ECO mode Peugeot iOn 2012 Owner's Manual

This personal space offers advice and other useful information for
the care and maintenance of your vehicle.

You can find your user guide on the PEUGEOT website, under theheading "Personal space".

Referring to the user guide on-line also gives you access to thelatest information available, easily identified by the bookmarks, associated with this pictogram:
If the heading "Personal space" is not available on the public websitefor your country, you can find your user guide at the following address:http://public.servicebox.peugeot.com

the link in "Private customer access",
the language,
the model,
the edition date appropriate for the date of registration of your vehicle.
Please note the following point:
The fitting of electrical equipment or accessories which are not recommended by PEUGEOT may result in a failure of your vehicle's electronic system. Please note this specific warning.It is advisable to contact a PEUGEOT dealer to be shown the recommended equipment and accessories.
Select:
Yo u w i l l find your user guide, presented in the same way as the paper version.

.Familiarisation
17





For more economical driving, and increased range
Practical advice for everyday use to optimise the range of your vehicle by conser ving battery power.


Adopt a smooth driving
style

The electrical consumption of your vehicle
depends greatly on your journey, your driving style and your speed.
In all cases, adopt a smooth driving style.
Sta
y in the "Eco" zoneindicated in the energy consumption / generation meter: depress the
accelerator pedal progressively, without sudden movement, and if the conditions permit, drive at
steady and moderate speed.
Recover energy
Anticipating the driving conditions allows you torecover energy and increase the range of your
vehicle.
Use the "Charge" zoneof the energyconsumption / generation meter whenever possible: anticipate the traffic slowing
down and if the the conditions permit, use
deceleration rather than the brakes.


Control the use of your
electrical equipment

The heating and air conditioning systems operate on energy from the main battery.
Excessive use of these systems greatlyreduces the range of your vehicle. Remember
to switch them off once the desired level of comfor t is reached and check their settings every time you set off.
Control also the use of demisting / defrostingand the heated seat.


Limit the causes of excess
consumption
As with any vehicle, limit the loads carried
in the vehicle and reduce wind resistance (windows open above 30 mph (50 km/h), roof
bars, roof box, …).


Observe the
recommendations on
maintenance
Check the tyre pressures regularly andfollow the schedule for routine ser vicing
recommended by PEUGEOT.

1
Instruments and controls
19
Indicator and warning lamps
Visual indicators informing the driver that asystem is in operation, is deactivated or has a
fault.


When the ignition is switched on
Cer tain warning lamps come on for a few seconds
when the vehicle's ignition is switched on.
These same warning lamps go off after a fewseconds.
If you notice one of these warning lamps
remaining on, refer to the information on the
warning lamp in question.
Associated warnings
The illumination of cer tain warning lamps may
be accompanied by an audible signal.
The warning lamps may come on continuously (fixed) or flash.
Cer tain warning lamps may come on in one of two modes. Only by relating the type of lighting to the operating status of the vehicle can it be ascertained whether the situation is normal or whether a fault has occurred.

1
Instruments and controls
27





Energy consumption / generation indicator
Energy consumption
On switching on the ignition, your vehicleneither consumes nor generates energy in itselectric traction system: the needle is in the
"neutral" position (provided that the heating and
air conditioning are off).
"Eco" zone

A system that informs the driver of the level of energy consumption or generation of the main battery.


"Neutral" position

"Char
ge" zone
The needle moves to the right in proportion to
the energy consumption by the vehicle. The needle is in this zone when the vehicle is
used so as to moderate electric consumption
and optimise its ran
ge.
The needle moves to the le
ft in propor tion to
the level of charge sent to the main battery,
during period of deceleration and braking.

1
Instruments and controls
29
Service indicator
When the ignition is switched on, pressbutton A
several times in succession until the
ser vice indicator is displayed in the desiredunits. This point can be indicated in one o
f two ways:
- the miles (km) remaining,
- the time remaining to the next ser vice.



Operation
1.
The screen indicates that 620 miles (10 0 0 km) or 1 month remain before thenext service. 2.The screen indicates that the date for theservice has been exceeded.
Every time the ignition is switched on,
the ser vice spanner is displayed for a
few seconds to remind you that a ser vice should be carried out as soon as possible.3.Once the ser vice has been carried out, the
distance or the number of months to the next ser vice is displayed again.

System which informs the driver when the next service is due in accordance with the
manufacturer's servicing schedule.
The point at which the next ser vice is due is calculated from the last service indicator zeroreset.
S
ystem for manual adjustment of the brightness of the instruments and controls in relation to theexterior brightness.
With the lighting on or off, press button Ato select the function, then hold down to change
the intensity of the lighting of the instruments
and controls in "day" or "night" mode.
The intensity of the lighting increases each timebutton Ais pressed.
When the lighting reaches the maximumsetting, press again to change to the minimum setting.
When the lighting reaches the required
intensity, release button A .
The setting is saved when you release button A
and retained when the ignition switch is turned
to OFF.
Lighting dimmer

Access
34
1. Driver's electric window.2.
Passenger's electric window.3.
Rear right electric window. 4.
Rear left electric window. 5.
Deactivating the passenger and rear electric window switches.










Electric windows


Operation

Deactivating the passenger and
rear electric window switches
)For the safety of your children, pressswitch 5
to prevent operation of the passenger and rear electric windows
irrespective of their position.
When the button is pressed down, the switches are deactivated.
When the button is raised, the switches are activated.
System which opens or closes a window manually or automatically. It is fitted with a deactivation system to prevent misuse of the rear controls.
The electric window switches remainoperational for approximately30 seconds after the ignition is switchedoff. The windows can no longer be opened or closed after the driver's door is closed. With the i
gnition on: )
Press the switch gently to open or pull it gently to close. The window stops as soonas the switch is released.


Always remove the key from the ignition when leaving the vehicle, even for a short time.
In the event of contact during operationof the windows, you must reverse the movement of the window. To do this,press the switch concerned.
When the driver operates the passenger electric window switches, they mustensure that no one is preventing correct closing of the windows.
The driver must ensure that passengersuse the electric windows correctly.
Be aware of children when operating the windows.
Automatic one-touch mode
(driver's side)) Press the switch fully to open. The driver's
window opens completely when the switch is released. ) Pressing the switch again stops the
movement of the window.

Visibility
60








Wiper controls The vehicle's front and rear wipers are designed to improve the driver's vision, according to the climatic conditions.
Manual controls


Windscreen wipers
The wiper commands are issued directly by the
driver by means of the stalk Aand its ring B
. sin
gle wipe.
park.
intermittent
(the speed can be set manually).
slow.
fast.
B. Intermittent operation adjustment ring. ) Turn this ring to increase or reduce the
wiping frequency in intermittent mode. A
. Wiping speed selection stalk:
Windscreen wash
Pull the wiper stalk towards you. The
windscreen wash, then the windscreen wipers,
operate for a pre-determined time.

Rear wiper
C.Rear wiper selection ring:
park.
intermittent wipe.
The wiper wipes twice then switches
t
o intermittent mode with an interval of a few seconds.
wi
pe with screenwash .

Keep the ring in this position to operate thescreenwash with several wipes of the wiper.

129






AUDIO SYSTEM / BLUETOOTH

01 First steps


For safety reasons, the driver must only carry out
operations which require prolonged attention while the
vehicle is stationary.
When the engine is switched o
ff and to prevent
discharging of the battery, the system switches off after
activation of the energy economy mode.

CONTENTS

02 Radio

03 Audio

04 Using the telephone

05 Audio settings

06 Configuration

07 Screen menu map

Frequently asked questions p.
p.
p.
p.
p.
p.
p.
p. 130
131
134
140
146
147
148
149 After a battery disconnection, a code has to be enteredfor operation of the radio.

A maximum of fi ve attempts are possible. For the last
two attempts, a 15 minutes wait is imposed between each attempt.
R
efer to the end of this document to fi nd the label indicating this code:

03
137
Select a line in the list.
Jump a page.
Pr
ess MENU, select "Media"
thenselect or deselect "TA "
to activate or
deactivate reception of traffi c messages.
U
p a level in the menu.
AUDIO
Return to the top level of the folder structure to select the type of
tracks.
-
By Folders
(CD or USB): all folders containing audio fi les recognised on the peripheral device, in alphabetical order withoutfollowing the folder structure.
- B
y Artist(USB only): all of the artist names defi ned in the ID3
Tags, in alphabetical order.
- B
y Genre
(USB only): all of the genres defi ned in the ID3 Tags.
-
By Playlist
(CD or USB): if playlists have been saved.

Pr
ess LISTto display the structure of
the folders in the compilation.
Select the pla
y mode: "Normal" ,"Random" , "Random all"or "Repeat".

150
FREQUENTLY ASKED QUESTIONS
QUESTIONANSWERSOLUTION
The quality of receptionof the radio station
listened to graduallydeteriorates or the stored stations do not function(no sound, 87.5 MHz is
displayed...). The vehicle is too
far from the transmitter used by the station listened
to or there is no transmitter in the geographical area through which the
vehicle is travelling.
Activate the RDS function to enable the system
to check whether there is a more powerful
transmitter in the geographical area.
The environment
(hills, buildings, tunnels, basement car parks...) block reception, including in RDS mode. This phenomenon is normal and does not indicate
a failure of the audio equipment.
The aerial is absent or has been dama
ged (for example when goingthrough a car wash or into an underground car park). Have the aerial checked by a PEUGEOT dealer.

Sound cut-outs of 1 to2 seconds in radio mode.During this brief sound cut-out, the RDS searches for any frequency
permitting better reception of the station. Deactivate the RDS function if the phenomenon is
too frequent and always on the same route.
Tr
affi c announcement
TA is displayed. I donot receive any traffi c
information.Th
e radio station does not broadcast traffi c information. Tune to a radio station which broadcasts traffi c
information.

The stored stations arenot found (no sound, 87.5 MHz is displayed...).
An incorrect waveband is selected. Press the SRC/TEL button to return to the
waveband (FM1 or FM2) on which the stations arestored.