open bonnet Peugeot 208 2013 Owner's Manual
[x] Cancel search | Manufacturer: PEUGEOT, Model Year: 2013, Model line: 208, Model: Peugeot 208 2013Pages: 332, PDF Size: 8.4 MB
Page 8 of 332
6
Familiarisation
Access
A.
Unfolding / Folding the key.B. Unlocking the vehicle.
Deactivating the alarm.
Remote control key
Bonnet
191
1.Opening the fuel filler flap.
2. Removing the fuel filler cap.
3.
Hooking the fuel filler cap.
Ta n k c a p a c i ty: approximately 50 litres.
A.Interior release lever. B.Exterior safety catchC.Bonnet stay.
Other functions...C. Locking the vehicle. Locating the vehicle. Activating the alarm.
44
Fuel t ank
188
Locking and unlocking of the vehicle is signalled by rapid flashing of the direction indicators for abouttwo seconds.
Page 10 of 332
8
Familiarisation
10. Side adjustable air vents.
11.Front side window demisting/defrosting
vent.
12 .Instrument panel.
13. Windscreen demisting/defrosting vent. 14 .
Sunshine sensor.
15. Glove box / Passenger's airbagdeactivation.
16.Passenger's airbag.
17. Multifunction screen / Audio system.
18. Central adjustable air vents.
Instruments and controls
1.
Cruise control / speed limiter controls. 2.
Steering mounted controls for the touch screen.
3.
Lighting and direction indicator stalk4.
Wiper / screenwash / trip computer stalk. 5.
Bonnet release lever.
6.Steering wheel adjustment control.
7. Driver's airbag.
Horn. 8.Headlamp height adjustment. 9. Switch panel.
19.
Central locking and hazard warning buttons. 20.
Heating / air conditioning controls.
21.12 V accessory socket.
USB por t / auxiliary socket.
Additional USB por t.22. Open storage.
Cup holder. 23. Gear lever. 24.
Central armrest with storage. 25.Parking brake.
Page 53 of 332
51
2
Access
System which protects and provides a deterrent
against theft and break-ins. It provides the
following types of monitoring.
Alarm
- Exterior perimeter
The system checks for opening of the vehicle.
The alarm is triggered if anyone tries to open a
door, the boot, the bonnet...
- Interior volumetric
The system checks for any variation in the
volume in the passenger compartment.
The alarm is triggered if anyone breaks a
window, enters the passenger compar tment or
moves inside the vehicle.
Self-protection function
The system checks for the putting out of service of its components. The alarm is triggered if the battery, thecentral control or the wires of the siren are put out of ser vice or damaged.
For all work on the alarm system, contact a PEUGEOT dealer or aqualified workshop.
Locking the vehicle with full
alarm system
Activation
)Switch off the ignition and get out of the vehicle.
) Press the locking button on the
remote control.
After the locking button on the remote control
is pressed, the exterior perimeter monitoring
is activated after a delay of 5 seconds and the
interior volumetric monitoring after a delay of 45 seconds.
If an opening (door, boot...) is not closed fully, the vehicle is not locked but the exterior
perimeter monitoring will be activated after a
dela
y of 45 seconds at the same time as the
interior volumetric monitoring.
)
Press the unlocking button on
the remote control.
Deactivation
The alarm system is deactivated: the
indicator lamp in the button goes off.
The monitoring system is active: the
indicator lamp in the button
flashes once per second.
Page 176 of 332
174
Practical information
Battery
The presence of this label indicatesthe use of a 12 V lead-acid battery withspecial technology and specification, for which the involvement of a PEUGEOT dealer or qualified workshop is requiredwhen replacing or disconnecting thebattery.
Failure to observe this recommendation may cause premature wear of thebattery.
After refitting the battery, the Stop & Start system will only be active
after several hours depending on the climatic conditions and the state of charge of the battery (up to about 8 hours).
)Raise the locking tab fully.
Disconnecting the cables
Reconnecting the cables
)Position the open clip 1of the cable on the positive terminal (+) of the battery.
)Press ver tically on the clip 1
to position it correctly against the battery. )Lock the clip by spreading the positioning
lug and then lowering the tab 2.
Do not force the tab as locking will not be possible if the clip is not positionedcorrectly; start the procedure again.
Procedure for char
ging your battery when it is flat or for star ting the engine using another battery.
The battery is located under the bonnet.
To gain access to it: ) open the bonnet using the interior releaselever, then the exterior safety catch, )
secure the bonnet stay, )
remove the plastic cover on the (+)
t
erminal.
Access to the battery