light Peugeot 301 2017 User Guide

17
Warning / indicator lampStateCause Action / Observations
Under-inflation Fixed, accompanied
by and audible signal
and a message. One or more wheels has
insufficient pressure.
Check the pressure of the tyres as soon as possible.
This check should preferably be carried out when the
tyres are cold.
You must reinitialise the system after adjusting one or
more tyre pressures and after changing one or more
wheels.
For more information on Under-inflation detection
,
refer to the corresponding section.
or Flashing then fixed,
accompanied by the
Service warning light.
The system has a fault: tyre
pressures are no longer
monitored. As soon as possible, check the pressure of the tyres.
Have the system checked by a PEUGEOT
dealer or a
qualified workshop.
Anti-lock
Braking System
(ABS) Fixed.
The anti-lock braking system
has a fault. The vehicle retains conventional braking.
Drive carefully at reduced speed and contact a
PEUGEOT
dealer or a qualified workshop without
d e l ay.
1
Instruments

18
Warning / indicator lampStateCause Action / Observations
Airbags Temporarily on. This warning light comes on for
a few seconds when you turn on
the ignition, then goes off. This warning light should go off when the engine is
started.
If it does not go off, contact a PEUGEOT
dealer or a
qualified workshop.
Continuous. One of the airbag or seat belt
pretensioner systems has a fault. Have it checked by a PEUGEOT
dealer or a qualified
workshop.
Passenger's
airbag system Continuous.
The control switch, located in
the glove box, is set to the " OFF"
position.
The passenger's front airbag is
deactivated.
You can install a "rearward"
facing child seat, unless there is
a fault with the airbags (airbag
warning light on). To activate the passenger front airbag, turn the
control to the "
ON" position.
In this case, do not fit a child seat in the "rear ward"
facing position.
Dynamic
stability control
(DSC/ASR) Continuous.
The button, located at the
bottom left of the dashboard, is
pressed. Its indicator light is on.
The DSC/ASR is deactivated.
DSC: dynamic stability control.
ASR: anti-slip regulation. Press the button to activate the DSC/ASR. Its
indicator light goes off.
The DSC/ASR system is activated automatically when
the vehicle is started.
If the system is deactivated, it is reactivated
automatically once a speed of around 30 mph (50
km/h) is reached.
Instruments

19
Warning / indicator lampStateCause Action / Observations
Dynamic
stability control
(DSC/ASR) Flashing.
The DSC/ASR regulation is
active. The system optimises traction and allows improved
directional stability of the vehicle.
Continuous. Unless it has been deactivated
(button pressed and its indicator
light on) the DCS/ASR system
has a fault. Have it checked by a PEUGEOT
dealer or a qualified
workshop.
Power steering Continuous. The power steering has a fault. Drive carefully at reduced speed.
Have it checked by a PEUGEOT dealer or a qualified
workshop.
1
Instruments

20
Warning / indicator lampStateCause Action / Observations
AdBlue
®
(BlueHDi Diesel) Fixed, on switching
on the ignition,
accompanied by an
audible signal and a
message indicating
the remaining driving
range. The remaining driving range is
between 350 miles (600 km) and
1,500 miles (2,400 km).
Have the AdBlue
® tank topped-up as soon as
possible: go to a PEUGEOT dealer or a qualified
workshop, or carry out this operation yourself.
or Flashing, associated
with the SERVICE
warning light,
accompanied by an
audible signal and a
message indicating
the remaining driving
range.The remaining driving range is
between 0 and 350 miles
(6 0 0 k m).
You must top-up the AdBlue
® tank to avoid a
breakdown : go to a PEUGEOT dealer or a qualified
workshop, or carry out this operation yourself.
Flashing, associated
with the SERVICE
warning light,
accompanied by an
audible signal and a
message indicating
that starting is
prevented. The AdBlue
® tank is empty:
the starting inhibition system
required by legislation prevents
starting of the engine. To be able to start the engine, you must top-up the
AdBlue® tank: go to a PEUGEOT
dealer or a qualified
workshop, or carry out this operation yourself.
It is essential to add at least 3.8 litres of AdBlue
® to
the fluid tank.
Instruments

21
Warning / indicator lampStateCause Action / Observations
or SCR emissions
control system
(BlueHDi Diesel)
Fixed, on switching
on the ignition,
associated with the
Service and engine
diagnostic warning
lights, accompanied
by an audible signal
and a message. A fault with the SCR emissions
control system has been
detected.
This alert disappears once the exhaust emissions
return to normal levels.
Flashing, on
switching on the
ignition, associated
with the Service and
engine diagnostic
warning lights,
accompanied by an
audible signal and a
message indicating
the remaining driving
range. After confirmation of the fault
with the emissions control
system, you can continue driving
for up to 650 miles (1,100 km)
before the engine starting
inhibition system is triggered.
Contact a dès que possible
PEUGEOT dealer or
a qualified workshop without delay, to avoid a
breakdown .
Flashing, on switching
on the ignition,
associated with the
Service and engine
diagnostic warning
lights, accompanied
by an audible signal
and a message. You have exceeded the
authorised driving limit following
confirmation of a fault with the
emissions control system: the
engine starting inhibition system
prevents starting of the engine.
To be able to start the engine, you must
call on a
PEUGEOT dealer or a qualified workshop.
1
Instruments

22
orService
Temporarily on. A minor fault has occurred
for which there is no specific
warning light. Identify the fault by reading the message shown in
the screen, such as, for example:
-
s aturation of the particle emissions filter (Diesel).
- t he power steering,
-

a m
inor electrical fault.
For any other faults, contact a PEUGEOT dealer or a
qualified workshop.
Continuous. A major fault has occurred
for which there is no specific
warning light. Identify the fault by reading the message shown in
the screen and then contact a PEUGEOT
dealer or
qualified workshop.
Warning / indicator lamp
StateCause Action / Observations
Rear foglamp Fixed. The rear fog lamp has been
switched on using the ring on the
lighting control lever. Turn the ring on the lighting control lever to the rear to
switch off the rear fog lamp.
Stop & Star t Continuous. When the vehicle stopped (red
lights, traffic jams,...) the Stop &
Start system has put the engine
into STOP mode. The warning light goes off and the engine restarts
automatically in START mode, as soon as you want
to move off.
Flashes for a few
seconds, then goes
of f. STOP mode is temporarily
unavailable.
or
START mode is invoked
automatically. For more information on Stop & Star t
, refer to the
corresponding section.
Instruments

23
Warning / indicator lampStateCause Action / Observations
Front fog lights Continuous. The front fog lights are switched
on using the ring on the lighting
control lever. Turn the ring on the lighting control lever rear ward
once to switch off the front fog lights.
Left-hand
direction
indicator Flashing with buzzer.
The lighting stalk has been
pushed down.
Right-hand
direction
indicator Flashing with buzzer.
The lighting stalk has been
pushed up.
Dipped beam
headlights Continuous.
The lighting lever is in the
"Dipped beam headlights"
position.
Main beam
headlights Continuous.
The lighting lever has been
pulled towards you. Pull the lever to return to dipped beam headlights.
Foot on the
clutch Continuous.
In STOP mode of the Stop &
Start, the transition to START
mode has been rejected
because the clutch pedal is not
fully pressed down. With a manual gearbox, you must declutch fully to
allow the change to engine START mode.
1
Instruments

24
Foot on brakeContinuous. The brake pedal must be
pressed. With an electronic gearbox, selector in position N
,
press the brake pedal to start the engine.
With an automatic gearbox, with the engine running,
press the brake pedal before releasing the parking
brake to unlock the lever and come out of position P .
If you wish to release the parking brake without
pressing the brake pedal, this warning light will
remain on.
Flashing. With an electronic gearbox, the
clutch will overheat if you hold
the vehicle on an incline using
the accelerator for too long. Use the brake pedal and/or the parking brake.
Warning / indicator lamp
StateCause Action / Observations
Instruments

26
The servicing interval has been
exceeded
For 5 seconds after the ignition is switched on,
the spanner flashes to indicate that the service
must be carried out as soon as possible.
Example: the service is overdue by 186 miles
(3 0 0 k m).
For 5 seconds after the ignition is switched on,
the screen indicates:
5 seconds after the ignition is switched on,
the total distance recorder resumes its normal
operation. The spanner remains on .
For BlueHDi Diesel versions, this alert
is also accompanied by the continuous
illumination of the Service warning light
when the ignition is switched on. The remaining mileage may be weighted
by time according to the driver’s driving
habits.
The spanner may therefore also come
on if you have exceeded the period
since the last service, as indicated in the
manufacturer's service schedule.
For BlueHDi Diesel versions, the spanner
may also come on early, depending on the
degree of deterioration of the engine oil
(depending on the country of sale).
The degree of deterioration of the engine
oil depends on the driving conditions in
which the vehicle is used.
Resetting the service indicator
After each service, the service indicator must
be reset to zero.
To do so, follow this procedure:
F

S
witch off the ignition.
F

P
ress the trip distance recorder reset
button and keep it pressed.
F

S
witch on the ignition; the distance
recorder display begins a countdown.
F

W
hen the display indicates =0, release the
button; the spanner disappears.
Following this step, if you wish to
disconnect the battery, lock the vehicle
and wait at least five minutes for the reset
to be taken into account.
Retrieving the service
information
You can access the service information at any
time.
F
P
ress the trip distance recorder reset
button. The service information is
displayed for a few seconds, then
disappears.
Instruments

27
AdBlue® liquid range indicators
Once the AdBlue® tank is on reserve or after
detection of a fault with the SCR emissions
control system, when the ignition is switched
on, an indicator displays an estimate of the
distance that can be covered, the range, before
engine starting is prevented.
In the event of simultaneous system fault and
low AdBlue
® level, the shortest range figure is
the one displayed.
Range greater than 1,500 miles (2,400 km)
When switching on the ignition, there is no
automatic display of range in the instrument
panel.
In the event of the risk of non-starting related to a lack of
AdBlue®
The engine start prevention system
required by regulations is activated
automatically once the AdBlue
® tank is
e m pt y. Range between 350 and 1,500 miles
(600 and 2,400 km)
When switching on the ignition, the AdBlue
warning light comes on, accompanied by
an audible signal and the temporary display
of "NO START IN" and a distance on the
instrument panel, indicating the remaining
range expressed in miles or kilometres before
engine starting is prevented - (e.g. "NO START
IN 1500 km" means "Starting will be prevented
in 1,500 km (930 miles).
When driving, this message is displayed every
186 miles (300 km) until the AdBlue level has
been topped-up.
®
The reserve level has been reached: it is
recommended that you top-up as soon as
possible.
It is recommended that you not top up by more
than 10 litres of AdBlue.
For more information on AdBlue
® and the SCR
(BlueHDi Diesel) system , and in particular
topping it up, refer to the corresponding
section.
1
Instruments