsfixed.The lighting stalk is in the "Dipped
beam headlamps" position.
Main beam headlampsfixed.The lighting stalk is pulled towards
you. Pull the stalk to return to dipped beam headlamps.
Front foglampsfixed.The front foglamps are switched on. Turn the ring on the stalk rear wards twice to switch off
the front foglamps.
Rear foglampfixed.The rear foglamp is switched on. Turn the ring on the stalk rear wards to switch off the
rear foglamp.

For more information on the lighting controls, refer to the corresponding section.

26
Instruments and controls
Warning / indicator lampStateCauseAction / Observations
Foot on the clutch * fixed.In the STOP mode of Stop & Star t,changing to START mode is refused
because the clutch pedal is not fully
down.You must declutch full
y to allow the change to engineSTA R T m o d e .
Stop & Startfixed. When the vehicle stops (red lights,
traffic jams, ...) the Stop & Start system has put the engine into STOPmode.The warnin
g lamp goes off and the engine restarts
automatically in START mode, as soon as you want tomove off.
flashes for afew seconds,
then goes off.
STOP mode is temporarily unavailable. or STA R T m o d e i s i n v o ke dautomatically. For more in
formation on special cases with STOP mode and START mode, refer to the "Stop & Start"section.
Automatic wipingfixed. The wiper control is pushed downwards. Automatic front wiping is activated.
To deactivate automatic wiping, operate the controlstalk downwards or put the stalk into another position.
* Except for the active matrix instrument panel.

1
33
Instruments and controls
Coolant temperature
gauge
With the engine running, when the needle is:


- in zone A
, the temperature is correct,

- in zone B, the temperature is too high;
the maximum temperature and the central STOP
warning lamps come on,accompanied by an audible signal and a
warning message in the screen.
You MUST stop as soon as it is safe to
do so. Wait a few minutes before switching off theengine.
Contact a PEUGEOT dealer or a qualified
wor
kshop.
After drivin
g for a few minutes, the temperatureand pressure in the cooling system increase.
To top up the level:
) wait for the engine to cool, )
unscrew the cap slightly to allow the
pressure to drop,
) when the pressure has dropped, remove
the cap,) top up the level to the "MA X" mark.

Be aware of the risk of burns whentopping up the cooling system. Do not fill above the maximum level (indicatedon the reservoir).

47
2
Access

Electronic engine immobiliser

The key contains an electronic chip which has
a special code. When the ignition is switched on, this code must be recognised in order for starting to be possible.
This electronic engine immobiliser locks theengine management system a few minutes
after the ignition is switched off and preventsstar ting of the engine by anyone who does not
have the key.
Folding the key
)First press this button to fold the key.
)Press the closed padlock tolocate your locked vehicle in a car park.
Locating your vehicle
This is indicated by lighting of the cour tesy
lamps and flashing of the direction indicators
for a few seconds.
Guide-me-home
lighting
Make a long press this button to
operate the
guide-me-home lighting (switching on the sidelamps, dipped
beams and number plate lamps).
A second press before the end of the timed
period cancels the guide-me-home lighting.
Anti-theft protection
In the event of a fault, you are
informed by illumination of this
warning lamp, an audible signal and a message
in th
e screen.
In this case, your vehicle will not start; contact
a PEUGEOT dealer as soon as possible.
If you do not press the button when folding the key, there is a risk of damageto the mechanism.


Keep safely the label attached to the keys given to you on acquisition of thevehicle.

49
2
Access
Secondary control
doors in the event of a fault with the central
locking system or a battery failure.


Driver's door

Inser t the key in the lock to lock or unlock the door.


Passenger doors
)On the rear doors, check that the child lock
is not on.)Remove the black cap located on the edge
of the door, using the key. )Inser t the key into the aper ture without forcing, then without turning, move the
latch sideways towards the inside of thedoor.
)Remove the key and refit the cap.




Changing the battery

Battery ref.: CR1620 / 3 volts.
Do not throw the remote control batteries away, they contain metalswhich are harmful to the environment.
Take them to an approved collectionpoint.
Remote control problem
Reinitialisation
)
Switch off the ignition.)
Turn the key to position 2 (Ignition).)
Press the closed padlock immediately for a
few seconds.) Switch off the ignition and remove the key
from the ignition switch.
The remote control is fully operational again. Followin
g disconnection of the vehicle battery,replacement of the remote control battery or in the event of a remote control malfunction, you can no longer unlock, lock or locate your
vehicle.) First of all, use the key in the lock to unlock
or lock your vehicle.) Then, reinitialise the remote control.
I
f the problem persists, contact a PEUGEOT
dealer as soon as possible.
If the batter
y is flat, you are informed
by lighting of this warning lamp in the
instrument panel, an audible signal
and a message in the screen.) Unclip the cover using a screwdriver in thecutout.)
Remove the cover.)
Extract the flat battery from its location.
)
Place the new battery into its location
observing the original direction. ) Clip the cover in place.

78
Comfort
Warning triangle (stowing)
Before getting out of your vehicle to
assemble the triangle and place it on the road, put on your high visibility vest.
The dimensions o
f the triangle (once folded) or
its storage box must be:
- A: length = 438mm,
- B: height = 56
mm, -C: width = 38mm.
The location for stowing a folded triangle or its box is under the front seat.

These are the internationally recognisedvalues. Use the triangle in line with local driving
regulations.
R
efer to the manufacturer's instructions for useof the triangle.

Placing the triangle in
the road
) Place the triangle at a distance behind
the vehicle, as shown in the table below,
accordin
g to the type of road and the levelof ambient light.
Distance from your vehicle (in metres)
Road
Motorway
DayNight

50 m 80 m 150 m
The trian
gle is available as an accessory, contact a PEUGEOT dealer or a qualified
workshop.