ignition Peugeot 307 SW 2003.5 Owner's Manual

29-09-2003






D
The menu CC'
2!CC
provides access to the following functions:
– changing of the route calculation criteria,
– voice synthesis adjustment of guidance messages,
– description of the information relating to the navigation CD-Rom,
– management of the addresses stored in the directory.
'
2!
The last criterion used is displayed. Select a criterion from the list, then validate by pressing the dial. When the criterion of your choice has been selected, select the
1:1
function then confirm by pressing thedial.
?!%
*'
'
!&*'!!' Select the type of voice 1( '1or
1/'( '1 , after inserting the configu-
ration CD-Rom. Adjust the volume of the voice synthesis by turning the dial, then validate bypressing the dial. '0
the volume can also be adjusted
during a message, using the audio/ telephone button or the steeringwheel control. %'('
/
*'
'& This function enables you to rename
an address stored in the directory. Select the description corresponding to the stored address to be changed. Select the
1'('1 function, then
confirm by pressing the dial. Select the 1:1function, then confirm
by pressing the dial to record the changes made.
22%E'!(%
%'
 "Stop guidance" During guidance, select this function then validate.
 "Resume guidance" In the absence of guidance, select this function then validate to activateguidance to the last destination pro-grammed. '0
after re-starting the engine, a
screen appears enabling you to resume guidance activated before
the ignition was switched off.
+  
'

3
4 The keys allow you to switch on the ignition and to independently operatethe locks on the front doors, the fuelfiller cap, the glove box and the pas-senger air bag disarming switch.
(
'5 -
From the driver's door, the keys allow you to lock, deadlock or unlock thedoors and tailgate, as well as fold backthe exterior mirrors. If one of the doors or the boot is open, the central locking does not work; anaudible signal indicates this when locking by remote control.


(*
'(

(+(*


*
+0' 


& '6

(*
'( '5 -Press button
to lock the vehicle.
This is confirmed by fixed lighting of the direction indicators for approxi-mately two seconds. /
a long press on button , in
addition to locking, automatically closes the windows.
7
'
+ &
 

&&'5 -
Warning: deadlocking renders the
internal and external door locking controls inoperative.


( on button deadlocks
the vehicle.This is confirmed by fixed lighting of the direction indicators for approxi-mately two seconds. / a long press on button , in
addition to deadlocking, automatically closes the windows.
 '&

( on button within
five seconds of deadlocking changes this to normal locking. This is confirmed by fixed lighting of the direction indicators for approxi-mately two seconds. '5 - Press button
8to unlock the vehicle.
This is confirmed by rapid flashing of the direction indicators. /
if the vehicle is locked and
unlocking is activated inadvertently without the doors being opened with-in 30 seconds, the vehicle will lock
itself automatically.
' -
.0(
,
'
To locate your car, if you have locked it, in a car park:  press button , the courtesy
lights come on and the direction indicators flash for a few sec-onds.

!"
#

 $!
29-09-2003

+ & 
'(&
The confidential card contains the identification code necessary for anywork carried out by a PEUGEOTdealer on the electronic immobiliser
system. This code is hidden by afilm, which should be removed only if
necessary.
4

.0(
'(&


+

'9
,(
 &


,
'6
4.

-  
A buzzer sounds on opening the dri-
ver's door, if the key has been left inthe ignition.
- -


(.
+


(*
'(
Warning that the battery is flat is given by an audible signal accompa-nied by the message
::*
';
(
(.
::
on the multi-func-
tion display.
To replace the battery, remove the screw then unclip the casing using acoin at the ring (CR 2016/3 volt battery). If the remote control does not work after the battery has been changed,reprogramme the remote control.
<(-(** -


(* '(
 Switch off the ignition.
 Switch the ignition on again.
 Immediately press button .
 Switch off the ignition and remove the remote control key
from the ignition lock. The remotecontrol is now working again.

!"
#


$!2


8 This locks the engine control system as soon as the ignition has been
switched off and therefore preventsstarting of the vehicle by anyone
who does not have the key. The ignition key has an electronic chip which has a special code.When the ignition is switched on, thecode must be recognised for startingto be possible.
+


.*
&

+0'  '(('. , the central locking button
indicator light, situated in the centreof the fascia, flashes rapidly whenthe ignition is switched on (2ndnotch), accompanied by an audiblesignal and the message = ;
+
&, '
+0.= on the multi-function
display. In this case your vehicle will not start.
Contact a PEUGEOT dealer as soon as possible.
29-09-2003

29-09-2003
Make a careful note of the number on each key. The key number is coded on the label attached to the key. If the keys are lost, your PEUGEOT dealer can rapidly supply you with new keys.The high frequency remote control is a sensitive system; do not operate it while it is in your pocket as there is a possibility that it may unlock your vehicle, without you being aware of it.
The remote control does not operate when the key is in the ignition, even when the ignition is switched off, except forreprogramming. Do not operate the deadlocking function if there is anyone inside the vehicle.Driving with the doors locked may make access to the passenger compartment by the emergency services more difficult
in an emergency. As a safety precaution (with children on board), remove the ignition key when you leave the vehicle, even for a short time.
Do not repeatedly press the button of your remote control out of range of your vehicle. You run the risk of stopping it from working and the remote control would have to be reprogrammed. When purchasing a second-hand vehicle: Ð ensure that you are given the confidential card;
Ð have the key codes memorised by a PEUGEOT dealer, to ensure that the keys in your possession are the only ones which can start the vehicle.
Do not make any modifications to the electronic engine immobiliser system.

!"
#

 $!"

+ & 
'(&
The confidential card contains the identification code necessary for anywork carried out by a PEUGEOTdealer on the electronic immobiliser
system. This code is hidden by afilm, which should be removed only if
necessary.
4

.0(
'(&


+

'9
,(
 &


,
'6
4.

-  
A buzzer sounds on opening the dri-
ver's door, if the key has been left inthe ignition.
- -


(.
+


(*
'(
Warning that the battery is flat is given by an audible signal accompa-nied by the message
::*
';
(
(.
::
on the multi-func-
tion display.
To replace the battery, remove the screw then unclip the casing using acoin at the ring (CR 2016/3 volt battery). If the remote control does not work after the battery has been changed,reprogramme the remote control.
<(-(** -


(* '(
 Switch off the ignition.
 Switch the ignition on again.
 Immediately press button .
 Switch off the ignition and remove the remote control key
from the ignition lock. The remotecontrol is now working again.

!"
#


$!2


8 This locks the engine control system as soon as the ignition has been
switched off and therefore preventsstarting of the vehicle by anyone
who does not have the key. The ignition key has an electronic chip which has a special code.When the ignition is switched on, thecode must be recognised for startingto be possible.
+


.*
&

+0'  '(('. , the central locking button
indicator light, situated in the centreof the fascia, flashes rapidly whenthe ignition is switched on (2ndnotch), accompanied by an audiblesignal and the message = ;
+
&, '
+0.= on the multi-function
display. In this case your vehicle will not start.
Contact a PEUGEOT dealer as soon as possible.
29-09-2003

29-09-2003
Make a careful note of the number on each key. The key number is coded on the label attached to the key. If the keys are lost, your PEUGEOT dealer can rapidly supply you with new keys.The high frequency remote control is a sensitive system; do not operate it while it is in your pocket as there is a possibility that it may unlock your vehicle, without you being aware of it.
The remote control does not operate when the key is in the ignition, even when the ignition is switched off, except forreprogramming. Do not operate the deadlocking function if there is anyone inside the vehicle.Driving with the doors locked may make access to the passenger compartment by the emergency services more difficult
in an emergency. As a safety precaution (with children on board), remove the ignition key when you leave the vehicle, even for a short time.
Do not repeatedly press the button of your remote control out of range of your vehicle. You run the risk of stopping it from working and the remote control would have to be reprogrammed. When purchasing a second-hand vehicle: Ð ensure that you are given the confidential card;
Ð have the key codes memorised by a PEUGEOT dealer, to ensure that the keys in your possession are the only ones which can start the vehicle.
Do not make any modifications to the electronic engine immobiliser system.

!"
#

 $!"

29-09-2003
3
 This provides two types of protection: Ðexterior protection: it sounds if a
door, the boot or the bonnet is opened.
Ð interior protection: it sounds if
the volume inside the passengercompartment changes (breaking ofa window or a movement insidethe vehicle).
 -


(*  Switch off the ignition and get out of the vehicle.
 Set the alarm, by locking ordeadlocking using the remotecontrol (button indicator light
flashes once per second).
/
if you wish to lock your vehicle
without setting the alarm, use thedoor lock. When the alarm is triggered, thesiren sounds and the direction indi-cator lights flash for thirty seconds. After triggering, the alarm remains set.
#( -/
if the alarm has been
triggered ten times in succession, on the eleventh time it becomesinactive. / if button indicator light flash-
es rapidly, the alarm has been trig- gered while you were away fromyour vehicle.
 (* - Unlock the vehicle with the remote control key (button indicator light
goes out). / if the alarm has been triggered
while you were away from your vehi- cle, the rapid flashing of the indicatorlight will stop when you switch on theignition.




(*
 

)( (
(' 
. If, while you are away from the vehi- cle, you wish to leave a window par-tially open or a pet inside the vehicle,you should choose exterior protec-
tion only.  Switch off the ignition,
 In the next ten seconds, press button until the indicator light is
on continuously,
 Get out of the vehicle, 
Set the alarm by locking or dead-locking using the remote control(button indicator light flashes
once a second).
/
when the alarm is set but the
remote control does not operate:  Unlock the doors with the key
and open the door. The alarm istriggered.
 Switch on the ignition. The alarmis disarmed.
'(('

(  When the ignition is switched on, if button lights for ten seconds, there
is a fault in the siren connection.
Contact a PEUGEOT dealer to have the system checked.
0* '
' , > The alarm is activated automatically two minutes after the last closure ofa door or the boot. In order to avoid accidental triggering of the alarm when a door or the bootis opened, it is essential to first pressthe unlocking button on the remotecontrol.
* According to destination.

!"
#


$!?

29-09-2003
3


 -


&(
+(* 0 &

 -


&(
+(*  & The front door opening controls per- mit complete unlocking of the vehi-cle.
However, the rear door opening controls only unlock the door concerned. /the door opening controls do
not function when the vehicle is deadlocked. '5 -@'5 -
+(*

  & Press button
.
This allows locking or unlocking of the doors and the tailgate. / if the vehicle is deadlocked,
button does not function. In this
case use the remote control for unlocking.
=(

=
( With the engine running, an audible signal and a diagram locating thedoor briefly displayed on the multi-function display warn you that a dooris not properly closed. In addition, if the vehicle is moving, the courtesy lights flash. 
&
+. This prevents either of the rear doors being opened from inside. 
Turn the switch a quarter of a
turn using the ignition key.

!"
#

 $!A

7
'
+ &
 

+(
+-
*

&

((
+-
*

B( -
CFront fog lamps (first rota-tion of the ring forwards)
The front fog lamps operate with theside lights and the dipped headlamps. When the main beam headlamps are switched on, the front fog lamps
are switched off. They are switchedon again when the main beam head-
lamps are switched off. Front and rear foglamps (2nd rotation ofthe ring forwards).
/ to switch off the rear fog lamp
and the front fog lamps, turn the ringbackwards twice in succession. / when the lights are switched
off automatically or when the dipped
headlamps are switched off manual-
ly, the front fog lamps, the rear foglamp and the side lights will remainon (turn the ring backwards to switch
off the front fog lamps. The side
lights will then be switched off).
3
3
4
(
&
((
 -
 Selection is by turning ring .
Lights off Side lights Dipped/main beam headlamps Automatic switching on of lights 

&@ 
*
'
- Pull the stalk towards you. /

with the ignition off, when the
driver's door is opened, a buzzer sounds if you have left your lights on.
(
+-
*

&
((
+- *
Rotate the ring forwards to switch on
and backwards to switch off. The sta-tus is confirmed by the indicator lighton the instrument panel.
7
'
+ &
 


((
+-
*

B( -
8C
Rear fog lamp
This only operates with the dipped/main beam headlamps. / when the lights are switched off
automatically, the rear fog lamp and the dipped headlamps will remain on (turn
the ring backwards to switch off the
rear fog lamp. The dipped headlampsand side lights will then be switched
off).

!"
#


$$%
29-09-2003


-#"
./


 
1
Do not cover the rain sen- sor located on the wind-screen behind the interior
mirror.
When using an automatic carwash, switch off the ignition orcheck that the wiper stalk is not inthe automatic position.
In winter, it is advisable to wait for the windscreen to completelyclear of ice before operating theautomatic wipe.  


)$
 






"







 
 

  )$









".


 "
 




 "







-



! 







"#
 
!



"





$

" 
 




2
*
$

 $ (( 
# %
) + 
/


$"


"

!

   
3! 
%
+3 





$
$"



  %


+
$
 ($! !





'

$'
 




  
3!

$ !(3



$
$"






"#
 
!



"














,
"


+0120) 







""&