ABS Peugeot 407 Dag 2010 User Guide

1010PRACTICAL INFORMATION
117
Integrated direction indicator side
repeaters CHANGING A REAR BULB (SALOON)
Third brake light:
Five W 5 W bulbs.

 Remove the plastic cover carefully
by unclipping it at the centre and
on either side, perpendicular to its
direction of engagement.

 Press on the two tabs located at
the rear, near the rear screen.

 Pull the red transparent cover out-
wards while maintaining the pressure
on the tabs.

 Change the faulty bulb.

 When refi tting, ensure that the
tabs of the red transparent cover
are engaged correctly and that the
upper trim has been put back in
place correctly.

 Refi t the lamp fi xing nuts inside
the boot using the towing eye, if
necessary. When refi tting, ensure
that the lamp unit is positioned and
fi xed correctly.

 Reconnect the electrical connector.

Number plate lamps : W5W.

 Remove the transparent cover us-
ing a screwdriver blade.

 Change the faulty bulb.

 Push the repeater forwards or
backwards and release it.

 Unclip the repeater and change it.
Repeaters can be obtained from
PEUGEOT dealers.
Amber coloured bulbs (direction indi-
cators and side repeaters), must be
replaced with bulbs of identical speci-
fi cation and colour.
1. Direction indicators :
PY21W (amber).

2. Reversing lamps : P21W.

3. Foglamps/sidelamps :
P21/4W.

4. Sidelamps : P21/4W.

5. Brake lamps/sidelamps : P21/4W.

 Disconnect the electrical connector.

 Unscrew the lamp fi xing nuts in-
side the boot using the towing eye
(stored inside the spare wheel), if
necessary.

 Remove the seal.

 Unclip the bulb holder moving
aside the 5 tabs.

 Unscrew the bulb and change it.

 Refi t the bulb holder.

 Reposition the seal.

1010PRACTICAL INFORMATION
118
CHANGING A REAR BULB (407SW)
Left and right foglamps: P21W.

 Carefully unclip the tailgate interior
trim.

 Detach the sealing fi lm located be-
hind the lamp in question.

 Remove the bulb holder turning it a
quarter of a turn.

 Change the faulty bulb.
When refi tting, ensure that the bulb is
positioned correctly in the bulb holder.

 Unclip the lamp (2 clips).

 Disconnect the connector and re-
move the lamp.

 Unclip the bulb holder moving
aside the 4 tabs.

 Unscrew the bulb and change it.

 Reconnect the connector.

 Refi t the bulb holder. When refi tting
it, ensure that the lamp is correctly
positioned and secured, reclipping
the rear part then the front part.

Number plate lamps: W5W.

 Insert a thin screwdriver in one of
the exterior holes of the transpar-
ent cover.

 Push it towards the outside to unclip
it.

 Remove the transparent cover.

 Change the faulty bulb. Third brake lamp (diodes)
All work on the diode lamps must be
carried out by a PEUGEOT dealer.
Wing lamps

1. Brake lamps/sidelamps: P21/5W.

2. Reversing lamps: P21W.

3. Direction indicators: P21W.
These three bulbs are changed by re-
moving the lamp.

 Remove the corresponding boot
side fl ap to gain access to the
lamp.

 Remove the lamp fi xing nut inside
the boot.
Note: if necessary, use the wheelbrace
to remove the nuts. In some climatic conditions
(e.g. low temperature or hu-
midity), the presence of misting
on the internal surface of the
glass of the headlamps and rear lamps
is normal; it disappears after the lamps
have been on for a few minutes.

1010PRACTICAL INFORMATION
125
Without lifting (4 wheels on
the ground)
You must always use a towing bar.
The removable towing eye is inside
the spare wheel.
At the front and at the rear:

 Unclip the cover,

 Screw in the towing eye as far as it
will go. Special requirements with an
automatic gearbox
When towing with the engine switched
off, there is no braking or steering as-
sistance.
Failure to observe this special require-
ment may lead to the destruction of
certain braking units and the absence
of braking assistance when the engine
is re-started.
TOWING YOUR VEHICLE
Lifting (2 wheels only on
the ground)
It is preferable to raise the vehicle with
a professional lifting device.
Place the gear lever in neutral
(position N in the case of the
automatic gearbox).
Towing a vehicle with an auto-
matic gearbox in reverse gear
is prohibited (no lubrication). When towing with four wheels on the
ground, the following rules must be
observed:
- lever in position
N ,
- tow the vehicle at less than 30 mph (50 km/h) over a maximum dis-
tance of 30 miles (50 km).
- do not add oil to the gearbox.

181
QUESTION SOLUTION ANSWER
The environment (hills, buildings, tunnels, basement car parks...) block reception, including in RDS mode.
The aerial is absent or has been damaged (for exam ple when going through a car wash or into an underground car park).
This phenomenon is normal and does not indicate a failure of the audio equipment.
Have the aerial checked by a PEUGEOT dealer.
Sound cut-outs of 1 to 2 seconds in radio mode.
During this brief sound cut-out, the RDS searches for any frequency permitting better reception of the station. Deactivate the RDS function if the phenomenon is too frequent and always on the same route.
With the engine off, the audio equipment switches off after a few minutes of use.
When the engine is switched off, the audio equipme nt operating time depends on the battery charge.
The switch-off is normal: the audio equipment switches to economy mode and switches off to prevent discharging of the vehicle's battery.
The stored stations do not function (no sound, 87.5 Mhz is displayed...) .
An incorrect waveband is selected. Press the BAND AST button to return to the waveband (AM, FM1, FM2, FMAST) on which the stations are stored.
Start the vehicle's engine to increase the battery charge.
The quality of reception of the radio station listened to gradually deteriorates or the stored stations do not function (no sound, 87.5 Mhz is displayed...).
The vehicle is too far from the transmitter used by the station listened to or there is no transmitter in the geographical area th rough which the vehicle is travelling.
Activate the RDS function to enable the system to check whether there is a more powerful transmitter in the geographical area.