light Peugeot 406 Break Dag 2003 Owner's Guide

17-02-2003
The control unit This is located in the boot on the right hand side. In the estate, open the panel to access it. 1. CD ROM eject button.
2. CD ROM compartment.
3. The ON indicator light indicates that the control unit is
supplied with power.
4. The CD indicator light indicates that there is a CDROM in the control unit.The last voice message recall control
Pressing the button briefly on the end of the lightsstalk repeats the last voicemessage.
The CD Rom This contains all the mappingdata. It must be inserted with the printed face upwards.
Use only CD Roms approved by PEUGEOT. The satellite navigation system is active once the globe appears in bold.
YOUR 406 IN DETAIL 95
The use of copied CDs can cause malfunctions.

17-02-2003
Press the switch. The indicator light comes on when the air conditioningstarts.
1 - Air conditioning control
The air conditioning is intended to operate in all seasons. In summer itallows the temperature to be reduced
and in winter, above 0 ¡C, it increases
the effectiveness of the demisting.
2 - Temperature adjustment
To be adjusted according to your requirements: from blue (cold whenthe air conditioning is on) to red(hot).
AIR CONDITIONING
YOUR 406 IN DETAIL
56
Please note that for optimum operation of the air condition-ing, the recommended air flowsetting is with knob 4 turned toits second position.

17-02-2003
3 - Setting the air distribution
Windscreen and side windows (de-icing/demisting).
To quickly de-ice or demist the wind- screen and the side windows:
Ð set the temperature and air flow controls to maximum,
Ð close the central vents,
Ð press the A/C button.
Windscreen and side win- dows, central and side ventsand footwells. Central and side vents and footwells.
These settings are recommended forcold climates.
Central and side vents. This setting is recommend-
ed for hot climates. 4 - Air flow adjustment
Turn the knob to obtain sufficient
flow.
5 - Air intake control
Recirculation of the interior air (indi-cator light on). This position prevents the entry of unpleasant odours or fumes fromoutside and increases the speed ofheating. Used simultaneously with the air conditioning, recirculation improvesthe performance of the system whenset to hot as well as to cold. Used in humid conditions, recircula- tion risks misting up the windows. As soon as possible, place the con- trol in the outside air position. 6 - Demisting the rear
screen
With the engine running, pressingthe switch demists the rear screenand the mirrors.
It switches off automatically after approximately fifteen minutes. Press again to resume demisting.It is possible to stop the demisting
operation before it goes off automat-
ically, by pressing the switch again. Important precaution Operate the air conditioning for 5 to 10 minutes, once or twice a month,
to keep it in good working order. If the system does not produce cold
air, do not use it and contact your
PEUGEOT dealer. Note: The condensation created by
the air conditioning causes a normal flow of water under the vehicle when
stationary.
YOUR 406 IN DETAIL 57

17-02-2003
SEAT BELTS
To adjust the height of the front seat belts Pinch control 1and slide it.
To lock the seat beltsPull the strap, then insert the buckle into the stalk. Pre-tensioning and force-limitingfront seat belts Safety in the event of a frontal impact has been improved by the introduc-tion of pre-tensioning and force-limit-ing front seat belts. Depending onthe seriousness of the impact, thepre-tensioning system instantly tight-ens the seat belt firmly against thebody of the occupant. The pre-tensioning seat belts are active when the ignition is on. The force-limiting device reduces the pressure of the seat belt against theoccupant's body in the event of anaccident. Rear seat belts The three rear seats are all fitted with three-point inertia reel belts.
YOUR 406 IN DETAIL
123
To be effective, a seat belt must be tightened asclose to the body as pos-sible.
Depending on the nature and theseriousness of the impact, thepre-tensioners may be triggeredbefore and independently of theair bags. In all cases, the air bag warning light comes on. Following a collision, have the system checked by a PEUGEOT
dealer. The system has been designed to be fully operational for ten years. Have it replaced after this period.

17-02-2003
THE KEYS The keys allow you to switch on the ignition and to independently operate
the locks on the front door, the glovebox and the passenger air bag dis-arming switch. Central locking
From the driver's door, the keys allow you to lock and unlock thedoors and boot/tailgate. If one of the front or rear doors is open, the central locking does notwork. The remote control performs the same functions at a distance. The remote control LockingPress button Ato lock the vehicle.
YOUR 406 IN DETAIL 103
This is confirmed by fixed lighting of the direction indicators for approxi-mately two seconds. Unlocking Press button
B to unlock the vehicle.
This is confirmed by rapid flashing of the direction indicators. Note: do not repeatedly press the
button of your remote control out of
range of your vehicle. You risk caus-ing it not to work and the remote con-trol would have to be reprogrammed. ELECTRONIC ENGINE IMMOBILISER This locks the engine management system as soon as the ignition has
been switched off and therefore pre-vents starting of the vehicle by any-
one who does not have the key. The ignition key has an electronic chip which has a special code. Whenthe ignition is switched on, the code isrecognised and starting is possible. If the system does not function cor-
rectly, you are warned by an audiblesignal and a message on the multi-
function display. In this case, the vehicle will not start.
Contact a PEUGEOT dealer as soon as possible.
Locating your vehicle
To locate your vehicle, if you have locked it, in a car park: 
press button A. The courtesy
lights come on and the direction indicators flash for a few seconds.
Key in ignition
A buzzer sounds on opening the dri-
ver's door, if the key has been left inthe ignition.

17-02-2003
THE KEYS The keys allow you to switch on the ignition and to independently operate
the locks on the front door, the glovebox and the passenger air bag dis-arming switch. Central locking
From the driver's door, the keys allow you to lock and unlock thedoors and boot/tailgate. If one of the front or rear doors is open, the central locking does notwork. The remote control performs the same functions at a distance. The remote control LockingPress button Ato lock the vehicle.
YOUR 406 IN DETAIL 103
This is confirmed by fixed lighting of the direction indicators for approxi-mately two seconds. Unlocking Press button
B to unlock the vehicle.
This is confirmed by rapid flashing of the direction indicators. Note: do not repeatedly press the
button of your remote control out of
range of your vehicle. You risk caus-ing it not to work and the remote con-trol would have to be reprogrammed. ELECTRONIC ENGINE IMMOBILISER This locks the engine management system as soon as the ignition has
been switched off and therefore pre-vents starting of the vehicle by any-
one who does not have the key. The ignition key has an electronic chip which has a special code. Whenthe ignition is switched on, the code isrecognised and starting is possible. If the system does not function cor-
rectly, you are warned by an audiblesignal and a message on the multi-
function display. In this case, the vehicle will not start.
Contact a PEUGEOT dealer as soon as possible.
Locating your vehicle
To locate your vehicle, if you have locked it, in a car park: 
press button A. The courtesy
lights come on and the direction indicators flash for a few seconds.
Key in ignition
A buzzer sounds on opening the dri-
ver's door, if the key has been left inthe ignition.

17-02-2003
THE ALARM SYSTEM*
This offers two types of protection: ¥external , it sounds if a door, the
bonnet or the boot is opened.
¥ internal , it sounds if there is air
movement in the passenger compartment (a broken windowor movement inside the vehicle) .
Note: it also has an anti-tamper
function; if there is an attempt to tam-per with the wires to the siren, the
control unit or the battery, the sirensounds and the direction indicatorslight. Setting
Switch the ignition off and get out of the vehicle. Set the alarm within five minutes fol- lowing your exit from the vehicle bylocking using the remote control (thered light on the switch, visible fromthe outside, flashes every secondand the direction indicators come onpermanently for two seconds).
5 seconds later, internal protection is set.
45 seconds later, external protection is set. When the alarm is triggered, the siren sounds for thirty seconds. After it has been triggered, the alarm is operational again. Note:
if you wish to lock your vehi-
cle without setting the alarm, lock it using the lock.
Warning
When the alarm is triggered, if a door, the boot or the bonnet are not closed
correctly, the siren sounds for amoment. Close the vehicle correctlyto set the alarm. Disarming Unlock the vehicle using the remote
control key. (the direction indicatorsflash for two seconds and the redlight on the switch goes out). Note:
if the red warning light flashes,
it is a sign that the alarm has been triggered during your absence.
To stop it, switch on the ignition.Note: when the alarm is set, but the
remote control no longer works:
¥ unlock the doors using the key and open the door; the alarm is trig- gered;
¥ switch the ignition on within ten seconds;
¥ press the internal protection button 1 immediately. The alarm is dis-
armed.
* According to destination.
YOUR 406 IN DETAIL
106

17-02-2003
To disarm external type protection only
¥ see "Disarming" section. Note:if you wish to charge or replace
the battery:
¥ Turn on the ignition.
¥ You have 10 seconds after turning on the ignition to press the internal protection switch 1and hold it
down for two seconds.
¥ The warning light flashes rapidly for three seconds.
¥ Disconnect the battery.
¥ After reconnecting the battery, lock, then unlock the vehicle using the remote control.
YOUR 406 IN DETAIL 107
To set the alarm to external protection only If you want to leave a window partially open, or a pet inside thevehicle, you need to select externalprotection only:
¥ Switch off the ignition.
¥ Within the next ten seconds, press the internal protection button 1.
¥ Get out of the vehicle.
¥ Press the locking button on the remote control.
¥ The doors lock.
¥ The direction indicators light for two seconds.
¥ The red light on the switch flashes once a second.
Do not make any modifi- cations to the alarm sys-tem, this could causefaults.

17-02-2003
PETROL/LPG TWIN FUEL VERSION
168
Filling the LPG tank
(Capacity, approximately 46 litres)
Ð switch off the ignition,
Ð unscrew the cap protecting thefiller opening,
Ð lock the filler nozzle onto the opening (if necessary, screw the appropriate adapter*, located inthe insulated compartment, ontothe filler opening first),
Ð push the button on the pump,
Ð once filling has stopped automati- cally, unlock the filler nozzle,
Ð screw the protective cap back onto the filler opening.
* According to destination. Petrol gauge When the low petrol level indicator comes on, fill the tank without delayas the engine can only start usingpetrol. Furthermore, a low petrollevel may result in fuel circuit faults.
Gas gauge If the outside temperature is high, the gas level indicated by the fuelgauge may be slightly higher thanthe actual level. Safety advice The safety valve must be closed before any main-
tenance or repair work is carried
out on your vehicle. To close it,switch off the ignition. Ensure that there is no risk that the loads carried may damagethe tank.
Testing the tank Decree of 18/01/43 and applica-
tion of article 3 of the A.M. of
24/11/82. The maximum interval between successive tests is eight years.
However, the test must be repeat-ed whenever the vehicle is sold, ifthis sale takes place more than 5 years following the last test. It is imperative that any work on the LPG feed system is carried
out by a PEUGEOT dealer.

17-02-2003
Front fog lamps and rear fog lamp (2nd for-wards turn of the ring)
Note: to switch off the rear fog lamp
and the front fog lamps, turn the ringtwice backwards.
Direction indicators(flashers) Left:downwards.
Right: upwards.
THE LIGHTS STALK Front and rear lightsSelection is by turning ring A.
Lights off Side lights on Dipped/main beam headlamps Automatic switching on of lights Dipped/Main beam change Pull the stalk towards you.Note:
with the ignition off, if the dri-
ver's door is open, a buzzer sounds if you have left your lights on. Front fog lamps and rear fog lamp Rotate the ring Bforwards to switch
on and backwards to switch off. The status is confirmed by the light on theinstrument panel.
Front fog lamps (1st for-wards turn of the ring)
YOUR 406 IN DETAIL
124
In good or rainy weather, both day and night, thefront fog lamps and therear fog lamp are daz-
zling and are prohibited.Do not forget to switch them offwhen they are no longer need-ed.