dashboard PEUGEOT EXPERT DAG 2001 User Guide

INSTRUMENT PANEL*35I-12
Coolant temperature gauge Coolant temperature warning lampUnder normal operating conditions, the gauge may indicate a temperature of up to 100¡C.Under severe operating conditions, such as in high temperatures, the needle may approach the red zones.
If the warning lamp lights up, stop immediately, switch the engine off, the cooling fan may continue
to operate for a while , and allow to cool before checking the coolant level, taking the precautions
described in chapter IV - Maintenance - "Levels, checks".
Engine overheating can have various causes. Contact your nearest dealer.The STOP warning lamp flashes when the coolant temperature warning lamp is lit.
Engine oil levelOn switching on the ignition, the needle indicates the oil level and then returns to zero.Reading in the min. zone, check the level manually using the dipstick. Fuel gauge When the low level warning lamp comes on continuously with the vehicle on level ground, there remain approximately 5 to 7 litres of fuel in the tank. Reservoir capacity (in litres):
80 Approximately.
* According to model or country
Protection fuses under the dashboardF2

INSTRUMENT PANEL*I-12
36
* According to model or country
Protection fuses under the dashboardF2 - F19
A
Exterior temperature display The outside temperature is dis- played whenever the ignition isswitched on. If the ¡C symbol flashes, there is a danger of ice on the roads. Resetting the trip mileage recorder to zero Press button
Ato alternate the dis-
play between the total mileage
recorder and the trip mileage recorder. Press and hold down the button to reset the current trip mileage recor-der to zero. Dashboard lighting The intensity of the dashboard ligh- ting can be adjusted. Use the rheostat dimmer wheel located in the dashboard.

SIGNALLING*41I-14
Horn Press the end of the stalk. Headlamp flash Pull the stalk towards you to flash headlamps.
The headlamp flash operates even with the ignition off. Direction indicators Left: move the stalk downwards.Right: move the stalk upwards.
Movement of the steering wheel returns the stalk to the off position automati-
cally. Hazard warning lamps
Operates the direction indicators simultaneously.
Use only in case of danger, emergency stop or in hazardous conditions.
Also operates with the ignition off.The direction indicators will not work when the hazard warning lamps are in use.
* According to model or country
Protection fuses under the dashboardF7 - F26 - F30Protection fuses under the dashboardF4 - F9 - F18 - F19
(under the bonnet)
F3 - F4 - F7 - F8 (with ABS)
F2 - F3 - F12 - F13 (without ABS)

SIGNALLING*43I-14
Adjusting the headlamps
You are advised to adjust the beam of the headlamps in accor- dance with vehicle load. Electrically operated adjustments* In the dashboard on the right hand side of the steering column.0 Empty
1 Lightly laden
2 Half laden
3 Fully laden
Manual adjustments*Using the controls located in the engine compartment behind eachheadlamp.
* According to model or country
Protection fuses under the dashboardF4

VISIBILITYI-15
44
Windscreen wiper
3 High speed
2 Normal speed
1 Intermittent wipe
0 Stop
4 Single wipe - Press the stalk down
By pulling the stalk towards you:
Windscreen wash And headlamp washers if the dipped beams are on*.
Two headlamp wash operations at an interval of less than 10 seconds will pro-
vide effective cleaning of the headlamps.
BEWARE: When washing the vehicle, with the ignition on (for example when using an automatic car wash):
- ensure that the stalk is returned to position 0-Off.
* According to model or country
Protection fuses under the dashboardF9 - F24
(under the bonnet)
F10 - F12 (with ABS)
F4 (without ABS)
1
2
3
4
0

VISIBILITY45I-15
Rear screen demister* Can only be operated with the engine running.
Press the button to switch on the rear screen (and door mirrors) electric demister.
The demister switches off automatically after approximately twelve minutes of operation to avoid excessive current consumption. Press the button to cancel the demisting function.Press the button again to re-activate the demisting function for another twelve minutes.* According to model or country
Protection fuses under the dashboardF6 - F27

WINDOWS*I-16
46
ALWAYS PAY ATTENTION TO WHERE CHILDREN
ARE WHEN OPENING OR CLOSING WINDOWS.
Sequential control*
One touch on the switch to its first position offers partial opening of the driverÕs
window.
Pressing the switch to its second position fully opens or closes the window. Child safety precaution Always remove the ignition key when leaving the vehicle, even for short periods. Electric control The switches mounted in the roof
console control the vehicleÕs frontwindows.
Glazed or Combi versions Sliding side window in second row
To open, pull Aand slide the win-
dow towards the front.
To close, slide the window towards
the rear, then press Bto lock it.
* According to model or countryProtection fuses under the dashboardF5 - F28 - F29
AB

REAR VIEW MIRRORS*I-17
48
Electrically - controlled door mirrors If your vehicle is fitted with two electrically controlled rear view mirrors, turn lever Ato select the desired rear view mirror:
- to the right for the right hand rear view mirror,
- to the left for the left hand rear view mirror. Adjust the rear view mirror using lever A.
* According to model or country
Protection fuses under the dashboardF30
A

BRAKES55II-4
ABS - Anti-lock Braking System* This system improves vehicle safety by preventing the wheels from locking under emergency braking or when
braking on surfaces offering poor adhesion.
It thus also allows control of the steering to be retained. The operation of the various electronic components of the system is continuously monitored, both before and during your
journey. On switching on the ignition, the ABS lamp will light for approximately two seconds. If it stays on or lights when
driving, the ABS computer has detected a fault and has disconnected the ABS system. If the lamp lights whilst driving, it
again indicates that a fault has been detected and that the ABS system is inactive. In both situations, the normal braking
system is not affected and will continue to function as a conventional braking system without ABS. Nevertheless, to re-
establish the full safety features of the ABS system, It is recommended that the vehicle be examined by a dealer as soonas possible.
On slippery roads (loose stones, snow, ice, etc.), it is imperative to drive with caution.
* According to model or country
Protection fuses under the dashboardF12
(under the bonnet)
MF4 (with ABS)

CRUISE CONTROL*57II-5
BEWARE
Cruise control must only be used where road condi- tions permit. Do not use it on congested roads nor
when weather and road conditions are poor.
Disengaging the cruise control The cruise control will be disengaged on pressing either the clutch or brake pedal. Flicking stalk
Atoward you will also disengage the crui-
se control.The memorised speed is not cancelled. Recalling the memorised speed Following a disengagement, flick the stalk Arapidly
upwards or downwards and your vehicle will resume the last speed memorised. Increasing the memorised speed Move stalk Aupwards, hold until the new speed is rea-
ched and then release the stalk to memorise it. Reducing the memorised speed Move stalk Adownwards, hold until the new speed is
reached and then release the stalk to memorise it. (Minimum regulated speed = 25 mph). Cancelling the cruise control operation Either when the vehicle is stationary: ignition switched
off. Or Press switch B. The warning lamp will go out. AdviceDo not position your foot under the accelerator pedal
while the cruise control is operating. Your reactions maybe impeded and movement of your foot restricted.
* According to model or country
Protection fuses (under the dashboard)F3