battery PEUGEOT 807 2003 Owners Manual







 
)*


2




5 2

#++1#"#  
"

(
%
$# 


#



 "2

/ %

!


"



&

!2

(
%
$# 

,(7


#


9 
!



"

"




!


# 

!



 "2

&#/#$
!




= !2

&#/#$

!



=/#$
44
$


!


"




52
 #
#
 #("

,
%
1(7
,&("

2#
, ##
5@
 
!


 
=

!


!


#
=

"
"





7!



"





2
 

#

!



#
 
!

 
=

!


!


#
=

"
"





C


$





#



!

 
= 


"

"
"
!


#

1


&

"(/
%#"
&
 ,/# &
# #&
%
/%#"@
'#%
%
$#
#$

$





#

!



!



#


5
;5

5



=;

=

:D The four speed automatic gearbox offers a choice between the comfort of
integral automatic operation , enhanced by a snow programme, or the
pleasure of manual gear changing .
(
"#
$(  A"

"






!



!









!




If the battery is flat and the lever is in position P, it will be impossible to
change to another position.

12-05-2003
 


  
  




!"
#$%


&
!'%' Less than a minute after switching
off the ignition, operate the wipersstalk to position the wiper bladesalong the windscreen uprights(maintenance position).


("'
!"
#$  Lift the wiper arm, then disconnectthe windscreen-wash pipe.
 Unclip the blade and remove it.
 Fit the new blade.
 Reconnect the windscreen-washpipe and push back the wiper arm.
'
")"

$%"
!"%
'
"
'"&
!'%'*
% 
'

'
$
'!"

!"%
%+,


""
!"
#$  Lift the wiper arm, then unclip the blade and remove it.
 Fit the new blade and push backthe wiper arm.  - 

.  After the engine has stopped, with the key in the accessories position,
certain functions (windscreen wiper,electric windows, courtesy lights,audio equipment etc.) can only beused for thirty minutes, to prevent
discharging the battery.
Once the thirty minutes are over, the message
/''&0
&'$
1/
appears on the multifunction displayand the active functions are put on
standby.
A flat battery will prevent the engine from starting.

12-05-2003
-
'
"

#"0
)%

#"0
""2– Disconnect the battery,
– Follow the instructions for use given by the battery charger manufacturer,
– Reconnect starting with the negative (–) terminal,
– Check that the terminals and connectors are clean. If they are covered with sulphate (white or greenish deposit), disconnect them and clean them.
'
%"

1
("'&
'"
#"02 – Connect the red cable to the positive (+) terminals of the two batteries,
– Connect one end of the green or black cable to the negative (–) terminal of the slave battery,
– Connect the other end of the green or black cable to an earth point on the bro- ken down vehicle as far as possible from the battery,
Operate the starter, let the engine run.
Wait for the engine to return to idle, then disconnect the cables.

%
$1%#
'
$%'

#"0
(

1
%
'
'
#
)%$
('"

!"'$
'(
&'"

'
&',
 


Ð Before disconnecting
the battery, you must wait for 2 minutes afterswitching off the igni-tion.
Ð Never disconnect a terminal when the engine is running.
Ð Never charge a battery without first disconnecting the terminals.
Ð Close the windows and sunroof before disconnecting the battery.If they do not operate normallyfollowing reconnection of the
battery, they must be reintialised(see sections "Electric windows -Safety auto-reverse" and "Sun-roof - Safety auto-reverse".
Ð After every reconnection of the battery, switch on the ignitionand wait 1 minute before starting to allow the electronicsystems to be initialised. If slightdifficulties are experienced after this, please contact a
PEUGEOT dealer.