jump cable Peugeot 308 2016 Owner's Manual

273
308_en_Chap08_en-cas-de-panne_ed02-2015
Starting using another battery
First check that the slave battery has a
nominal voltage of 12 V and a capacity
at least equal to that of the discharged
battery.
Do not try to start the engine by
connecting a battery charger.
Do not disconnect the (+) terminal when
the engine is running.
F
Re

move the plastic cover from
the
(

+)
t
erminal, if your vehicle has one.
F
Co

nnect the red cable to the positive
terminal (+) of the flat battery A , then to the
positive terminal (+) of the slave battery B.
F
Co

nnect one end of the green or black
cable to the negative terminal (-) of the
slave battery B (or earth point on the other
vehicle).
F
Co

nnect the other end of the green or black
cable to the earth point C on the broken
down vehicle (or on the engine mounting).
F
St

art the engine of the vehicle with the
good battery and leave it running for a
few
m

inutes. F
Op

erate the starter on the broken down
vehicle and let the engine run
If t

he engine does not start straight
away, switch off the ignition and wait a
few
m

oments before trying again.
F
Wa

it until the engine returns to idle then
disconnect the jump lead cables in the
reverse order.
F
Re

fit the plastic cover to the (+) terminal, if
your vehicle has one.
When your vehicle's battery is discharged, the
engine can be started using a slave battery
(external or on another vehicle) and jump lead
cables.Before disconnecting the battery
Wait 2 minutes after switching off the ignition
before disconnecting the battery.
Close the windows and the doors before
disconnecting the battery.
Following reconnection of the
battery
Following reconnection of the battery, switch on
the ignition and wait 1 minute before starting to
permit initialisation of the electronic systems.
However, if problems remain following this
operation, contact a P
eu

ge
Ot d
ealer or a
qualified workshop.
Referring to the corresponding section, you
must yourself reinitialise (depending on
version):
-
th

e remote control key,
-
th

e electric blind(s),
-
... S

ome functions are not available if the
battery is not sufficiently charged.
8
In the event of a breakdown