indicator Peugeot 508 2011 Service Manual
[x] Cancel search | Manufacturer: PEUGEOT, Model Year: 2011, Model line: 508, Model: Peugeot 508 2011Pages: 340, PDF Size: 25.72 MB
Page 132 of 340
130
Visibility
Model without AUTO lighting
Model with AUTO lighting
Selection ring for main lighting
mode
Turn the ring to position the symbol required
facing the mark.
Lighting off.
Automatic illumination of headlamps.
Sidelamps only.
Dipped or main beam headlamps.
Stalk for switching headlamps
Pull the stalk to switch the lighting between
dipped/main beam headlamps.
In the lighting off and sidelamps modes, the
driver can switch on the main beam headlamps
temporarily ("headlamp flash") by maintaining a
pull on the stalk.
Displays
Illumination of the corresponding indicator lamp
in the instrument panel confirms the lighting
switched on.
Page 135 of 340
5
133
Visibility
Parking lamps
Side markers for the vehicle by illumination of
the sidelamps on the traffic side only.
)
Within one minute of switching off the
ignition, operate the lighting control stalk up
or down depending on the traffic side (for
example: when parking on the left; lighting
control stalk upwards; the right hand
sidelamps are on).
This is confirmed by an audible signal and
illumination of the corresponding direction
indicator warning lamp in the instrument panel.
To switch off the parking lamps, return the
lighting control stalk to position 0 or switch on
the ignition. Temporarily keeping the dipped beam
headlamps on after the vehicle's ignition has
been switched off makes the driver's exit easier
when the light is poor.
Manual guide-me-home
lighting
Switching on
)
Within 30 seconds or a minute after
switching of the ignition (according to the
automatic guide-me-home lighting duration
programmed in the configuration menu),
"flash" the headlamps using the lighting
stalk.
)
A fur ther "headlamp flash" switches the
function off.
Switching off
The manual guide-me-home lighting switches
off automatically after a set time.
Page 141 of 340
5
139
Visibility
Additional directional lighting
With dipped or main beams, this function
makes use of the beam from a front foglamp
to illuminate the inside of a bend, when the
vehicle speed is below 25 mph (approximately
40 km/h).
This additional lighting is particularly useful in
town, at intersections, on very winding roads,
when parking, ...
with additional directional lighting
without additional directional lighting
Switching on
This function starts
- when the direction indicator is switched on
(the foglamp on the same side is switched on),
or
- from a cer tain angle of rotation of the
steering wheel.
Switching off
The system is deactivated:
- below a cer tain angle of rotation of the
steering wheel,
- when switching off the direction indicator,
Programming
The system is activated or
deactivated in the instrument panel
screen configuration menu.
The system is activated by default.
Page 158 of 340
156
!
!
Child safety
Electric child lock
Remote control system to prevent opening of the rear doors using their interior controls and use of the rear electric windows.
Switching on
)
With the ignition on, press button A
.
The indicator lamp on button A
comes on,
accompanied by a message to confirm that the
child lock is on.
This indicator lamp remains on until the child
lock is switched off.
It is still possible to open the doors from the
outside and operate the rear electric windows
from the driver's control panel.
Switching off
)
With the ignition on, press button A
again.
The indicator lamp on button A
goes off,
accompanied by a message to confirm that the
child lock is off.
This indicator lamp remains off while the child
lock is switched off.
Any other status of the indicator lamp
indicates a fault with the electric child
lock.
Have it checked by a PEUGEOT dealer
or a qualified workshop.
This system is independent and in no
circumstances does it take the place of
the central locking control.
Check the status of the child lock each
time you switch on the ignition.
Always remove the key from the ignition
when leaving the vehicle, even for a
shor t time.
In the event of a serious impact, the
electric child lock is switched off
automatically to permit the exit of the
rear passengers.
Page 159 of 340
7
157
i
Safety
Direction indicators
)
Lower the lighting control stalk fully when
moving to the left.
)
Raise the lighting control stalk fully when
moving to the right.
"Motorway" function
Move the stalk briefly upwards or downwards,
without going beyond the point of resistance;
the corresponding direction indicators will flash
3 times.
If you forget to cancel the direction
indicators for more than twenty
seconds, the volume of the audible
signal will increase if the speed is above
40 mph (60 km/h).
Hazard warning lamps
Press the button, the direction indicators flash.
They can operate with the ignition off.
Automatic operation of
hazard warning lamps
When braking in an emergency, depending on
the rate of deceleration, as well as when the
ABS regulation is invoked or in the event of an
impact, the hazard warning lamps come on
automatically.
They switch off automatically the first time you
accelerate.
)
You can also switch them off by pressing
the button.
Page 164 of 340
162
!
Safety
Dynamic stability control (DSC)
Activation
This system is activated automatically each
time the vehicle is star ted.
It comes into operation in the event of a grip or
trajectory problem.
This is indicated by flashing of this
warning lamp in the instrument panel.
Deactivation
In exceptional conditions (starting a vehicle
which is bogged down, stuck in snow, on soft
ground...), it may be advisable to deactivate
the DSC system, so that the wheels can move
freely and regain grip. The DSC system offers exceptional
safety in normal driving, but this should
not encourage the driver to take extra
risks or drive at high speed.
The correct operation of the system
depends on obser vation of the
manufacturer's recommendations
regarding the wheels (tyres and rims),
the braking components, the electronic
components and the PEUGEOT
assembly and operation procedures.
After an impact, have the system
checked by a PEUGEOT dealer
or a qualified workshop.
Operating fault
If this warning lamp comes on,
accompanied by an audible signal
and a message in the instrument
panel screen, this indicates a fault
with the system.
Contact a PEUGEOT dealer or a qualified
workshop to have the system checked.
Reactivation
The system is reactivated automatically each
time the ignition is switched back on or from
30 mph (50 km/h).
)
Press the "ESP OFF"
button again to
reactivate it manually.
)
Press the "ESP OFF"
button.
This warning lamp and the indicator
lamp in the button come on: the
DSC system no longer acts on the
operation of the engine.
Page 185 of 340
8
183
i
Practical information
Changing a bulb
Front lamps
Model with xenon and directional
headlamps
1.
Daytime running lamps/sidelamps
(light emitting diodes - LEDs).
2.
Directional dipped/main beam
headlamps (D1S-35W).
3.
Direction indicators (PY21-21W).
4.
Foglamps (directional according to
version) (H8).
Model with halogen headlamps
1.
Dipped and main beam headlamps
(H7-55W).
2.
Sidelamps (W5-5W).
3.
Main beam headlamps (H7-55W).
4.
Daytime running lamps (SP13-13W).
5.
Foglamps (directional according to
version) (H8).
6.
Direction indicators (PY21-21W).
For H7 type bulbs with lugs... take care to
obser ve their correct installation so as to
ensure the best lighting per formance.
In some weather conditions (e.g. low
temperature or humidity), the presence
of misting on the internal sur face of the
glass of the headlamps and rear lamps
is normal; it disappears after the lamps
have been on for a few minutes.
Page 189 of 340
8
187
Practical information
Direction indicators
)
Lie down under the vehicle.
)
Remove the screws securing the
underbody shield.
)
Remove the underbody shield.
)
Turn the bulb holder a quar ter turn and pull
it out.
)
Replace the faulty bulb.
For reassembly, carry out these operations in
reverse order.
You can also contact a PEUGEOT dealer or a
qualified workshop for the replacement of these
bulbs.
Integrated direction indicator
side repeaters
You should contact a PEUGEOT dealer or a
qualified workshop for the replacement of these
bulbs.
Door mirror spotlamps
You should contact a PEUGEOT dealer or a
qualified workshop for the replacement of the
light emitting diode - LED.
Page 190 of 340
188
i
Practical information
1.
Brake lamps/sidelamps
(light emitting diodes - LEDs).
2.
Reversing lamps (P21W).
3.
Direction indicators (PY21W amber).
4.
Sidelamps (light emitting diodes -
LEDs).
5.
Foglamps (H21W).
Rear lamps (Saloon)
Reversing lamp, direction
indicator and foglamp bulbs
)
Open the boot, then the plastic cover.
)
Remove the two lamp unit fixing nuts.
)
Extract the lamp unit carefully from the
outside.
)
Disconnect the electrical connector.
)
Spread the six tabs and remove the bulb
holder.
)
Turn the bulb a quar ter of a turn and pull it
out.
For reassembly, carry out these operations in
reverse order.
Changing the light emitting
diode-LED lamps
For replacement, contact a PEUGEOT
dealer or qualified workshop.
Page 191 of 340
8
189
i
Practical information
1.
Brake lamps (light emitting diodes -
LEDs).
2.
Reversing lamps (W19W).
3.
Direction indicators (PY21W amber).
4.
Sidelamps (light emitting diodes -
LEDs).
5.
Foglamps (light emitting diodes - LEDs).
Rear lamps (SW)
)
Open the boot then remove the access
cover.
)
Remove the sealing foam.
)
Disconnect the lamp connector.
)
Remove the lamp fixing nut.
Direction indicators
(on the wings)
)
Carefully remove the lamp unit from
outside.
)
Remove the sealing foam.
)
Unclip the bulb holder.
)
Turn the bulb a quar ter of a turn and pull it
out.
For reassembly, carry out these operations in
reverse order.
Changing the light emitting
diode-LED lamps
For replacement, contact a PEUGEOT
dealer or qualified workshop.