key battery Peugeot 508 Hybrid 2013 Owner's Manual
[x] Cancel search | Manufacturer: PEUGEOT, Model Year: 2013, Model line: 508 Hybrid, Model: Peugeot 508 Hybrid 2013Pages: 340, PDF Size: 10.91 MB
Page 52 of 340
50
Access
Emergency procedure
Emergency unlocking/
locking
using the electronic
ke
y
The integral key is used to lock and unlock the
vehicle when the electronic key cannot operate:
- cell battery flat, vehicle battery discharged
or disconnected, ...
- vehicle located in an area with strongelectromagnetic emissions. )Pull on button 1, to extract the integralkey 2. )Unlock or lock the vehicle using the key.
Manual locking
Driver's door
Inser t the key in the lock to lock or unlock thedoor.
Passenger doors
)
On the rear doors, check that the child lock
is not on. ) Remove the black cap located on the edgeof the door, using the key. )
Inser t the key into the aper ture withoutforcing, then without turning, move the
latch sideways towards the inside of the door. )
Remove the key and refit the cap.
Remote control problem
Following disconnection of the vehicle battery,
replacement of the remote control battery or
in the event of a remote control malfunction
, you can no longer unlock, lock or locate your
vehicle. )First of all, use the key in the lock to unlock
or lock your vehicle. )Then, reinitialise the remote control.
If the problem persists, contact a PEUGEOT
dealer or a qualified workshop as soon as
possible.
Reinitialisation with the remote control
)Switch on the ignition. )Immediately press one of the remotecontrol buttons for a few seconds. )Switch off the ignition.
The remote control is fully operational again.
Page 53 of 340
2
51
Access
Changing the battery of the key
Battery ref.: CR2032 / 3 volts.
This replacement battery is available from a PEUGEOT dealer or a qualified workshop.
A message appears in the instrument panel
screen when replacement of the battery is needed. ) Unclip the cover using a small screwdriver at the cutout. )
Lift off the cover.
)
Remove the flat battery from its location. )
Fit the new battery into its location
observing the original direction of fitment. ) Clip the cover onto the casing.
Do not throw the remote controlbatteries away, they contain metals which are harmful to the environment. Take them to an approved collection point.
Reinitialisation with the electronic key
)Switch of the ignition. )Immediately press one of the remotecontrol buttons for a few seconds.
)Switch on the ignition
The electronic key is fully operational again.
Changing the battery of theelectronic key
Battery ref.: CR2032 / 3 volts.
This replacement battery is available from a
PEUGEOT dealer or a qualified workshop.
A message is displayed in the instrument panel screen when replacement of the battery is
needed. ) Unclip the cover using a pointed object at
the key ring. ) Slide the flat battery out of its location.
)
Slide the new battery into its location
observing the original direction of fitment. ) Clip the cover in place star ting at the front. )
Reinitialise the electronic key.
Page 55 of 340
2
53
Access
System which protects and provides a deterrent
against theft and break-ins. It provides the
following types of monitoring:
Alarm
- Exterior perimeter
The system checks for opening of the vehicle.
The alarm is triggered if anyone tries to open a
door, the boot or the bonnet...
- Interior volumetric
The system checks for any variation in the
volume in the passenger compartment.
The alarm is triggered if anyone breaks a
window, enters the passenger compar tment or moves inside the vehicle.
- Tilt
The system checks for any change in the attitude of the vehicle.
The alarm is triggered if the vehicle is lifted,
moved or knocked.
Self-protection function
The system checks for the putting out of ser vice of its components. The alarm is triggered if the battery, thecentral control unit or the wires of thesiren are put out of service or damaged.
For all work on the alarm system, contact a PEUGEOT dealer or aqualified workshop.
Locking the vehicle with full
alarm system
Activation
)Switch off the ignition and get out of the vehicle.
)
Press the locking button on the
remote control or lock the vehicleusing the Keyless Entry and Starting system. The monitorin
g system is active: the indicator
lamp on the button flashes once per second.
After the locking button on the remote control is pressed or the vehicle locked using the
Ke
yless Entry and Starting system, the exterior
perimeter monitoring is activated after a delay of 5 seconds, the interior volumetric monitoring
after 45 seconds and anti-tilt monitoring after 90 seconds.
If an opening (door, boot...) is not closed fully, the vehicle is not locked but the exterior
perimeter monitoring will be activated after a
delay of 45 seconds.
) Press the unlocking button on
the remote control or unlock the
vehicle using the Keyless Entryand Star ting system.
Deactivation of the volumetric monitoring
The volumetric protection system is
deactivated: the indicator lamp in the
button goes off.
Page 58 of 340
56
Access
Reinitialisation of the
electric windows
Always remove the key from the ignition when leaving the vehicle, even for ashort time. In the event of contact during operation
of the windows, you must reverse themovement of the window. To do this, press the switch concerned.When operating the passenger electric window switches, the driver must ensure that no one is preventing correctclosing of the windows. The driver must ensure that thepassengers use the electric windows correctly.Be aware of children when operatingthe windows. Followin
g reconnection of the battery, thesafety anti-pinch function must be reinitialised.
The safety anti-pinch function is not active
during these operations:
- lower the window completely, then raise it, it will rise in steps of a few centimetres
each time the switch is pressed. Repeat
the operation until the window closes
completely,
- continue to press the switch for at least one
second after reaching this position, window closed.
Page 123 of 340
4
121
Driving
Stop & Start
The Stop & Star t system puts the engine temporarily into standby - STOP mode - during stops in the traffic (red lights, traffic jams, or other...).
The engine restar ts automatically - START mode - as soon as you want to move off. The restart takes place instantly, quickly and silently.
Per fect for urban use, the Stop & Star t system reduces fuel consumption and exhaust emissions as well as the noise level when stationary.
Operation
Going into engine STOP mode
The "ECO"warning lamp comes
on in the instrument panel and the
engine goes into standby:
-
with the electronic gearbox system, at speeds below 4 mph (6 km/h), press the brakepedal or put the gear lever in position N.
I
f your vehicle is fitted with the system, a timecounter calculates the sum of the periods in
STOP mode during a journey. It rests itself to
zero every time the ignition is switched on with
the ke
y.
Never refuel with the engine in STOPmode; you must switch off the ignition with the key.
For your comfort, during parking maoeuvres, STOP mode is not available for a few seconds after coming out of reverse gear. STOP mode does not affect the functionality of the vehicle, such as for example, braking, power steering...
Special cases: STOP mode notavailable
STOP mode is not invoked when:
- the driver's door is open,
- the driver's seat belt is not fastened,
- the vehicle has not exceeded 6 mph (10 km/h) since the last engine star t using
the key,
- the electric parking brake is applied or
being applied,
- the engine is needed to maintain acomfor table temperature in the passenger compartment,
- demisting is active,
- some special conditions (battery charge, engine temperature, braking assistance,
ambient temperature...) where the engine isneeded to assure control of a system.
In this case, the
"ECO"
warning lamp
flashes for a few seconds then goesoff.
This operation is per fectly normal
.
Page 125 of 340
4
123
Driving
The system is reactivated automatically at every new star t using the key.
Reactivation
Press the "ECO OFF"switch again.
The s
ystem is active again; this is confirmed
by the switch warning lamp going off and a message in the screen.
Operating fault
In the event of a fault with the system, the
"ECO OFF"
switch warning lamp flashes thencomes on continuously.
Have it checked by a PEUGEOT dealer or aqualified workshop.
In the event of a fault in STOP mode, the
vehicle ma
y stall: all the instrument panelwarning lamps come on. It is then necessary
to switch off the ignition and star t the engine again using the key.
Before doing anything under the bonnet,deactivate the Stop & Start system toavoid any risk of injury resulting fromautomatic operation of STA R T m o d e .
This system requires a 12 V battery with a
special specification and technology (reference
numbers available from PEUGEOT dealers).
Fitting a battery not listed byPEUGEOT introduces the risk of malfunction of
the system.
To c h a rge the battery, use a 12 V charger andobser ve the polarity.
Maintenance
The Stop & Star t system makes use of advanced technology. For any work onthe system go to a qualified workshopwith the skills and equipment required,which a PEUGEOT dealer is able toprovide.
Page 208 of 340
206
Practical information
The batteries contain harmful substancessuch as sulphuric acid and lead. They must be disposed of in accordance with regulations and must not, in anycircumstances, be discarded with household waste.
Take used remote control batteries andvehicle batteries to a special collection point.
Do not reverse the polarity and use only a 12 V charger.
Do not disconnect the terminals whilethe engine is running.
Do not charge the batteries without disconnecting the terminals first. Do not push the vehicle to star t the engine if it is fitted with the 6 -speed electronic gearbox system or an automatic gearbox.
It is advisable to disconnect the 12 Vbattery if the vehicle is to be left unusedfor more than one month.
Before disconnecting the battery
Wait 2 minutes after switching off the ignitionbefore disconnecting the 12 V battery.
Close the windows and the doors beforedisconnecting the battery.
Following reconnection of thebattery
Following reconnection of the 12 V battery,
switch on the ignition and wait 1 minute before
star ting to permit initialisation of the electronic
systems. However, if problems remain followingthis operation, contact a PEUGEOT dealer or a
qualified workshop.
Referring to the corresponding section, you
must yourself reinitialise:
- the remote control key,
- the panoramic sunroof blind,
- the GPS satellite navigation system.
Load reduction mode
System which manages the use of cer tain
functions according to the level of charge
remaining in the battery.
When the vehicle is bein
g driven, the load
reduction function temporarily deactivates certain functions, such as the air conditioning,
the heated rear screen...
The deactivated functions are reactivated
automatically as soon as conditions permit.
Page 333 of 340
.
331
Visual search
Saloon Exterior
Remote control key / electronic key 43-52- opening / closing - anti-theft protection - starting - batteryWelcome lighting 143 Door mirror spotlamps 143 Main directional lighting 13 6-142, 145 Additional directional lighting 146 Headlamp height adjustment 144 Changing bulbs 191-195 - front lamps - foglamps- direction indicator repeaters
Wipers 147-149 Changing a wiper blade 150, 208
Parking space sensors 134-135
Doors 44-52 - Keyless Entry and Starting - opening / closing - central locking - emergency control Alarm 53-54 Electric windows 55 -56
Fuel tank,misfuel prevention 64-66
Sunroof 61- 62
Roof bars 213
Accessories 214 -215
ESC, ABS, EBA, ASR, DSC 168 -170
Tyre under-inflation detection 167
Tyre pressures 237
Changing a wheel 184-190
- tools
- removing / refitting
Boot 57, 60- opening / closing - emergency releaseTe m p o r a ry puncture repair kit 178 -183
Changing bulbs 196, 199 - rear lamps - 3rd brake lamp- number plate lamps - foglamps
Parking sensors 132-13 3 Towbar 211-212To w i ng 209-210
Door mirrors 74-75
Page 334 of 340
332
Visual search
SW Exterior
Remote control key / electronic key 43-52 - opening / closing - anti-theft protection - starting - batteryWelcome lighting 143 Door mirror spotlamps 143 Main directional lighting 13 6-142, 145
Additional directional lighting 146 Headlamp adjustment 144 Changing bulbs 191-195 - front lamps - foglamps- side repeaters
Wipers 147-149 Changing a wiper blade 150, 208
Door mirrors 74-75
Doors 44-52 - Keyless Entry and Starting - opening / closing- central locking- emergency control
Alarm 53-54 Wipers 55-56
Fuel tank, misfuel prevention 64-66
Boot 57, 60 - opening / closing - emergency controlMotorised tailgate 58-59 Temporary puncture repair kit 178 -183
Changing bulbs 197-199 - rear lamps- 3 rd
brake lamp - number plate lamp- fog lamps
Parking sensors 132-13 3 Towbar 211-212 To w i ng 209-210
Sunroof 61- 62
Panoramic sunroof 63
Roof bars 213
Accessories 214-215
ESC: ABS, EBA, ASR, DSC 168 -170 Under-inflation detection 167
Tyre pressures 237
Changing a wheel 184-190
- tools
- removing / refitting
Parking space sensors 134-135