instrument panel Peugeot 208 2014 Owner's Manual - RHD (UK, Australia)

.
.
Instrument panels 14
Indicator and warning lamps 1 6
Touch screen

2
8
ga

uges and indicators
3
2
Trip computer

3
8
Trip computer with touch screen

4
0
Setting the date and time

4
2
MonitoringOver view
Remote control key 4
3
Alarm 5 0
el

ectric windows
5
2
Boot
5

4
Panoramic sunroof
5

5
Access
Front seats 5 6
Rear seats 5 9
Rear seats
6

1
Steering wheel adjustment
62
M

irrors 63
Ventilation


65
Heating


68
Manual air conditioning
6

8
Dual-zone digital air conditioning
7

0
Front demist - defrost

7
3
Rear screen demist - defrost

7
3
Interior fittings

7
4
Boot fittings

7
8
Comfort
Starting - Stopping the engine 81
Manual parking brake 8 2
Manual gearbox
8

3
ge

ar shift indicator
8
4
5-speed electronic gearbox
8

5
6-speed electronic gearbox
8

9
Automatic gearbox
93
S

top & Start
9
7
Hill start assist

1
00
Speed limiter
1

01
Cruise control

1
03
Park Assist

1
07
Parking sensors
1

11
Driving
Lighting controls 113
LeD l amps 1 17
Daytime running lamps
1

17
Automatic illumination of headlamps

1
19
Headlamp adjustment
1

20
Cornering lighting
1

21
Wiper controls

1
22
Automatic rain sensitive wipers
1

24
Courtesy lamp

1
26
Interior mood lighting
1

27
Visibility
e

co-driving
Contents

7
Stop & Start 97-99
Alarm 50-51
Park Assist
10

7-110
P a r k i n g s e n s o r s
111

-112
Instrument panels
1

4-15
Warning lamps
1
6-27
Indicators
32
-37
Touch screen
2
8 -31
ge

ar shift indicator
8
4
Lighting controls
1

13-119
Direction indicators 1
28
Memorising speeds
1

05
Speed limiter
1

01-102
Cruise control
10

3 -104
Instruments and controls (cont.)
Trip computer with touch screen 4 0 - 41
Setting the date and time with the touch screen

4
2
Headlamp beam adjustment
1

20
W iper c ontrols
12

2-125
Trip computer

3
8 -39, 41
Hazard warning lamps
1

28
Locking/unlocking from inside
4

7Steering wheel adjustment
62
H

or n
12
9
.
Over view

12
eco-driving
eco-driving is a range of everyday practices that allow the motorist to optimise their fuel consumption and CO2 emissions.
Optimise the use of your gearbox
With a manual gearbox, move off gently and change up without waiting.
During acceleration change up early.
With an automatic or electronic gearbox, give preference to automatic
mode and avoid pressing the accelerator pedal heavily or suddenly.
The gear shift indicator invites you engage the most suitable gear: as
soon as the indication is displayed in the instrument panel, follow it
straight away.
For vehicles fitted with an electronic or automatic gearbox, this
indicator appears only in manual mode.
Drive smoothly
Maintain a safe distance between vehicles, use engine braking rather
than the brake pedal, and press the accelerator progressively. These
practices contribute towards a reduction in fuel consumption and CO
2
emissions and also helps reduce the background traffic noise.
If your vehicle has cruise control, make use of the system at speeds
above 25 mph (40 km/h) when the traffic is flowing well.
Control the use of your electrical
equipment
Before moving off, if the passenger compartment is too warm, ventilate it
by opening the windows and air vents before using the air conditioning.
Above 30 mph (50 km/h), close the windows and leave the air vents
open.
Remember to make use of equipment that can help keep the
temperature in the passenger compartment down (sunroof and window
blinds...).
Switch off the air conditioning, unless it has automatic regulation,
as soon as the desired temperature is attained.
Switch off the demisting and defrosting controls, if not automatic.
Switch off the heated seat as soon as possible.
Switch off the headlamps and front foglamps when the level of light
does not require their use.
Avoid running the engine before moving off, particularly in winter; your
vehicle will warm up much faster while driving.
As a passenger, if you avoid connecting your multimedia devices
(film, music, video game...), you will contribute towards limiting the
consumption of electrical energy, and so of fuel.
Disconnect your portable devices before leaving the vehicle.
eco-driving

14
LCD instrument panel
1. engine coolant temperature gauge.
2. Rev counter (x 1 000 rpm or tr/min),
graduation according to engine (petrol or
Diesel).
3.


e
n
gine oil level indicator*.
4.


g
e
ar shift indicator for a manual gearbox
or gear lever position and gear for an
electronic or automatic gearbox.
5.
D

igital speedometer (mph or km/h)
T

his can be switched off with a long press
on B . A.
gen eral lighting dimmer.
B. R ecalling the service information.
R

esetting the function selected (service
indicator or trip distance recorder).
S

etting the time.
S

witching the digital speedometer on and
of f.
6. C
ruise control or speed limiter settings.
7. S ervice indicator, then total distance
recorder (miles or km).
T

hese functions are displayed successively
on switching on the ignition.
8.
T

rip distance recorder (miles or km).
9.
A

nalogue speedometer (mph or km/h).
10.
F

uel gauge.
Dials and screens Control buttons
* Depending on version.
Monitoring

15
Active matrix instrument panel
Dials and screensControl buttons
1. engine coolant temperature gauge.
2. R
ev counter (x 1 000 rpm or tr/min),
graduation according to engine (petrol or
Diesel).
3.
C

ruise control or speed limiter settings.
4.


g
e
ar shift indicator for a manual gearbox
or gear lever position and gear for an
electronic or automatic gearbox.
5.
Spe

edometer (mph or km/h). A. M
ain lighting dimmer.
B. I nstrument panel mood lighting.
C.
R

ecall of the service information.
R

eset the selected function (service
indicator or trip distance recorder).
6. S
ervice indicator, then total distance
recorder (miles or km).
T

hese functions are displayed successively
on switching on the ignition.
7.
T

rip distance recorder (miles or km).
8.
A

nalogue speedometer (mph or km/h).
9.
F

uel gauge.
1
Monitoring

16
Indicator and warning lamps
Certain warning lamps may come on in
one of two modes. Only by relating the
type of lighting to the operating status
of the vehicle can it be ascertained
whether the situation is normal or
whether a fault has occurred.When the ignition is switched on
Certain warning lamps come on for a
few seconds in the instrument panel and/or
instrument panel screen when the vehicle's
ignition is switched on.
When the engine is started, these same
warning lamps should go off.
If they remain on, before moving off, refer to the
information on the warning lamp concerned.
Associated warnings
The switching on of certain warning lamps
may be accompanied by an audible signal
and a message in the instrument panel or
multifunction screen.
The warning lamps may come on continuously
(fixed) or flash.
Visual indicators informing the driver that a system is switched on (indicator or deactivation lamp) or has a fault (warning lamp).
Monitoring

17
Operation indicator lamps
If one of the following indicator lamps comes on in the instrument panel and/or instrument panel screen, this confirms that the corresponding system has come into operation.
Warning / indicator lampStateCause Action / Observations
Left-hand
direction indicatorflashing with buzzer.The lighting stalk is pushed down.
Right-hand
direction indicatorflashing with buzzer.The lighting stalk is pushed up.
Sidelamps fixed. The lighting stalk is in the
"Sidelamps" position.
Dipped beam
headlamps fixed.
The lighting stalk is in the "Dipped
beam headlamps" position.
Main beam
headlamps fixed.
The lighting stalk is pulled towards
you. Pull the stalk to return to dipped beam headlamps.
Front
foglamps fixed.
The front foglamps are switched on
using the ring on the lighting control
stalk. Turn the ring on the lighting control stalk rear wards
twice to switch off the front foglamps.
Rear
foglamp fixed.
The rear foglamp is switched on
using the ring on the lighting control
stalk. Turn the ring on the lighting control stalk rear wards to
switch off the rear foglamp.
For more information on the lighting controls, refer to the corresponding section.
1
Monitoring

19
Warning / indicator lampStateCause Action / Observations
Foot on the
clutch* fixed.
In the STOP mode of Stop & Start,
changing to START mode is refused
because the clutch pedal is not fully
down. You must declutch fully to allow the change to engine
S TA R T m o d e .
Stop & Star t fixed. When the vehicle stops (red lights,
traffic jams,
...) the Stop & Start
system has put the engine into STOP
mode. The warning lamp goes off and the engine restarts
automatically in START mode, as soon as you want to
move off.
flashes for a
few


seconds, then
goes off. STOP mode is temporarily
unavailable.
or
START mode is invoked
automatically. For more information on special cases with STOP
mode and START mode, refer to the "Stop & Start"
section.
Automatic
wiping fixed.
The wiper control is pushed
downwards. Automatic front wiping is activated.
To deactivate automatic wiping, operate the control
stalk downwards or put the stalk into another position.
*
e
x
cept for the active matrix instrument panel.
1
Monitoring

33
Lighting dimmer control
System for the manual adjustment of the
brightness of the instrument panel and the
touch screen to suit the ambient light level.
Tw o b u t t o n s
With the headlamps on, press button B to
increase the brightness of the instruments
and controls and the interior mood lighting or
button A to reduce it.
As soon as the lighting reaches the required
level of brightness, release the button.
One button
Activation
F p ress the button to adjust the brightness of
the instruments and controls,
F

r
elease the button when the desired level is
attained.
Touch screen
F Press M ENU to display the "MAIN MENU"
then select "Preferences" .
F

F
rom the secondary page, select "Screen
preferences" .
F

A
djust the brightness by moving the cursor.
You can also switch of the screen. To do this:
F
Press MENU to display the "MAIN MENU"
then select "Preferences" .
F
Press "Turn off screen" . The screen goes
off completely.
P

ress the screen again (anywhere on its
sur face) to activate it.
Switching off
When the vehicle lighting is off or in day mode
(daytime running lamps on), pressing the button
has no effect.
1
Monitoring

37
Engine oil level indicator*
Oil level incorrect
This is indicated by the flashing of "OIL" or
by the display of a dedicated message in the
instrument panel.
If the low oil level is confirmed by a check using
the dipstick, the level must be topped up to
avoid damage to the engine.
Oil level indicator fault
This is indicated by the flashing of " OIL_ _" or
by the display of a dedicated message in the
instrument panel. Contact a P
e

uge
O
T dealer
or a qualified workshop.
Dipstick
Refer to the "Checks" section to locate the
dipstick and the oil filler cap on your engine.
There are 2 marks on the dipstick:
System which informs the driver whether the
engine oil level is correct or not.
This information is indicated for a few seconds
when the ignition is switched on, after the
service information.
The level read will only be correct if
the vehicle is on level ground and the
engine has been off for more than
30


minutes.
-
A
= max; never exceed this
level,
-

B
= min; top up the level via
the oil filler cap, using the
grade of oil suited to your
engine.
Oil level correct
* Depending on version.
1
Monitoring