oil Peugeot Partner 2013 - RHD (UK, Australia) User Guide

[x] Cancel search | Manufacturer: PEUGEOT, Model Year: 2013, Model line: Partner, Model: Peugeot Partner 2013
Pages: 236, PDF Size: 8.86 MB

Load previous 10 pages

Page 112 of 236

Peugeot Partner 2013 - RHD (UK, Australia) User Guide

Levels

11 0

Cooling system

Only use the ﬂ uid recommended by the
manufacturer.
Otherwise, you risk seriously damaging
your engine.
When the engine is warm, the
temperature

Levels

11 0

Cooling system

Only use the ﬂ uid recommended by the
manufacturer.
Otherwise, you risk seriously damaging
your engine.
When the engine is warm, the
temperature of the coolant is controlled
by the engine fan. As this fan can
operate with the ignition key removed
and because the cooling system is
pressurised, wait for at least one hour
after the engine has stopped before
carrying out any work.
Slacken the cap by 1/4 of a turn to
release the pressure to prevent any
risk of scalding. When the pressure
has dropped, remove the cap and top
up the level with coolant.
If ﬂ uid has to be added frequently,
this indicates a fault which must be
checked by a PEUGEOT dealer as
soon as possible.

Power steering fluid level

The vehicle must be parked on level
ground with the engine cold. Unscrew
the cap integrated with the gauge and
check the level which must be between
the MIN and MAX marks. In order to regenerate the ﬁ lter, you
are advised to drive at a speed higher
than 40 mph (60 km/h) for at least ﬁ ve
minutes as soon as possible, when
trafﬁ c conditions permit (until the
message disappears and the service
warning lamp goes off).
During regeneration of the particle
emission ﬁ lter, the noise of a relay
operating may be heard under the
dashboard.
If the message is still displayed and
if the service warning lamp remains
on, consult a PEUGEOT dealer or a
qualiﬁ ed workshop.

Topping up
The level must be between the MIN
and MAX marks on the expansion
bottle. If more than 1 litre of ﬂ uid is
required to top up the level, have
the system checked by a PEUGEOT
dealer or a qualiﬁ ed workshop.

Screenwash and headlamp
wash level
For best quality cleaning and for your
safety, we would advise that you use
products of the PEUGEOT range.
For optimum cleaning and to avoid
freezing, this ﬂ uid must not be topped
up or replaced with plain water.
Capacity of the screenwash reservoir:
approximately 3 litres.
If your vehicle is ﬁ tted with headlamp
washers, the capacity of the reservoir
is 6 litres.

Diesel additive level
(Diesel with particle
emission filter)

Topping up
This additive must be topped up by
a PEUGEOT dealer or a qualiﬁ ed
workshop without delay.

Waste products

Avoid prolonged contact of used oil
with the skin.
Brake ﬂ uid is harmful to health and
very corrosive.
Do not dispose of used oil, brake ﬂ uid
or coolant into drains or into the ground
but into the containers dedicated to this
use at PEUGEOT dealer (France) or
an authorised waste disposal site. The minimum level of this additive
is indicated by lighting of the service
warning lamp, accompanied by an
audible signal and a message in the
screen.
When this occurs with the engine
running it is due to the start of
saturation of the particle emission ﬁ lter
(exceptionally prolonged urban type
driving conditions: low speed, long
trafﬁ c jams, ...).

Page 113 of 236

Peugeot Partner 2013 - RHD (UK, Australia) User Guide 111
CHECK
S
6

Checks

CHECKS

Carbon filter and passenger
compartment filter
The carbon ﬁ lter permits continuous
and effective ﬁ ltering of dust.
If the passenger compartmen

111
CHECK
S
6

Checks

CHECKS

Carbon filter and passenger
compartment filter
The carbon ﬁ lter permits continuous
and effective ﬁ ltering of dust.
If the passenger compartment ﬁ lter
becomes blocked, this may reduce the
performance of the air conditioning
system and generate unpleasant
odours.
We recommend the use of a combined
passenger compartment ﬁ lter. By
means of its second special active
ﬁ lter, it contributes to the puriﬁ cation
of the air breathed by the occupants
and the cleanness of the passenger
compartment (reduction of allergic
symptoms, unpleasant odours and
greasy deposits).

Particle emission filter (Diesel)

maintenance of the particle emission
ﬁ lter must be carried out by a
PEUGEOT dealer.
On acceleration after the vehicle has
been running for a prolonged period
at very low speed or at idle, you may,
in exceptional circumstances, notice
the emission of water vapour at the
exhaust. This water vapour does not
have any adverse effect on vehicle
handling or the environment.

Battery

At the start of winter, have your battery
checked by a PEUGEOT dealer or a
qualiﬁ ed workshop.

Brake pads

Brake pad wear depends on the style
of driving, in particular for vehicles
which are used in town, over short
distances. It may be necessary to
check the thickness of the pads, even
between services.
Unless there is a leak on the circuit,
a drop in the brake ﬂ uid level indicates
that the brake pads are worn.

Brake disc / drum wear

For information on checking the brake
disc / drum wear, consult a PEUGEOT
dealer.

Parking brake
Where the parking brake travel is too great
or there is a reduction in the performance
of the system, the parking brake should be
adjusted, even between services.
Have the system checked by a PEUGEOT
dealer or a qualiﬁ ed workshop.

Oil filter

Change the ﬁ lter regularly in
accordance with the servicing
schedule. Refer to the servicing and warranty
booklet for the replacement interval for
these components.
Depending on the environment (dusty
atmosphere...) and the use of the
vehicle (urban driving...), change them
twice as often if necessary.