warning PEUGEOT 807 2002 Owner's Manual

YOUR 807 IN DETAIL107
Electric sliding
side doors
Opening / Closing from the front:
– press the corresponding switch
B
to open or close.
An audible signal accompanies the
opening and closing of the door.
Opening / Closing from the
2 nd
row:
– press the corresponding switch C
to open or close.
Disarming the 2 nd
row controls:
– press the rear electric functions disarming switch.
THE DOORS
Opening the doors
from outside
Opening the doors
from inside
Note:
the door opening switches do
not function when the vehicle is
deadlocked. Locking / Unlocking from the
inside
Press button
A, the red warning light
comes on when the vehicle is locked
and switches off when it is unlocked.
This locks/unlocks the doors and the
tailgate.
Note: if the vehicle is locked or dead
locked from outside, the red warning
light flashes and button Adoes not
function. In this case, use the key or
the remote control for unlocking.
Automatic central locking
Your vehicle locks automatically
when you are driiving (at a speed of
more than 6 mph).
You can deactivate this function or
reactivate it.
To switch off
Press and hold button A.
Deactivation of the function is
accompanied by an audible signal.
To switch on
Press and hold button A.
Activation of the function is accom
panied by an audible signal and the
message ''Automatic locking of
the doors activated'' on the
multi–function display.
"Door open" alert
With the engine running or the vehicle
moving, a diagram accompanied by
an audible signal, locating the door
on the multi–function display, warns
you that a door is not properly closed.
18-11-2002

YOUR 807 IN DETAIL107
Electric sliding
side doors
Opening / Closing from the front:
– press the corresponding switch
B
to open or close.
An audible signal accompanies the
opening and closing of the door.
Opening / Closing from the
2 nd
row:
– press the corresponding switch C
to open or close.
Disarming the 2 nd
row controls:
– press the rear electric functions disarming switch.
THE DOORS
Opening the doors
from outside
Opening the doors
from inside
Note:
the door opening switches do
not function when the vehicle is
deadlocked. Locking / Unlocking from the
inside
Press button
A, the red warning light
comes on when the vehicle is locked
and switches off when it is unlocked.
This locks/unlocks the doors and the
tailgate.
Note: if the vehicle is locked or dead
locked from outside, the red warning
light flashes and button Adoes not
function. In this case, use the key or
the remote control for unlocking.
Automatic central locking
Your vehicle locks automatically
when you are driiving (at a speed of
more than 6 mph).
You can deactivate this function or
reactivate it.
To switch off
Press and hold button A.
Deactivation of the function is
accompanied by an audible signal.
To switch on
Press and hold button A.
Activation of the function is accom
panied by an audible signal and the
message ''Automatic locking of
the doors activated'' on the
multi–function display.
"Door open" alert
With the engine running or the vehicle
moving, a diagram accompanied by
an audible signal, locating the door
on the multi–function display, warns
you that a door is not properly closed.
18-11-2002

Opening / Closing using the
remote control:
press button C for more than two
seconds to open or close the rear
right door.
press button D for more than two
seconds to open or close the rear
left door.
Note: the electric sliding side doors
are fitted with an obstacle detection
system.
If an obstacle appears while the door
is closing, the door reopens.
If an obstacle appears while the door
is opening, the door stops.
In both cases, complete the required
action manually using the handle. Child lock
Electric
This disarms all of the electrical
controls in the rear.
 electric windows,
 sliding side doors,
 sunroofs.
With the ignition on, press button A.
The message "Child lock activat
ed" appears on the multifunction
display, accompanied by an audible
signal.
Always remove the key from the igni
tion on leaving the vehicle, even for
a short time.
YOUR 807 IN DETAIL
108
The force with which the
door moves may cause
injury.
When opening or closing
the door, ensure that
nothing prevents the required
manoeuvre.
Do not leave children or animals
near the door controls without
supervision. If necessary, disarm
the controls, then remove the key
from the ignition, even for a short
time.
Before setting off, check that the
door is correctly closed and
locked (see "door open" warning).
18-11-2002

Opening / Closing using the
remote control:
press button C for more than two
seconds to open or close the rear
right door.
press button D for more than two
seconds to open or close the rear
left door.
Note: the electric sliding side doors
are fitted with an obstacle detection
system.
If an obstacle appears while the door
is closing, the door reopens.
If an obstacle appears while the door
is opening, the door stops.
In both cases, complete the required
action manually using the handle. Child lock
Electric
This disarms all of the electrical
controls in the rear.
 electric windows,
 sliding side doors,
 sunroofs.
With the ignition on, press button A.
The message "Child lock activat
ed" appears on the multifunction
display, accompanied by an audible
signal.
Always remove the key from the igni
tion on leaving the vehicle, even for
a short time.
YOUR 807 IN DETAIL
108
The force with which the
door moves may cause
injury.
When opening or closing
the door, ensure that
nothing prevents the required
manoeuvre.
Do not leave children or animals
near the door controls without
supervision. If necessary, disarm
the controls, then remove the key
from the ignition, even for a short
time.
Before setting off, check that the
door is correctly closed and
locked (see "door open" warning).
18-11-2002

YOUR 807 IN DETAIL109
T
ailgate release
This enables the tailgate to be
unlocked in the event of a central
locking fault.  Fold back a 2 nd
row rear seat,
 Fold back a 3 rd
row rear seat or
the bench seat to gain access to
the lock from inside the boot,
 Insert a small screwdriver into
hole Ain the lock and push it
towards the left to unlock the
tailgate .
TAILGATE
Simultaneous locking or unlock
ing of the tailgate and the doors
The tailgate is locked or unlocked by
the remote control or the driver's
door or passenger door lock.
To open, operate the handle
Aand
lift the tailgate.
Note: The tailgate locks automatical
ly when the vehicle is being driven at
more than 6 mph (10 km/h) and
unlocks when one of the doors is
opened.
"Tailgate open" warning
When the engine is running or the
vehicle is being driven, you are
warned if the tailgate is not closed
correctly by a diagram on the
multi–function display, accompanied
by an audible signal. Partially opening rear
windows
To partially open the rear windows,
tilt the lever
Aand push it fully to
lock the windows in the open posi
tion.
18-11-2002

YOUR 807 IN DETAIL
110
SUNROOFS You have three sunroofs each with
an independent control.
However, the front passengers' con
trol can also operate the two rear
sunroofs simultaneously.
•partially open the roof: press and
hold part Aof the switch.
•to open the roof completely:
press part Aof the switch briefly.
•to close it completely: press part
B of the switch briefly, then keep it
pressed.
•safety autoreverse
When the sunroof is sliding closed
and meets an obstacle, it stops then
opens again.
Note: in the presence of ice, if the
sunroof does not close, press the
control until the roof is fully open,
then close the roof. Note:
following reconnection of the
battery, if the sunroof does not close,
release the control and press it sev
eral times until the roof is fully
closed. Continue to press the control
for approximately five seconds after
closing.
Disarming of the 2 nd
and 3 rd
row
controls:
– press the rear electrical functions disarming switch.
Note: the sunroof shutter is manual.
To open it, lift the handle and slide it
rearwards.
To close it, slide it forwards until the
handle locks. OPENING THE BONNET
From inside:
– lift the cover at the left foot of the
passenger seat.
– pull the control upwards.
From outside: lift the catch and
raise the bonnet.
Bonnet strut
Secure the strut to hold the bonnet open.Before closing the bonnet, replace
the strut in its housing.
To close
Lower the bonnet and release it at
the end of its travel. Check that the
bonnet is properly locked.
"Bonnet open" warning
This warning is linked to the alarm
option only.
With the engine running or the
vehicle moving, a diagram on the
multifunction display, accompanied
by an audible signal, warns you that
the bonnet is not properly closed.
18-11-2002

YOUR 807 IN DETAIL111
FILLING
THE
FUEL TANK
Low fuel level
When the tank's minimum
level is reached, this warn
ing light comes on, accom
panied by the message
"Fuel level low" on the
multi–function display.
You have enough fuel left to cover
approximately 30 miles (50 km).
If the warning light flashes, this
indicates a fuel gauge malfunction.
Contact a PEUGEOT dealer.
If the warning light flashes, accom
panied by the message "Fuel circuit
disarmed" , this indicates that the
fuel supply has been cut off.
Restore the supply (refer to the
corresponding section). The tank must be filled with fuel with
the engine off
.
 Open the fuel filler flap.
 Insert the key then turn it to the
left.
 Remove the cap and attach it to
the clip located on the inside of
the flap.
A label on the inside of the flap indi
cates which type of fuel to use.
If you fill your tank, do not continue
after the third cutoff of the pump
nozzle. This could result in vehicle
malfunctions.
The capacity of the tank is approx
imately 18 gallons (80 litres).  After filling the tank, lock the cap
and close the flap.
When the fuel filler flap isopen, a system limits theopening of the rear left
sliding side door. The keycannot be removed from
the capÕs lock until the cap is refit-ted on the tank.
18-11-2002

YOUR 807 IN DETAIL
116
TRIP COMPUTER
Each time the button on the end of the
wiper stalk is pressed, the following
sequence of data is displayed:
Monochrome screen CT
– the "vehicle" tab with:
• range, current consumption and the distance still to be driven,
– tab '1' (route '1') with:
• the distance driven and the aver age speed calculated over route
'1'
– tab '2' (route '2') with the same fea
tures.
It also permits access to the Excess
Speed Warning function.
Zero reset
When the required route is dis
played, press the button for more
than two seconds.
Monochrome screen B
the remaining range
the distance travelled
the average consumption
the current consumption
the average speed
In addition, it allows access to the
warning log information and to the
Excess speed warning function.
Zero reset
Press the stalk for more than two
seconds.
Colour screen DT
– the "Current information" with:
• the range,
• the current consumption,
• the distance still to be driven.
– 'Route 1' with:
• the distance travelled,
• the average coonsumption,
• the average speed,
– 'Route 2' with the same features.
It also permits access to the Excess
Speed Warning function.
Zero reset
When the required route is dis
played, press the button for more
than two seconds.
18-11-2002

Distance remaining to be
travelled
This is the distance remaining to the
destination. It can either be calculat
ed by the navigation if guidance is
activated, or entered by the user,
minus the distance covered since
the distance was entered.
Note:if digits are missing, dashes
are displayed in their place.
Average speed
This is the average speed calculated
since the computer was last set to
zero (with the ignition on).
The warnings log
This summarises the active warning
messages by displaying them on the
multifunction display.
The excess speed warning
function *
This monitors the maximum speed
required. In the event that the pro
grammed speed is exceeded, the
message ''Speed too high'' appears
on the multifunction display, accom
panied by an audible signal.
Programming
Accelerate to the desired speed.
Keep pressing the control to store in
memory.
* During the year.
YOUR 807 IN DETAIL 117
Range
This shows the distance that can still
be covered with the fuel remaining in
the tank.
Note:
this figure may increase if there
is a change in the style of driving or
the road surface, producing a signifi
cant drop in current consumption.
If horizontal segments are displayed
for long periods instead of digits,
contact a PEUGEOT dealer.
Current consumption
This is the average quantity of fuel
consumed during the last few sec
onds.
This function is displayed only when
the vehicle is travelling at a speed
greater than 20 mph (30 km/h).
Average consumption
This is the average fuel consumption
since the computer was last set to
zero.
Distance travelled
This indicates the distance travelled
since the computer was last set to
zero. Activation
Keep pressing the control until the
display indicates
''Excess speed
ON'' .
Switching off
Keep pressing the control until the
display indicates ''Excess speed
OFF'' .
The routes
The routes "1" and ''2''are indepen
dent but have identical application.
Route "1"for example allows you to
make daily calculations and route
"2" monthly calculations.
18-11-2002

YOUR 807 IN DETAIL
116
TRIP COMPUTER
Each time the button on the end of the
wiper stalk is pressed, the following
sequence of data is displayed:
Monochrome screen CT
– the "vehicle" tab with:
• range, current consumption and the distance still to be driven,
– tab '1' (route '1') with:
• the distance driven and the aver age speed calculated over route
'1'
– tab '2' (route '2') with the same fea
tures.
It also permits access to the Excess
Speed Warning function.
Zero reset
When the required route is dis
played, press the button for more
than two seconds.
Monochrome screen B
the remaining range
the distance travelled
the average consumption
the current consumption
the average speed
In addition, it allows access to the
warning log information and to the
Excess speed warning function.
Zero reset
Press the stalk for more than two
seconds.
Colour screen DT
– the "Current information" with:
• the range,
• the current consumption,
• the distance still to be driven.
– 'Route 1' with:
• the distance travelled,
• the average coonsumption,
• the average speed,
– 'Route 2' with the same features.
It also permits access to the Excess
Speed Warning function.
Zero reset
When the required route is dis
played, press the button for more
than two seconds.
18-11-2002