clutch Peugeot 407 C Dag 2008 Owner's Manual

8
96
CRUISE CONTROL/SPEED LIMITER
Selecting the function

 Place switch 1 in the CRUISE po-
sition. The cruise control is not
yet active and no speed has been
memorised. The display indicates:
Switching the function off

 Place switch 1 in position 0 or

LIMIT to switch the system off.
Note: It is possible to acce-
lerate and drive momentarily
at a speed greater than the
memorised speed. The value
memorised fl ashes. When the acceler-
ator pedal is released, the vehicle will
return to the memorised speed.
Cancelling the memorised speed
If you wish to cancel the memorised
speed:

 Press button 4 or the brake or
clutch pedal. The display indicates
(e.g. at 70 mph (110 km/h)):
Activation/memorising a speed
As soon as you reach the chosen
speed, press button 2 or 3 . This
memorises the speed, which will be
maintained automatically. The display
indicates (e.g. at 70 mph (110 km/h)): On a steep descent, the cruise
control, which does not act on
the brakes, is not able to pre-
vent the vehicle from excee-
ding the programmed speed.
In no circumstances does the cruise control
replace the requirement to respect speed
limits, nor does it replace the need for vigi-
lance and responsibility on the part of the
driver.
We recommend that your feet remain
near the pedals.
Cruise control function
This enables the vehicle to maintain
a steady speed programmed by the
driver
In order for it to be memorised, the
vehicle speed must be greater than
25 mph (40 km/h) with at least fourth
gear engaged (second gear for the
automatic gearbox), with the engine
running .

1010
117
The electrical system of your
vehicle is designed to operate
with standard or optional equip-
ment.
Before installing other electrical equip-
ment or accessories on your vehicle,
contact a PEUGEOT dealer. PEUGEOT will not accept responsi-
bility for the cost incurred in repairing
your vehicle or for rectifying the mal-
functions resulting from the installation
of accessories not supplied and not
recommended by PEUGEOT and not
installed in accordance with its instruc-
tions, in particular where the equip-
ment in question consumes more than
10 milliamperes. The maxi-fuses provide additional
protection for the electrical systems.
All work must be carried out by a
PEUGEOT dealer.
Fuse N° Rating
Functions
9 10 A Directional headlamps control unit, additional heat
ing switching and protection control unit, clutch
switch.
10 30 A A Engine management actuators (ignition coil, injec
tors, thermostats, solenoid valves, oxygen
sensors), diesel additive pump, fuel pump, engine c ontrol unit, Blow-by heater.
11 40 A Air conditioning blower.
.
12 30 A Windscreen wipers..
13 40 ABuilt-in systems interface supply (ignition positiv e).
14 30 A Not used.
.