audio Peugeot 208 2014 Service Manual

04
285

Audio CD
Insert 12 cm diameter circular compact discs only.
Some anti-pirating systems, on original discs or CDs copied using a personal recorder, may cause faults which are no refl ection on the quality of the original player.
Without pressing the EJECT button, insert a CD in the player, play begins automatically.
To play a disc which has already been inserted, press the SRC/TEL button several times until CD play is displayed.
Press one of the buttons to select a track on the CD.
Press and hold one of the buttons for fast forward or backward.
Playing a CD
AUDIO

04
286
CD, USB
Information and advice
On a single disc, the CD player can read up to 255 MP3 fi les spread over 8 folder levels with a maximum of 192 folders. However, it is recommended that this be kept to 2 levels so as to limit the time taken \
to access and play the CD.
During play, the folder structure is not observed.
In order to be able to play a recorded CDR or CDRW, when recording it is preferable to select standards ISO 9660 level 1.2 or Joliet.
If the disc is recorded in another format, it may not be played correctl\
y.
It is recommended that the same recording standard is always used for an individual disc, with as low a speed as possible (4x maximum) for optimum sound quality.
In the particular case of a multi-session CD, the Joliet standard is recommended.
Do not connect a hard disk or USB device other than audio players to the USB port. This may cause damage to your installation.
The audio system will only play fi les with ".mp3", ".wma" and ".wav" on a CD and can play fi les with ".ogg" extension only on USB.
A high compression rate can adversely affect sound quality.
The playlists accepted on CD, MP3, iPod and USB connection are types ".m3u" and ".wpl".
The number of fi les recognised is limited to 5 000 in 500 folders on a maximum of 8 levels.
AUDIO

04
287
CD, USB
Playing a compilation
Insert an MP3 compilation in the CD player or connect a memory stick to the USB port.
The system creates playlists (temporary memory) the creation time for which can take from a few seconds to several minutes.
The playlists are updated every time the ignition is switched off or a USB memory stick is connected.
Play starts automatically after a period which depends on the capacity of the USB memory stick.
At a fi rst connection, the order suggested is by folder. When connecting again, the order previously chosen is retained.
To play a disc or memory stick which has already been inserted, press SRC/TEL several times in succession and select " CD " or " USB ".
Press one of the buttons to select the next or previous track.
Press one of the buttons to select the next or previous folder in the order chosen.
Press and hold one of the buttons for fast forwards or backwards.
AUDIO

04
288
Select a line in the list.
Jump a page.
Press MENU , select "Media" then select or deselect "TA" to activate or deactivate reception of traffi c messages.
Up a level in the menu.
AUDIO
Return to the top level of the folder structure to select the type of tracks.
- By Folders (CD or USB): all folders containing audio fi les recognised on the peripheral device, in alphabetical order without following the folder structure.
- By Artist (USB only): all of the artist names defi ned in the ID3 Tags, in alphabetical order.
- By Genre (USB only): all of the genres defi ned in the ID3 Tags.
- By Playlist (CD or USB): if playlists have been saved.
Press LIST to display the structure of the folders in the compilation.
Select the play mode: "Normal" , "Random" , "Random all" or "Repeat" .

04
289
AUDIO
Management of the device is via the audio system controls; refer to the "CD, USB" section.
The audio fi les on a Mass Storage portable player * can be heard through the vehicle's speakers by connecting it to the USB port (cable not supplied).
The Apple ® player must be updated regularly for the best connection. ® player must be updated regularly for the best connection. ®
The playlists are those defi ned in the Apple ® player. ® player. ®
The Apple ® player must be generation 3 or later. ® player must be generation 3 or later. ®
* Check your player's manual.
APPLE ® player or portable player

04
290

Streaming - Playing audio files via Bluetooth
Depending on the compatibility of the phone
Connect the telephone: see the "USING THE TELEPHONE" section.
Streaming allows music fi les on a telephone to be heard via the vehicle's speakers.
The telephone must support the appropriate Bluetooth ® profi les ® profi les ®
(profi les A2DP / AVRCP).
Activate the streaming source by pressing SRC/TEL . Control of playback is via the audio system. The contextual information can be displayed in the screen.
In certain cases, playing of the audio fi les must be initiated from the telephone.
The audio quality depends on the quality of the transmission from the telephone.
AUDIO

05
291
USING THE TELEPHONE
Pairing a Bluetooth telephone / First connection
The services offered depend on the network, the SIM card and the compatibility of the B\
luetooth telephone used.
Consult your telephone's manual and your operator to fi nd out which services are available to you.
Activate the telephone's Bluetooth function and ensure that it is set as visible to all (refer to the telephone instructions).
Press MENU then select "Bluetooth" .
A window is displayed with " Searching device ".
Select the telephone to be paired from the list and confi rm with "OK" . Only one telephone can be paired at a time.
Select " Search ".
For safety reasons and because they require prolonged attention on the p\
art of the driver, the operations for pairing of the Bluetooth mobile telephone with the Bluetooth hands-free system of your audio system must\
be carried out with the vehicle stationary and the ignition on.
It is not possible to pair more that 5 telephones. Press MENU and select "Bluetooth" . Select "BT management" . If 5 telephones are already paired, select the telephone to be deleted by pressing "OK"and select "Delete" (refer to "Managing connections").
Visit www.peugeot.co.uk for more information (compatibility, more help, ...).

05
293
USING THE TELEPHONE
Press MENU then select "Bluetooth" .
Select "BT management" and confi rm. The list of paired telephones is displayed.
Indicates connection of the audio profi le.
Managing connections
Select a telephone and confi rm "OK" .
Indicates connection of the hands-free profi le.
Then select or deselect:
- "Tel." : hands-free connection
- "Audio" : play audio fi les
"OK" to confi rm the choice.
Select "Delete" to delete the pairing.

06
297
Press  to display the audio settings menu.
Press  to go to the next setting.
The settings available are:
- AMBIANCE: BASS, TREBLE and LOUDNESS.
- BALANCE (left/right balance), FADER (front/rear balance)
- SOUND DIST. (driver or passenger).
- AUTO VOLUME.
The distribution, or spatialisation of sound, is an audio process which allows the sound quality to be improved according to the setting chosen, corresponding to the position of the listeners in the vehicle.
The AMBIANCE, TREBLE and BASS audio settings are different and independent for each sound source.
AUDIO SETTINGS

300
FREQUENTLY ASKED QUESTIONS
QUESTIONANSWERSOLUTION
There is a difference in sound quality between the different audio sources (radio, CD...).
For optimum sound quality, the audio settings (volume, bass, treble, ambience, loudness) can be adapted to the different sound sources, which may result in audible differences when changing source (radio, CD...).
Check that the audio settings (volume, bass, treble, ambience, loudness) are adapted to the sources listened to. It is advisable to adjust audio settings (bass, treble, Front-Rear balance, Left-Right balance) to the middle position, select the musical ambience and set the loudness correction to the "Active" position in CD mode or to the "Inactive" position in radio mode.
When changing the settings for treble and bass, the ambience setting is deselected.
When changing the ambience setting, treble and bass are reset to zero.
Choosing an ambience imposes settings for treble and bass. Modifying one without the other is only possible with a personalised ambience. Modify the treble and bass settings or the ambience setting to obtain the desired sound quality.
When changing the balance setting, distribution is deselected.
Choosing the "driver" distribution setting imposes a balance setting. Modify the balance setting or the distribution setting to obtain the desired sound quality.
The following tables contain answers to the most frequently asked questi\
ons.