tyre pressure PEUGEOT 3008 2020 User Guide

195
In the event of a breakdown
8Only the 12 V sockets located at the
front of the vehicle and in the boot can
be used to power the compressor.
The 12
V socket located at the back of the
centre console is not suitable for this purpose.
► Affix the speed limit sticker .
The speed limit sticker must be affixed
inside the vehicle in the area close to the
driver, to remind them that a wheel is in
temporary use.
The tyre inflation pressures are given on this label.


► Switch the ignition on.

► Switch on the compressor by moving the
switch to position " I
" until the tyre pressure
reaches 2 bar. The sealant product is injected
under pressure into the tyre; do not disconnect
the pipe from the valve during this operation (risk
of blowback).
If after approximately 7 minutes, the
pressure of 2 bar is not reached, this
indicates that the tyre is not repairable;
contact a PEUGEOT dealer or a qualified
workshop for assistance.
►

Move the switch to position " O

".
►

Disconnect the compressor's electric plug
from the vehicle's 12

V socket.
►

Remove the kit.
►


Refit the cap on the valve.
►


Remove and store the bottle of sealant.
The sealant product is harmful if swallowed and causes irritation to the
eyes.
Keep this product out of the reach of children.
The use-by date of the fluid is marked on the
bottle.
After use, do not discard the bottle in
standard waste, take it to a PEUGEOT dealer
or an authorised waste disposal site.
Do not forget to obtain a new bottle of
sealant, available from a PEUGEOT dealer or
a qualified workshop.


► Drive immediately for approximately 3 miles
(5 kilometres) at reduced speed (between
12 and 37 mph (20 and 60
km/h)) to plug the
puncture.
►

Stop to check the repair
and the tyre
pressure using the kit.
With a tyre repaired using this type of kit,
do not exceed a speed of 50
mph
(80

km/h) and do not drive more than
125

miles (200 km).
Contact a PEUGEOT dealer or a qualified
workshop to have the tyre changed.
Checking/adjusting tyre
pressures
The compressor can be used, without injecting
sealant, to check and, if necessary, adjust the
tyre pressures.
►

Remove the valve cap from the tyre and keep
it in a clean place.
►


Uncoil
the pipe stowed under the compressor.
►

Screw the pipe onto the valve and tighten
firmly

.

196
In the event of a breakdown
► Check that the compressor switch is in
position " O
".
►

Fully uncoil the electric cable stowed under
the compressor

.
►

Connect the compressor's electric plug to the
vehicle's 12

V socket.
►

Switch the ignition on.
Only the 12 V sockets located at the
front of the vehicle and in the boot can
be used to power the compressor.
The 12V socket located at the back of the
centre console is not suitable for this purpose.
The tyre inflation pressures are given on this label.


► Start the compressor by placing the switch at
position " I
" and adjust the pressure to the value
shown on the vehicle's tyre pressure label. To
deflate: press the black button located on the
compressor pipe, near the valve connection.
If after 7 minutes the pressure of 2 bar is
not reached, the tyre is damaged;
contact a PEUGEOT dealer or a qualified
workshop for assistance.
►

Once the correct pressure is reached, put the
switch in position " O

".
►

Remove the kit and stow it.
► Refit the cap on the valve.
Should the pressure of one or more tyres
be adjusted, it is necessary to reinitialise
the under-inflation detection system.
For more information on Tyre under-inflation
detection, refer to the corresponding section.
Spare wheel
Scan the QR Code on page 3 to view
explanatory videos.
Accessing the spare wheel



The spare wheel is stored in the boot, under the
floor.
To access the spare wheel, first refer to the Tool
kit section.
Depending on version, the spare wheel
may be a standard size steel or alloy
wheel.
In some countries, it is a ‘space saver’ wheel.
Removing the wheel

► Slacken the central nut.
► Remove the fixing parts (nut and bolt).
►

Raise the spare wheel towards you from the
rear

.
►

T
ake the wheel out of the boot.
Putting the wheel back in place

► Put the wheel back in its housing.
► Slacken the nut on the bolt by a few turns.
► Position the fixing parts (nut and bolt) in the
middle of the wheel.


► Tighten fully until the central nut clicks, to
retain the wheel correctly.
► Return the tool box to the middle of the wheel
and clip it in place.

201
In the event of a breakdown
8

► Lower the vehicle again fully.
► Fold jack 6 and remove it.


► Tighten the security bolt using the
wheelbrace 5 equipped with a security socket 2 .
►

T
ighten the other bolts using the
wheelbrace

5
only.
►

Refit the bolt covers to each of the bolts
(depending on equipment).
►


Store the tools.
After changing a wheel
Store the punctured wheel in the boot or,
depending on version, remove the central cover
first to store it beneath the floor in place of the
spare wheel.


With a "space-saver" type spare wheel
Deactivate certain driving aid functions
(Active Safety Brake, Adaptive cruise control,
etc.).
Do not exceed the maximum authorised
speed of 50 mph (80
km/h).
Driving with more than one “space-saver”
type spare wheel is prohibited.
Visit a PEUGEOT dealer or a qualified
workshop as soon as possible to have
the tightness of the bolts and the pressure of
the spare wheel checked.
Have the punctured tyre examined. After
inspection, the technician will advise you on
whether the tyre can be repaired or if it must
be replaced.
Changing a bulb
In some weather conditions (e.g. low
temperature or humidity), misting on the
internal surface of the glass of the headlamps
and rear lamps is normal, and will disappear
after the lamps have been on for a few
minutes.
The headlamps have polycarbonate lenses with a protective coating:
–

Do not clean them with a dry or abrasive
cloth, nor with detergent or solvent
products.
–


Use a sponge and soapy water or a pH
neutral product.
–


When using a high-pressure washer on
persistent marks, do not keep the lance
directed towards the headlamps, lamps or
their edges for too long, so as not to damage
their protective coating and seals.
Changing a bulb must only be done with
the ignition off and after the headlamp /
lamp has been switched off for several
minutes - risk of serious burns!
Do not touch the bulb directly with your
fingers; use a lint-free cloth.
It is essential only to use anti-ultraviolet
(UV) type bulbs, so as not to damage the
headlamp.

227
Technical data
9

Identification markings
Various visible markings for the identification and
research of your vehicle.


A. Vehicle Identification Number (VIN), under
the bonnet.
Stamped on the chassis.
B. Vehicle Identification Number (VIN), on the
dashboard.
Engraved on a label, visible through the
windscreen.
C. Manufacturer's label.
Affixed to the right-hand door.
Bears the following information:
–
Manufacturer
’s name.
–

European whole vehicle type approval
number

.
– Vehicle Identification number (VIN).
– Gross vehicle weight (GVW).
–

Gross train weight (GTW).
–


Maximum weight on the front axle.
–


Maximum weight on the rear axle.
D. T

yres/paint code label.
Affixed to the driver's door.
Bears the following information about the tyres:
–

T
yre pressures, unladen and laden.
–

T
yre specification, made up of the dimensions
and type as well as the load and speed indices.
–

Spare tyre pressure.
Also indicates the paint colour code.
The vehicle may be originally equipped with tyres with higher load and speed
indices than those indicated on the label,
without affecting tyre pressure (on cold tyres).

280
Alphabetical index
CD, MP3 233, 246
Central locking
31–32
Changing a bulb

201–202, 204–205
Changing a fuse

205–206, 208–209
Changing a wheel

191–192, 196–198
Changing a wiper blade

84–85
Changing the remote control battery

33
Charge level indicator

20
Charger, induction

67
Charger, wireless

67
Charging cable

169–170, 172
Charging connector

168, 171–172
CHECK

20
Checking the engine oil level

17
Checking the levels

181–182
Checking tyre pressures (using the kit)

193, 195
Checks

180, 183–184
Checks, routine

183–184
Child lock

11 2
Children

97, 103, 105, 107, 110–111
Children (safety)

11 2
Child seats

97, 100–103, 107, 110–111
Child seats, conventional

102–103
Child seats, i-Size

11 0
Child seats, ISOFIX

105, 107, 110
Cleaning (advice)

168, 187–189
Closing the boot

31, 37
Closing the doors

31, 36
Collision Risk Alert

146–147
Configurations, seats

57
Configuration, vehicle

23–25, 27
Connected applications

266–267Connection, Bluetooth 235, 248–249,
267, 271–272
Connection, MirrorLink

247–248, 266
Connection, Wi-Fi network

267–268
Connectivity

265
Consumption figures

26
Container, AdBlue®

185–186
Control, emergency boot release

37
Control, emergency door

32–33
Control, heated seats

48
Controls, steering mounted

121–124
Control stalk, lighting

78–79
Control stalk, wipers

83–86
Control unit

169–170, 172
Courtesy lamps

69
Cover, load space

73
Cruise control

132, 134, 136–138
Cruise control, adaptive

139
Cruise control by speed limit recognition

134
Cruise control, dynamic with Stop function

134
Cup holder

66
D
DAB (Digital Audio Broadcasting) -
Digital radio
231–232, 245, 269
Date (setting)

23–24, 251, 275
Daytime running lamps

79, 202
Deactivating the passenger
airbag

98, 101–102
Deadlocking

29, 31
Deferred charging 27, 168, 171, 173
Defrosting
64
Defrosting, front

64
Demisting

64
Demisting, front

64
Demisting, rear

65
Demisting, rear screen

65
Dials and gauges

9
Digital instrument panel

9–10
Dimensions

226
Dipstick

17, 181
Direction indicators

79, 202–204
Domestic charging

170, 173
Door pockets

66
Doors

36
Drive Assist Plus

139
Driver’s attention warning

149
Driving

44–45, 113
Driving aids camera (warnings)

131
Driving aids (recommendations)

130
Driving economically

7
Driving positions (storing)

47–48
Dynamic pack

125–126
Dynamic stability control (DSC)

90–92
E
EBFD 90
Eco-driving (advice)
7
Economy mode

179
Electric automatic gearbox (Hybrid)

124

283
Alphabetical index
Mirrors, door 49–50, 65, 154
Mirror, vanity
66
Misfuel prevention

167
Modularity, seats

57
Motor, electric

126, 167, 225
Motorised tailgate

37–38, 40
Mountings, ISOFIX

105
MP3 CD

233
N
Navigation 260–262
Navigation, connected
263–265
Net

73–74
Net, high load retaining

75–76
Number plate lamps

205
O
Obstacle detection 155
Oil change
181
Oil consumption

181
OIl, engine

181
On-board tools

76, 191–193
Opening the bonnet

179–180
Opening the boot

30, 36
Opening the doors

30, 36
Opening the windows

28
P
Pads, brake 184
Paint
188, 227
Paint colour code

227
Paint, matt

188
Parcel shelf, rear

71, 73
Park Assist

161–162
Parking brake, electric

118–120, 184
Parking sensors, audible and visual

155
Parking sensors, front

156
Parking sensors, rear

155
Personalisation

10
Plates, identification

227
Player, Apple®

234, 246, 270
Player, MP3 CD

233
Player, USB

232, 245, 270
Port, USB

67, 232, 245, 265, 270
Power

20
Power indicator

20
Pressures, tyres

184, 196, 227
Pre-tensioning seat belts

97
Priming pump

191
Priming the fuel system

190
Profiles

250, 274
Protecting children

98, 100–103,
105, 107, 110–111
Puncture

193–194, 196
Q
Quiet vehicle warning sound 88
R
Radar (warnings) 131
Radio
230–231, 243–244, 246, 268
Radio, digital (Digital Audio
Broadcasting - DAB)

231, 245, 269
Range, AdBlue®

18, 182
RDS

244, 268–269
READY lamp

179
Rear air blower

63
Rear screen, demisting

65
Rechargeable hybrid system

5, 26, 116, 126,
167
Recharging the battery

211, 214
Recirculation, air

62, 64
Recorder, total distance

20
Recovery

215–218
Recovery of the vehicle

216
Reduction of electrical load

179
Regeneration of the particle filter

183
Regenerative braking (deceleration
by engine braking)

125
Reinitialisation of the under-inflation
detection system

130
Reinitialising the remote control

34
Reminder, key in ignition

11 6
Reminder, lighting on

79