towing Peugeot 307 2007.5 Owner's Manual

47
COMFORT
6. Demisting the rear screen and the mirrors
Pressing the button once
demists the rear screen
and the exterior mirrors.
This switches off automati-
cally to prevent an exces-
sive consumption of current.
Pressing again reactivates demisting.
It is possible to stop demisting be-
fore it is switched off automatically by
pressing the button again. In certain cases of particu-
larly arduous use (towing the
maximum load on a steep
gradient in high tempera-
tures), switching off the air condition-
ing permits the recovery of engine
power and therefore an increase in
the towing capacity.
In order for the air conditioning to be
fully effective, the windows must be
closed.
The air conditioning system does not
contain chlorine and does not pres-
ent any danger to the ozone layer.
Operate the air conditioning system
for 5 to 10 minutes, once or twice a
month, to keep it in perfect working
order.
The water produced by the air con-
ditioning condensation is discharged
through an opening provided for this
purpose. Therefore, a puddle of wa-
ter may form underneath the vehicle
when stationary.
In order to ensure that the air condi-
tioning system operates correctly, reg-
ular checks are also recommended.
If the system does not produce cold air,
do not use it and contact a PEUGEOT
dealer.
5. Air intake/Air recirculation
Pressing button 5 permits
recirculation of the interior
air. This is indicated by il-
lumination of the indicator
light.
As soon as possible, press button

5 again to permit the intake of out-
side air, to prevent deterioration of
the air quality and to avoid misting of
the windows. This is indicated by the
switching off of the indicator light.
The interior air recirculation enables
you to isolate the passenger com-
partment from exterior odours and
smoke.
The outside air intake enables you to
prevent and eliminate misting of the
windscreen and side windows.
Used simultaneously with the air con-
ditioning, air recirculation enables
performance to be improved.
Used in a humid climate, air recir-
culation may result in misting of the
windows.
Rapid demisting of the wind-
screen
To quickly de-ice or demist the wind-
screen and side windows:
- place the air distribution control in the "windscreen and side win-
dows" position,
- place the temperature 2 and air
l ow 3 controls at maximum, as
indicated by the "Windscreen
and side windows" symbol on the
control panel,
- close the centre vents,
- switch air intake button 5 to the
"Outside Air Intake" position (but-
ton 5 indicator light off),
- start the air conditioning by press- ing button 1 .

COMFORT
50
In certain cases of particu-
larly arduous use (towing the
maximum load on a steep
gradient in high tempera-
tures), switching off the air condition-
ing permits the recovery of engine
power and therefore an increase in
the towing capacity.
In order for the air conditioning to be
fully effective, the windows must be
closed.
The air conditioning system does not
contain chlorine and does not pres-
ent any danger to the ozone layer.
Operate the air conditioning for 5 to
10 minutes, once or twice a month, to
keep it in good working order.
The water produced by the air con-
ditioning condensation is discharged
through an opening provided for this
purpose. Therefore, a puddle of wa-
ter may form underneath the vehicle
when stationary.
In order to ensure that the air condi-
tioning system operates correctly, reg-
ular checks are also recommended.
If the system does not produce cold air,
do not use it and contact a PEUGEOT
dealer.

VISIBILITY
Front and rear lights (ring A)

 Place ring A in the required
position. Dipped/Main beam change

 Pull the stalk towards you.
Vehicles i tted with front fog lamps
and a rear fog lamp (ring C)
Lights off
Side lights Dipped/main beam
headlamps Rear fog lamp Front fog lamps ( i rst rotation
of the ring forwards)
Front and rear fog
lamps (2
nd rotation of
the ring forwards).

Note: to switch off
the rear fog lamp
and the front fog lamps, turn the ring
backwards twice in succession.
Vehicles i tted with a rear fog
lamp (ring B)
This operates with the dipped/main
beam headlamps.

Note: when the lights are switched off
automatically, the rear fog lamp and
the dipped headlamps will remain on.
Turn the ring backwards to switch
off the rear fog lamp. The dipped
headlamps will then be switched off. The front fog lamps operate with
the side lights and the dipped
headlamps.
Front fog lamps and rear fog
lamp

 Turn ring B or C forwards to switch
on and backwards to switch off.
The status is coni rmed by the
indicator light on the instrument
panel .
Lights on buzzer
With the ignition off and the automatic
switching on of the lights deactivated,
when the driver’s door is opened, a
buzzer sounds to warn you that you
have left your lights on.
The rear fog lamp will be
deactivated automatically
when towing or when a
bicycle carrier i tted with a
fog lamp is i tted.
LIGHTS STALK
In good or rainy weather,
both day and night, the front
fog lamps and the rear fog
lamp are dazzling and are
prohibited.
Do not forget to switch them off when
they are no longer needed.
Automatic switching
on of the lights

LAYOUT
85

1. Rear parcel shelf
To remove the shelf:
- unhook the two strings,
- slightly raise the shelf, then remove it.
The shelf can be stored:
- either behind the front seats,
- or behind the rear seat.

2. Hooks

3. Stowing rings
4. Luggage retaining net
Hooked onto the stowing rings, this
enables your luggage to be secured.

5. Open storage trays

6. 12 volt socket (100 W max)
This is a lighter type socket, installed
on the left-hand side of the parcel
shelf.
It is supplied from the "Running"
position.
BOOT LAYOUT (SALOON)

LAYOUT
87
BOOT LAYOUT (ESTATE)
4. Boot l oor and pillar stowing rings
5. Rear seat stowing rings
6. Luggage retaining net
Secure the net hooks in the stowing
rings on the l oor or on the folded
rear seat (two horizontal positions) or
secure the net hooks in the stowing
rings on the boot pillars and in the
l oor rings at the rear of the boot (one
vertical position).
7. 12 volt socket (100 W max)
This is a lighter type socket, installed
on the load space cover left support.
It is supplied from the "Running"
position. 8. High load retaining net i xings
The high load retaining net can be
installed behind the front or rear
seats.
Open the covers of the corresponding
upper i xings.
Fit the ends of the metal bar in these
i xings.
To install the high load retaining net:
- behind the front seats, lift the rear
seat cushion, hook the net straps
on the i xings then fold the rear
seat;
- behind the rear seat, hook the net straps in the stowing rings on the
l oor.
The rings are located directly below
the corresponding upper i xings.
Pull the two straps taut.
9. Grab handles and coat hooks
1. Load space cover
To install it:
- position the front ends of the
cover on its support and press
gently to put it in place,
- unfold the cover fully,
- position the rear ends of the cover on its support and press gently to
put it in place.
To remove it:
- unclip the rear ends,
- fold the cover fully,
- unclip the front ends and remove the cover.
To store it, slide it under the rear
seats (location A ).
2. Floor storage trays (2/3 - 1/3)
3. Storage nets
One of them contains the luggage
retaining net.

DRIVING
107
VISUAL AND AUDIBLE REAR
PARKING ASSISTANCE
This system consists of four proximity
sensors, located in the rear bumper.
This detects any obstacle (person,
vehicle, tree, gate, etc.) behind the
vehicle. Nevertheless, it cannot
detect obstacles located just below
the bumper.
An object, such as a stake, a
roadworks cone or any other similar
object may be detected at the
beginning of the manoeuvre, but
may no longer be detected when the
vehicle comes close to it.

Note: this function will be disarmed
automatically when the vehicle is
towing a trailer or when a bicycle
carrier is i tted (vehicle i tted with
towing attachment or bicycle carrier
recommended by PEUGEOT).
In bad or wintry weather, ensure that
the sensors are not covered with
mud, frost or snow. When reverse
gear is engaged, an audible signal
(long bleep) indicates that the
sensors may be dirty. The proximity information is given
by:
- an audible signal, which becomes
more rapid as the vehicle
approaches the obstacle,
- a graphic on the multifunction display, with blocks which become
progressively closer to the vehicle.
Depending on the multifunction
display, the audible signal is
transmitted by a buzzer or by the rear
speakers which transmit:
- on the right if an obstacle is detected on the right,
- on the left if an obstacle is detected on the left,
- on the right and on the left if an obstacle is detected in the centre.
When the distance between the
rear of the vehicle and the obstacle
is less than approximately thirty
centimetres, the audible signal
becomes continuous and the
"Danger" symbol appears depending
on the multifunction display.
 Change to neutral, the system is
again inactive.
If there is an operating
fault, when reverse gear is
engaged, the service warning
light comes on, accompanied
by an audible signal (short bleep)
and a message on the multifunction
display.
Contact a PEUGEOT dealer.
Activation/Deactivation
Activation
The system is activated as soon as
reverse gear is engaged.
This is accompanied by an audible
signal and displaying of the vehicle,
depending on the multifunction
display. The system can be activated
or deactivated from the
multifunction display
coni guration menu.
The activation and deacti-
vation of the system are memorised
when the engine is switched off.
Switching the system off

10PRACTICAL INFORMATION
117

1. Wheelbrace.

2. Jack with handle.

3. Centralising tool.

4. Socket for anti-theft bolt.
5. Removable towing eye.

6. Alloy wheel bolt trim remover.

7.
Alloy wheel trim remover.
Parking the vehicle

 If possible, park the vehicle on
level, stable and non-slippery
ground.

 Apply the handbrake, switch off
the ignition and engage i rst or
reverse gear (position P for the
automatic gearbox).
To gain access to the spare wheel
and the jack in the boot, lift the l oor
using the handle.
CHANGING A WHEEL (SALOON)
Tools
The following tools are located in a holder in the cent re of the spare wheel:
A diagram on the holder indicates the location of the to ols.

10PRACTICAL INFORMATION
120
Parking the vehicle

 As far as possible, park the
vehicle on level, stable and non-
slippery ground.

 Apply the handbrake, switch off
the ignition and engage i rst or
reverse gear (position P for the
automatic gearbox). Access to the spare wheel

 Open the boot.

 Open the l ap using the lug
to release the winch and gain
access to its control nut.

 Unscrew the nut fully, using the
wheelbrace 1 , to unroll the winch
cable.
Tools
The following tools are located:
- in the right-hand trim of the boot,

1. Wheelbrace.
2. Removable towing eye.
3. Socket for anti-theft bolts.
- in the holder in the centre of the spare wheel,
4. Jack with handle.
5. Centralising tool.
6. Bolt cover tool.
CHANGING A WHEEL (ESTATE)

10PRACTICAL INFORMATION
Without lifting
(4 wheels on the ground)
You must always use a tow bar.
The removable towing eye is inside
the spare wheel.

Estate: the removable towing eye is
inside the right-hand boot trim. From the front:

 Unclip the cover, by pressing the
bottom part,

 Screw in the towing eye as far as
it will go.
Lifting (2 wheels only on the
ground)
It is preferable to raise the vehicle
with a professional lifting device.
When towing with the engine
switched off, there is no brak-
ing or steering assistance.
TOWING YOUR VEHICLE
From the rear:

 Unclip the top of the cover using
a coin,

 Screw in the towing eye as far as
it will go.
Special features of the
automatic gearbox
When towing with four wheels on the
ground, the following rules must be
obeyed:
- lever in position N ,
-
tow the vehicle at less than 30 mph
(50 km/h) up to a maximum dis-
tance of 30 miles (50 km).
- do not add oil to the gearbox.

10PRACTICAL INFORMATION
136
Driving advice
Distribution of loads:
Distribute the load in the trailer so
that the heaviest items are as close
as possible to the axle and the nose
weight approaches the maximum
permitted without exceeding it.
Cooling:
towing a trailer on a slope increases
the temperature of the coolant.
As the fan is electrically controlled,
its cooling capacity is not dependent
on the engine speed.
To lower the engine speed, reduce
your speed.
The maximum towing load on a long
slope depends on the gradient and
the outside temperature.
In all cases, pay attention to the
coolant temperature.
If the warning light comes on, stop
the vehicle and switch off the engine
as soon as possible. Tyres:
check the tyre pressures of the towing
vehicle and of the trailer, observing
the recommended pressures.
Braking:
towing increases the
braking distance.
Lights: check the electrical
signalling on the trailer.
Side wind: take into account the
increased sensitivity to side wind.
TOWING A TRAILER, A
CARAVAN, A BOAT, ETC...
Your vehicle is primarily designed
for transporting people and luggage
but it may also be used for towing a
trailer.
We recommend the use of original
PEUGEOT towbars and their
harnesses that have been tested and
approved from the design stage of
your vehicle and that the i tting of the
towbar is entrusted to a PEUGEOT
dealer.
If the towbar is not i tted by a
PEUGEOT dealer, it is imperative
that it is i tted using the electrical
pre-equipment located at the rear of
the vehicle in accordance with the
manufacturer’s instructions.
Driving with a trailer subjects the
towing vehicle to more signii cant
stress and its driver must be
particularly careful.
Air density decreases with altitude,
thus reducing engine performance.
Above 1 000 metres, the maximum
towing load must be reduced by 10 %
and so on for every 1 000 metres of
altitude.
The rear parking assistance function
will be disarmed automatically when
a towbar is i tted.