warning Peugeot 301 2012 Owner's Guide

48
Access











Doors
From out side
)After unlocking the vehicle using the remote control or the key, pull the door
handle.


Opening
From inside
)Pull the interior control lever of a front door;
this unlocks the vehicle completely.


-
when the engine is running,this warning lamp comes on,
accompanied by a message in
the multifunction screen for a few seconds,

-
when the vehicle is moving
(speed
higher than 6 mph (10 km/h)), this warninglamp comes on, accompanied by an
audible signal and a message in the
multifunction screen for a few seconds.

Closing

When a door is not closed correctly:


Secondary control

For mechanically locking and unlocking the doors in the event of a fault with the central
locking system or a battery failure.

Driver's door

Inser t the key in the lock to lock or unlock the door.


Passenger doors
)On the rear doors, check that the child lock
is not on.)Remove the black cap located on the edge
of the door, using the key. )Inser t the key into the aper ture without
forcing, then without turning, move the
latch sideways towards the inside of
the door. )Remove the key and refit the cap.

49
2
Access











Boot


Opening

Unlocking and releasing the boot using the remote control
)
Press the centre button on the
remote control for more than one second.The boot lid is released and opens
slightly.
Releasing the boot from the
inside
Openin
g the boot
) Raise the boot lid to its fully open position.
)
Lower the boot lid using one of the interior grab handles.
Closing

Electric boot opening
-when the engine is running
, this
warning lamp comes on, accompanied
by a message in the multifunction
screen for a few seconds,-when the vehicle is moving (speed above 6 mph (10 km/h)), this warning lamp comes
on, accompanied by an audible signal and
a message in the multifunction screen for afew seconds.

)
Press the boot opening switch located
on the left of the dashboard (electric boot
opening).or ) Raise the control lever below the driver's
door (mechanical boot opening).
The boot lid is released and opens slightly.
Mechanical boot opening

There is no associated warning for the boot lid
not being fully closed.

Yo u should ensure that the boot is closed correctly.
If the boot is not closed correctl
y:

51
2
Access








Windows

Electric controls
Manual controls
The electric window switches remain operational for about 45 seconds after switching off the ignition or until a front door is opened. During this period of 45 seconds, if you open a door whileoperating a window, the window stops.
Operating the switch again has noeffect until the ignition is switched on again.


Always remove the key from the ignition when leaving the vehicle, even for a short time.
In the event of contact during operationof the windows, you must reverse themovement of the window. To do this,press the switch concerned.
When operating the passenger electricwindow switches, the driver must ensure that no one is preventing correct closing of the windows.
The driver must ensure that the passengers use the electric windows correctly.
Be aware of children when operatingthe windows.
1.Left hand front electric window switch.2.Right hand front electric windowswitch.3.Right hand rear electric window switch.4.Left hand rear electric window switch.5.
Deactivating the rear electric window switches.To open or close the window, press or pull the
switch. The window stops as soon as the switch is released. T
urn the window winder located on the door
trim panel.
Deactivating the rear window controls

For the safety of your children, press switch 5
to prevent operation of all of the windows,
irrespective of their position.
With the warning lamp on, the switches are
deactivated. With the warning lamp off, theswitches are active.
Model with front electric window
s
Model with front and rear electric windows

52
Access
When the low fuel level in the tank is reached, this warning lamp comes
on in the instrument panel.
Opening the filler cap may result in an inrush of air. This vacuum is entirely normal and results from the sealing of the fuel system.
























Fuel tank
Capacity of the tank: approximately 50 litres.

A label on the inside of the filler flap reminds you of the type of fuel to use according to your engine.
Additions of fuel must be of at least 5 litres to be registered by the fuel gauge.


Refuelling
)Open the filler cap by turning it a 1/4 turn to
the left.)Remove the filler cap and hang it on its carrier (on the filler flap).)Fill the tank. Do not continue past the thirdcut-off of the nozzle, as this may causemalfunctions. )Refit the filler cap turning it a 1/4 turn to the right. )Push the filler flap to close it.
Opening
)Raise the lever. When it first comes on,
around 5 litres
of fuel
remain in the tank.
You must refuel as soon as possible to avoid
running out.
If you run out of fuel (Diesel), refer the the
"Checks" section.

74
Fittings
Storage box
)Raise the boot carpet for access to the
storage box.
This has areas
for the storage of a box of spare
bulbs, a first aid kit, two warning triangles...
It also contains the vehicle tools, the temporary puncture repair kit...

76
Driving





Manual parking brake
Application
)Pull the parking brake lever up toimmobilise your vehicle.



Release
)
Pull the parking brake lever up gently,
press the release button then lower the
lever fully.
When parking on a slope, direct your wheels against the kerb, apply the parking brake, engage a gear and switch off the ignition.

When the vehicle is being driven, if this
warning lamp and the STOP
warning lampcome on, accompanied by an audible signal and a message in the screen, indicating that theparking brake is still on or has not been fully released.

78
Driving

Gear lever















Electronic gearbox


Displays in the instrument panel


Gear lever positions
N.NeutralR.Reverse
1 2 3 4 5.Gears in manual mode.
AUTO. This comes on when automated mode
is selected. It goes off when changing to
manual mode.
R. Reverse ) With your foot on the brake, move the lever for wards to select this position.N.Neutral. )
With your foot on the brake, select this
position to start the engine.
A. Automated mode.) Move the lever backwards to select this
mode. M + / -.
Manual mode with sequential gear changing. )
Move the lever backwards, then to the left
to select this mode, then:


- push for wards to change up a gear,

- or push backwards to change down a gear.
Five-speed electronicall
y controlled gearbox
which offers a choice between the comfort of automated operation or the pleasure of manualgear changing.
Tw o d r i v i ng modes are offered: -automatedmode for automatic control
of the gears by the gearbox, without anyaction by the driver,- manualmode for the sequential changingof the gears by the driver, using the gear lever.
)Place your foot on the brakewhen this warning lamp flashes (e.g.: star ting the engine).

80
Driving
Automated mode
AUTOand the gear engaged appear in the instrument panel.

Manual mode
The gears engaged appear insuccession in the instrument panel.
The
gearbox then operates in auto-adaptive mode, without any action on the par t of thedriver. It continuously selects the most suitable gear taking account of:
- optimisation of fuel consumption,
- driving style,
- road conditions,
- v
ehicle load.
For optimum acceleration, when over takinganother vehicle for example, press theaccelerator pedal fully down, beyond the point of resistance. The
gear change requests are only carried out
i
f the engine speed permits.
It is not necessary to release the accelerator
pedal during gear changes.
When braking or slowing down, the gearbox changes down automatically so that the vehicle
picks up in the right gear.
Under full acceleration, the change up will not
take place unless the driver operates the gear lever (unless the engine is close to its maximum
speed).

Never select neutral (position N ) when moving.



You can change mode at any time bymoving the gear lever from Ato Mor the other way round.
Never select neutral (position N) whenmoving.
You can change mode at any time by moving the gear lever from A
to M
or the other way round.
)Select position A.)
Select position M.


Reverse
To engage reverse, the vehicle must be
immobilised with
your foot on the brake.)Select position R.

At low speed, if reverse gear is requested, the Nwarning lamp flashes and the gearbox goes
into neutral automatically.
To e n
gage reverse, put the gear lever intoposition N, then to position R
.


There is an audible signal onengagement of reverse.

81
5
Driving
AUTOand -appear in the instrument panel.
) Select position N.)
Press the brake pedal. )
Wait for around 30 seconds until N
or agear appears in the instrument panel.)
Move the gear lever to position A
, then to
position N.) With your foot still on the brake pedal, start
the engine.The gearbox is operational again.
Reinitialisation
Following disconnection of the battery, it is
necessary to reinitialise the gearbox.) Switch on the ignition.


Before doing anything under the bonnet, ensure that the gear lever is inneutral (position N ) and that the parkingbrake is applied.



In exceptional circumstances, the gearbox may need an automatic reinitialisation: starting and gear changing are no longer possible.
AUTOand -appear in the instrument panel.

For all parking situations, you mustapply the parking braketo immobilise the vehicle.

When immobilising the vehicle with theengine running, you must put the gear lever into neutral (position N)
. Be
fore switching off the engine:


- chan
ge to position N
to be in neutral,
or

- leave the vehicle in gear; in this case the
vehicle cannot be moved.

Follow the procedure described above.



Stopping the vehicle

With the ignition on, if this warninglamp comes on and AUTOflashes, accompanied by an audible signal and
a message in the multifunction screen, this
indicates a gearbox fault. Have it checked by a PEUGEOT dealer or a qualified workshop.


Operating fault

83
5
Driving
Apply the parking brake. )Select position P or N
.
)Star t the engine.
If this procedure is not followed, there is an
audible si
gnal, accompanied by the display of
an warning message.)With the engine running, press the brake pedal. )Release the parking brake. )Select position R, Dor M.)Gradually release the brake pedal.
The vehicle moves off immediately.


Moving off


When the engine is running at idle, with the brakes released, if position R, D
or M
is selected, the vehicle moves evenwithout the accelerator being pressed.
When the engine is running, never leave children in the vehicle without supervision. When carrying out maintenance with the engine running, apply the parkingbrake and select position P
.
P


If position N
is selected inadver tently while driving, allow the engine toreturn to idle then select position D
toaccelerate.
Never select position N
while the vehicle is moving.Never select positions P
or Runless thevehicle is completely stationary.

Automatic operation
)
Select position Dfor automaticchanging
of the four gears.The gearbox then operates in auto-adaptivemode, without any inter vention on the par t
of the driver. It continuously selects the most
suitable gear according to the style of driving,
the profile of the road and the load in the
v
ehicle.
For maximum acceleration without touching the gear lever, press the accelerator pedal downfully (kick down). The gearbox changes downautomatically or maintains the gear selecteduntil the maximum engine speed is reached.On braking, the gearbox changes downautomatically to provide efficient engine
braking.
If you release the accelerator sharply, thegearbox will not change to a higher gear for
safety reasons.

Sport and snow programmes


Sport programme "S"
)
Press button "S", after star ting the engine.
The
gearbox automatically favours a dynamic style of driving.
S
appears in the instrument panel.


Snow programme " 7
"
)
Press button "7
", after star ting the engine.
The gearbox adapts to driving on slipperyroads.
This programme improves star ting and drive
when traction is poor.
7 appears in the instrument panel.


Return to automatic
o
peration
) At any time, press the button selectedagain to quit the programme engaged and
return to auto-adaptive mode. These two special programmes supplement the
automatic operation in ver
y specific conditions of use.