display Peugeot Boxer 2016 Owner's Guide

111
boxer_en_Chap05_Securite_ed01-2015
deactivating the passenger's front
airbag
When OFF is selected, the passenger's front
airbag will not be triggered in the event of an
impact.
As soon as the child seat is removed, select
ON to re-activate the airbag and thus ensure
the safety of your front passengers in the
event of an impact.Lateral airbags and curtain airbags
If your vehicle is fitted with lateral airbags,
these are fitted to the front seat backs on
the door side.
t

he curtain airbags are fitted to the door
pillars and the upper part of the passenger
compartment, in the roof over the front cab
seats.
t

hey inflate between the occupant and the
glazed area.
t

hey are deployed independently of each
other depending on which side the collision
occurs.
to ensure the safety of your child, it is


essential to deactivate the passenger's
front airbag when you install a rearward
facing child seat on the front passenger
seat. Otherwise, the child would risk being
killed or seriously injured if the airbag were
to inflate.
If your vehicle's front passenger airbag
cannot be deactivated: you must not install a
rearward facing child seat.
d

eactivation check


t
his is confirmed by the
illumination of this warning lamp,
accompanied by a message in
the display screen, every time the
engine is started.
o

perating fault If this warning lamp comes on,
contact a P
euge O t
dealer to

have the vehicle checked.
Refer to the "
t
echnology on board -


Vehicle configuration" section.
t

he setting is made using the "M
od
E"
button: in the "Passenger airbag" menu,
select "OFF".
Airbags
5
SAFetY

137
boxer_en_Chap07_Verifications_ed01-2015
Good practice
While the quantity of AdBlue® in the additive
tank
is sufficient, no information is displayed.
On the other hand, once the additive level
drops to the quantity needed for a range
of 1 500 miles (2 400 km) driving, you
are warned by different temporary signals
(warning lamp, message, audible signal).
As more miles are covered, these signals
intensify and the message becomes
permanent.
Filling the additive tank
For light vehicles, 5 or 10 litre containers
and 1.89 litre (1/2
u
S gallon) bottles are
available from P
euge
O
t
dealers.
If you want to fill the

AdBlue
® tank yourself,
ensure that you have a suitable filler pipe,
which may or may not be supplied with the
additive container. When the AdBlue® tank is empty,
restarting becomes impossible.
It is strongly recommended that you do
not wait for the successive alerts before
topping-up the AdBlue
® tank, but do this as
soon as possible.
AdBlue® additive
7
CHeCKS

138
boxer_en_Chap07_Verifications_ed01-2015
range indicators
Different levels of alert are triggered
according to the remaining driving range
threshold.
You will be informed as each mileage
threshold is reached and the alerts will
change from temporary to permanent.
- t he 1
st alert is triggered at a remaining
driving range of 1 500 miles (2 400 km).
-
t
he 2
nd alert is triggered at a remaining
driving range of 375 miles (600 km).
u

p to 0 miles, at which point it will be
impossible to restart the engine after a stop.
r

ange greater than 1 500 miles (2 400 km)
No information displayed.
Once the 1 500 miles (2 400 km)
threshold is reached, this warning
lamp comes on temporarily and the
remaining range message is displayed.
every time the ignition is switched on, the
alert is given, together with an audible
signal.
r
emaining range less than 1 500 miles

(2 400 km) and greater than 375 miles
(600 km)
Once the 350 miles (600 km) threshold
is reached, this warning lamp flashes,
accompanied by a message on the
remaining driving range.
the alert is repeated with an update of the
remaining driving range in steps of 30 miles
(50 km) travelled.
e

very time the ignition is switched on, the
alert is given together with an audible signal.
At 0 miles the system installed in the
vehicle to meet the emissions standard
will prevent engine starting.
t
he 0 level of AdBlue
® additive has been
reached.
Your vehicle's exhaust emissions no longer
meet the "
e
uro 6" standard and the engine
will not start.
to be able to

restart the vehicle, you must
add at least 3.8 litres of AdBlue
®.
-

Pour the additive into the tank (by the

filler with the blue cap).
-

Switch on the ignition without starting.
-


W

ait 10 seconds before starting the
engine.
r

emaining range less than 350 miles

(600 km) and more than 0 miles Starting prevented, breakdown related to a
lack of AdBlue
®
additive in the special tank
Avoid waiting until the remaining
range is 0 miles!
t

he alert is repeated when driving until the
AdBlue additive tank has been topped-up
with sufficient additive.
u

nless the additive in the special additive
tank is topped-up, you risk immobilisation of
the vehicle. Following this, make a further fill to the
special additive tank, the capacity of
which is 15 litres. Or go to a P
euge O t
dealer or a

qualified workshop.
AdBlue® additive

139
boxer_en_Chap07_Verifications_ed01-2015
Fault with the Scr system
the diagnostic warning lamp
comes on.
e

very time the ignition is
switched on, the emissions fault
is confirmed by an audible signal and a
message.
If it is a temporary fault, the alert disappears
as soon as the exhaust emissions return to
the levels required by the standard. Fault confirmed
In addition to the previous signals, the
remaining range allowed will be displayed in
miles (kilometres) in the instrument panel.
t

he alert will be repeated every 30 seconds
with an update of the driving range.
g

o to a P euge O t
dealer or a qualified

workshop as soon as possible.
You risk not being able to start the engine. Starting prevented, having covered the
250 miles (400 km)
d

etection
At each attempt at starting,
the alert is activated and the
message on starting prevention is
displayed.
On the other hand, if the warning lamp
is still on after 30 miles (50 km) of
driving, the fault is confirmed.
An engine start prevention system
will be activated automatically after
250

miles (400 km) travelled following this
confirmation.
g

o to a P
euge O t
dealer or a qualified

workshop.
AdBlue® additive
7
CHeCKS

144
boxer_en_Chap08_Aide-Rapide_ed01-2015
the presence of this label, in particular
with the Stop & Start system, indicates
the use of a 12 V lead-acid battery with
special technology and specification; the
involvement of a P
euge O t
dealer or

a qualified workshop is essential when
replacing or disconnecting the battery.
After refitting the battery by a
P
euge O t
dealer or a qualified

workshop, the Stop & Start system will
only be active after a continuous period of
immobilisation of the vehicle, a period which
depends on the climatic conditions and the
state of charge of the battery (up to about
8 hours).
It is advisable to disconnect the
negative (-) terminal of the battery
if the vehicle is not to be used for a
period of more than one month.
t

he description of the battery charging
procedure is given as an indication only.
If the battery has been disconnected
for some time, it may be necessary to
reinitialise the following functions:
-

the display parameters (date, time,


language, distance unit and temperature
unit),
-

the radio stations,
-


the central locking.
Some settings are cleared and must be


reprogrammed, consult a P
euge
O
t
.
If your vehicle is fitted with a tachograph or


an alarm, disconnection of the negative (-)
terminal of the battery (located under the
floor on the left-hand side, in the cab) is
recommended if the vehicle is not to be used
for a period of more than 5 days.
Discharged battery

185
boxer_en_Chap10a_Autoradio_Fiat-tactile-1_ed01-2015
Screen off / on.
Activate, deactivate, adjust certain
system and vehicle functions.
ej
ect CD.
Mute / restore volume (mute / pause).
Abandon the current operation.
go u

p one level (menu or folder).
Press: on / off.
Rotate: adjust the volume
(each source is independent).
Radio, rotate: search for a radio
station.
Media, rotate: select the previous /
next track.
Press: confirm the option displayed in
the screen.
th

e screen is of the "resistive" type, it
is necessary to press firmly, particularly
for "flick" gestures (scrolling through a
list, moving the map...). A simple wipe
will not be enough. pressing with more
than one finger is not recognised.
th
e screen can be used when wearing
gloves. t
h
is technology allows use at
all temperatures.
to c

lean the screen, use a soft
non-abrasive cloth (spectacles cloth)
without any additional product.
Do not use pointed objects on the
screen.
Do not touch the screen with wet
hands.
glossary
Menu item Significance /
co rresponding
action
VOL
u
MeA
djust the volume by rotation.
RADIO Access the radio menu.
M
e

DIA Access the media menu and the
different audio sources.
N AV Access the navigation menu.
PHON
eA

ccess the telephone menu.
MOR
eA

ccess vehicle information.
BROWS
e
t

u N e
S

CROLL
tu
rn the button to:
-

m
ove in a menu or a list.
-

s
elect a radio station.
eNt

e R Confirm an option displayed in
the screen by pressing.
touch Screen Audio - telematic System
AuDIO and teLeMAtICS
10

189
boxer_en_Chap10a_Autoradio_Fiat-tactile-1_ed01-2015
Level 1Level 2 Level 3co mment
rAd

I
oB

riefly press the buttons for an automatic search.
Press and hold the buttons for a quick search.
rAd

I
o
Pr

eset Make a long press on the button to present the
current radio station.
th

e current station is highlighted.
Press the "All" button to display all of the preset
radio stations in the waveband selected.
rAd

I
o
n

avigate List of stations
Selection a station with a press.
up

date the list according to reception.
Press these buttons to scroll through the radio
stations received.
go d

irectly to the desired letter in the list.
rAd

I
o
AM

/FM/
d

AB
ch
oose the waveband Choose the waveband.
rAd

I
o
A

djustment
dir
ect adjustment
th
e screen virtual keypad can used to enter a
single number corresponding to a station.
th

e symbols allow precise adjustment of the
frequency.
rAd

I
o
I

nfo Information
Display information on the current radio station.
touch Screen Audio - telematic System
AuDIO and teLeMAtICS
10

192
boxer_en_Chap10a_Autoradio_Fiat-tactile-1_ed01-2015
If the "DAB" radio station being listened
to is not available, the "AF" alternative
frequency option is crossed out.
DAB (Digital Audio Broadcasting) radio
Select the audio source.Display the name and number of the
multiplex service being used.Alternative frequency.
Adjust audio settings. Select preset radio stations.
Next "Multiplex".
Next radio station.
Display the "DAB" band.
Select a radio station from
"All", "
ge

nres", "Multiplex".
Previous "Multiplex".
Previous radio station. Display name and
"Radiotext" for the current
station. Preset station.
Short press: select preset radio station.
Long press: preset a radio station.
touch Screen Audio - telematic System

193
boxer_en_Chap10a_Autoradio_Fiat-tactile-1_ed01-2015
Select the "navigate" tab.
Press repeatedly on "
rAd
I
o" t
o
display the "DAB Radio".
Select a list from the filters offered:
" All ", "Genres ", Multiplex " then
select a radio station.
Press the "
upd

ate" button to update
the list of "DAB Radio" stations
received.
dAB / FM auto trackingdi
gital radio
"DAB" does not cover 100% of the
te r r i to r y.
When the digital radio signal is weak,
the " AF" (alternative frequencies)
option allows you to continue listening
to the same station, by automatically
switching to the corresponding "FM"
analogue station (if there is one).
When the system switches to analogue
radio, there is a difference of few
seconds with sometimes a change in
volume.
When the digital signal is restored, the
system automatically changes back to
" DA B ".
Digital radio provides higher quality
reception and also the graphical display
of current information on the radio
station being listened to.
th

e range of multiplexes available is
displayed in alphabetical order.
If the "DAB" station being listened to
is not available, the sound will cut out
while the digital signal is too weak.
touch Screen Audio - telematic System
AuDIO and teLeMAtICS
10

195
boxer_en_Chap10a_Autoradio_Fiat-tactile-1_ed01-2015
Level 1Level 2 Level 3co mment
ME d
I
A Briefly press the buttons to play the previous/next
track.
Press and hold the buttons for fast for ward or
back in the track selected.
ME
d
I
A
n

avigate
cur
rently playing Navigate and select tracks on the active device.
th

e selection possibilities depend on the device
connected or the type of CD inserted.
Artists
Albums
Genres
tr

a c k s
Playlists
Audio books
Podcasts
ME
d
I
A
Source
cdS

elect the desired audio source from those
available or insert a device intended for this
purpose, the system starts playing the source
automatically.
A
ux
u
SB
Bluetooth Sources connected
Pair a Bluetooth audio device.
Add device
tel

. connect.
ME
d
I
A
Info Information
Display information on the track playing.
touch Screen Audio - telematic System
AuDIO and teLeMAtICS
10