fuel pump Peugeot 407 2009 Owner's Manual

9CHECKS
111
CHECKS
At the start of winter, have
your battery checked by a
PEUGEOT dealer.
Have the fi lter elements
replaced regularly. If you drive
in dusty conditions, change
them twice as often.
Air filter and passenger compartment filter
Particle emission filter (Diesel)
It is imperative that the particle emis-
sion fi lter is maintained in accordance
with the manufacturer’s servicing
schedule, by a PEUGEOT dealer.

Note: following prolonged operation of
the vehicle at very low speed or at idle,
you may, in exceptional circumstances,
notice emissions of water vapour at the
exhaust on acceleration. This does not
have any effect on the performance of
the vehicle or the environment.
On vehicles which are fi tted with a
particle emission fi lter, the fan as-
sembly may operate after the vehicle
has stopped, even when the engine is
cold. Where the handbrake travel is
too great or there is a reduc-
tion in the performance of the
system, the handbrake should
be adjusted.
Have the system checked by a
PEUGEOT dealer.
Handbrake
Disc wear status
For any information relating to checking
disc wear, contact a PEUGEOT dealer.
FUEL SUPPLY CUT-OFF
(PETROL) *
As a safety precaution, in certain circum-stances, a mechanism prevents fuel from reaching the engine. To re-establish the fuel supply:
RUNNING OUT OF FUEL (DIESEL)
If you should run out of fuel, it is neces-
sary to re-prime the circuit.
The repriming pump and the degas
screw are located under the bonnet
(see corresponding illustration in the
technical data section):
1.6 litre 16V HDI engine
- fi ll the fuel tank with at least fi ve
litres of diesel,
- squeeze and release the manual re-priming pump, until fuel appears
in the transparent pipe,
- operate the starter until the engine starts.
2 litre 16V HDI engine
- fi ll the fuel tank with at least fi ve litres of diesel,
- unscrew the degas screw,
- squeeze and release the manual repriming pump until diesel is seen
escaping via the degas screw,
- retighten the degas screw,
- operate the starter until the engine starts.
Brake pad wear depends on
the style of driving, in particu-
lar for vehicles which are used
in town, over short distances.
Brake pads It may be necessary to check
the thickness of the pads,
even between services.
* According to version.
To ensure the best perfor-
mance from components as
important as the power steer-
ing and the braking system, the
manufacturer selects and offers specifi c
products, only use products recom-
mended by PEUGEOT .
Battery
To prevent damage to the electrical units,
high pressure washing of the engine
compartment is strictly prohibited .
 press the red button on the angle of the front right-hand suspension assembly, under the bonnet.

1010PRACTICAL INFORMATION
Engine compartment fuses
To access the fuses located in the
engine compartment (next to the bat-
tery), remove the battery cover and
unclip the fuse box cover.
Close the fuse box cover carefully and
refi t the battery cover when you have
fi nished.
Fuse N°
Rating

A
Functions

1 20 Engine management control unit.

2 15 Horn.

3 10 Front and rear wash-wipe.

4 20 Headlamp wash.

5 15 Engine management actuators (fuel pump,
purge canister solenoid valves, ...).

6 10 Automatic gearbox control unit.

7 10 Switching and protection unit, intake air
fl ow sensor, clutch switch, six-speed
automatic gearbox switch, STOP switches,
electrochromatic mirror, panoramic roof
concealing fl ap controls (407 SW).

8 20 Starter coil.

9 10 Xenon bulb electronic supply, STOP switch,
power steering electropump assembly,
four-speed automatic gearbox control unit,
automatic gearbox locking relay.

10 30 Engine management actuators (ignition coil,
solenoid valves, oxygen sensors).

11 40 Air conditioning blower or not used.

12 30 Windscreen wipers.

13 40 Built-in systems interface supply
(ignition positive).

14 30 Air pump.