driver seat adjustment Peugeot 406 C 2003 Owner's Manual

24-03-2003
12 -Windscreen wash-wipe stalk. Trip computer stalk.
13 - Radio remote control stalk.
14 - Steering lock and ignition.
15 - Electric mirror controls.Window controls.
16 - Electronic stability control switch (ASR/ESP).
17 - Headlamp height adjustment.
18 - Fuse box.
19 - Steering wheel adjustment.
20 - Cruise control.
21 - Rear ashtray. 22 -
Cup-holder.
23 - Handbrake.
24 - Heated seat switches. Coin storage.Passenger airbag disarming switch. Alarm button.
25 - Lighter.
26 - Rear footwell heating vent.
27 - Front ashtray.
28 - Gear lever.
29 - Radio.
30 - Heating/ventilation controls.
31 - Multifunction display.
YOUR 406 COUPE AT A GLANCE
3
1 - Speaker (tweeter) location.
2 - Window demisting vent.
3 - Side adjustable heating/ ventilation vents and air flowregulation.
4 - Glove box.
5 - Passenger airbag.
6 - Windscreen demistingvents.
7 - Central adjustable heating/ventilation vents and air flowregulation.
8 - Hazard warning lightsswitch.
9 - Lights and direction indicators stalk.
10 - Instrument dials.
11 - Driver's airbag. Horn.

24-03-2003
6 - Head restraint height andangle adjustment Adjustment is correct when the top of the head restraint is levelwith the top of the head.
To raise the head restraint, pull it
upwards.
To lower the head restraint, it is
necessary to push simultaneously:
Ð the button located on the left guide on top of the seat back,
Ð the head restraint downwards. The head restraint has a frame with notches which prevent itfrom dropping down (safetydevice in case of impact).
To remove the head restraint,
press the tab. 7 - Lumbar adjustment
To obtain better back support,
turn the knob.
Passenger seat
To gain access to the rear seats,
there are two ways to tilt the seat back:
Ð pull the handle at the top right of the seat, or
Ð lift the handle at the bottom left of the seat.
93
YOUR 406 COUPE IN DETAIL
SEATS Manual adjustment of the front seats
1 - Forwards-backwards adjust- ment Lift the lever and slide the seat forwards or backwards.
2 - Adjusting the seat cushion angle Lift the lever to set the best angle.
3 - Adjusting the driver's seat height Pull the telescopic handle for- wards and pivot it up or down.
4 - Adjusting the seat back angle Turn the knob to obtain the best
angle.
5 - Tilting the seat back To gain access to the rear seats,
pull the handle, tilt the seat backas much as possible, and movethe seat forwards. On reposition-ing, the seat will resume its origi-nal settings.
Note: never reposition the seat
using the forwards-backwards adjustment control.
Never drive with the head restraints removed; theymust be in place and cor-rectly adjusted.

Electrical adjustment of the front seats
A- Forwards-backwards adjustment Push the switch forwards or backwards to slide the seat.
B - Adjusting the seat cushion angle Tilt the front part of the switch up or down.
C - Adjusting the driver's seat height Push the switch up or down.
D - Seat back angle adjustment Tilt the switch forwards or backwards
E - Tilting the seat back Pull the lever and tilt the seat back forwards. As long as you hold the seat back in the tilted position, the seat moves forward automatically (when the dooris closed, the ignition must be switched on in order tomove the seat forwards). On repositioning, the seat resumes its original settings.
YOUR 406 COUPE IN DETAIL
94
24-03-2003

24-03-2003
HORN Press one of the spokes or the centre of the steeringwheel.
Headlamp adjustment Depending on the load in your vehi- cle, adjusting the beam of the head-lamps is recommended as follows.0. - 1 or 2 people in the front seats.
–- 3 people.
1. - 4 people.
2. - 4 people + maximum authorised load.
3. - Driver + maximum authorised load.
Initial setting is position 0. HAZARD WARNING LIGHTS Press the button, the direction indi- cators flash. They can operate with the ignition
off.
STEERING WHEEL HEIGHT
AND DEPTH ADJUSTMENT
When the vehicle is stationary, unlock the steering wheel by pullinghandle
A.
Adjust the height and depth of thesteering wheel, then lock it by push-ing handle Adown fully.
YOUR 406 COUPE IN DETAIL 121
Automatic lighting of hazard warning lights*
When braking in an emergency, depending on the force of decelera-tion, the hazard warning lights come
on automatically. They switch offautomatically the first time you accel-erate.
It is also possible to switch them off by pressing the button.
* According to destination.