tailgate Peugeot 208 2014 Owner's Manual

55
2
Access
Boot
 After unlocking the boot or the vehicle using the remote control or the key, press the opening control, then raise the tailgate.
Tailgate release
System for mechanical unlocking of the boot in the event of a central locking malfunction.
Opening Closing
 Lower the tailgate using the interior grab handle.  If necessary, press down on the tailgate to fully close it. If the tailgate is not closed correctly:
- when the engine is running , this warning lamp comes on, accompanied by the display of an alert message for a few seconds,
- when the vehicle is moving (speed above 6 mph (10 km/h)), this warning lamp comes on, accompanied by an audible signal and the display of an alert message for a few seconds. Unlocking
 Fold back the rear seats to gain access to the lock from inside the boot.  Insert a small screwdriver into hole A of the lock to unlock the tailgate.

169
7
Practical information
Changing the third brake lamp bulbs
 Unscrew the fixing pins on each side of the lamp, without removing them completely.  Push on the screws to unclip the lamp.  Disconnect the lamp connector.  Remove the lamp from the outside.  Turn the bulb holder which corresponds to the faulty bulb one quarter of a turn and remove it.  Pull the bulb and change it.
To refit, carry out these operations in reverse o r d e r.
Number plate lamps
To facilitate the removal of the lamp, carry out this operation with the tailgate half open.
 Insert a thin screwdriver into the lens cutout.  Push it outwards.  Remove the lens.  Change the faulty bulb. To refit, press on the lens to clip it in place.
Access is by passing a hand under the bumper.  Turn the bulb holder a quarter of a turn and
pull it out.  Disconnect the connector on the bulb h o l d e r.  Pull the bulb out and change it. To refit, carry out these operations in reverse o r d e r. You can also contact a PEUGEOT dealer or a qualified workshop for the replacement of these bulbs.
Changing a foglamp bulb