ignition Peugeot Partner VU Dag 2004 Owner's Guide

HORNPress one of the spokes or the centre of the steeringwheel.
YOUR PARTNER IN DETAIL
76
22-12-2003
STEERING WHEEL HEIGHT ADJUSTMENT
When stationary, push the handle fowards to unlock the steeringwheel. Adjust it to the desired height. Pull the handle towards you fully to lockthe steering wheel.HAZARD WARNING LIGHTS Press the button, the direction indi- cators flash. They can operate with the ignition
off.

YOUR PARTNER IN DETAIL81
22-12-2003
CRUISE CONTROL Cruise control enables the vehicle to maintain a steady speed programmed
by the driver, regardless of the roadcharacteristics and without the driverhaving to touch the accelerator orbrake pedals. In order for it to be memorised, the vehicle speed must be greater than25 mph (40 km/h), and fourth gear atleast must be engaged.Operation 
Place switch 1in the ONposition.
A speed can be memorised. Place switch 1in the OFF position
to cancel.
Memorising a speedAs soon as you reach the chosen speed, press button 2or 3. This
memorises the speed, which will be
maintained automatically. Note: It is possible to accelerate and
drive momentarily at a speed greater than the memorised speed. Whenthe accelerator pedal is released, thevehicle will return to the memorisedspeed.
Cancelling the memorised speed If you wish to cancel the memorised speed:  press button 4or the brake or clutch
pedal.
Recalling the memorised speedAfter cancellation, press button 4.
Your vehicle will return to the last memorised speed. Changing a memorised speed
To memorise a speed higher than the previous one: 
press button 3;
 release it when you have reached the required speed.
To memorise a speed lower than theprevious one:  press button 2;
 release it when you have reached the required speed.
Cancelling the cruise control  Place switch 1in the OFFposition
or switch off the ignition.
Do not use cruise control on slippery roads or in heavytraffic.

Disarming the passenger air bag*
To ensure the safety of your child, it is essential to disarm the pas-senger air bag when you install arear-facing child seat on the frontpassenger seat. With the ignition switched off, insert the key into the passengerair bag disarming switch 1, turn it
to the "OFF" position, then
remove the key keeping the slotin this position.
The air bag warning light on theinstrument panel is lit throughoutthe disarming process.
YOUR PARTNER IN DETAIL
82
22-12-2003
FRONT AIR BAGS These are folded in the centre of the steering wheel for the driver and in
the fascia for the front passenger.
They are deployed simultaneously,except in cases where the passen-ger air bag is disarmed. Front air bag fault
If this warning light comeson on the instrument panel, accompanied by anaudible signal, contact a
PEUGEOT dealer to have
the system checked.
AIR BAGS
The air bags have been designed to maximise the safety of the occu-pants in the event of serious colli-
sions. They work in conjunction withthe pretensioning seat belts. The electronic detectors register and analyse any abrupt decelerationof the vehicle: if the triggeringthreshold is reached, the air bagsinflate instantly and protect theoccupants of the vehicle. Immediately after the impact, the air bags deflate rapidly so that they donot hinder the visibility of the occu-pants nor their exit if necessary fromthe vehicle. The air bags are not deployed in the case of collisions which are not seri-
ous, for which the seat belt is suffi-cient to ensure maximum protection.The seriousness of a collisiondepends on the nature of the obsta-cle and the speed of the vehicle atthe moment of the collision. Air bags only operate when the ignition is switched on. Note:
the gas escaping from the air
bags can be a minor irritant.
* According to destination.

YOUR PARTNER IN DETAIL83
22-12-2003
In the
"OFF" position, the passen-
ger air bag will not be triggered in the event of an impact. As soon as the child seat is removed, turn the air bag slot to the"ON" position to re-activate the air
bag and thus ensure the safety ofyour passenger in the event of animpact. Operating check This is confirmed by an indicator light, accompanied by an audiblesignal.
With the ignition on (2ndnotch), illumination of thiswarning light accompaniedby an audible signal, indi-cates that the passenger
air bag is disarmed (switch in the"OFF" position). SIDE AIR BAGS* These are incorporated into the frame of the front seat backs, on thedoor side. They are deployed independently of each other depending on which sidethe collision occurs, in collisionswhich could cause injury to thechest, the abdomen or the head. Air bag fault
If this warning light comes on, accompanied by anaudible signal, contact a
PEUGEOT dealer to havethe system checked.
* According to destination.

YOUR PARTNER IN DETAIL83
22-12-2003
In the
"OFF" position, the passen-
ger air bag will not be triggered in the event of an impact. As soon as the child seat is removed, turn the air bag slot to the"ON" position to re-activate the air
bag and thus ensure the safety ofyour passenger in the event of animpact. Operating check This is confirmed by an indicator light, accompanied by an audiblesignal.
With the ignition on (2ndnotch), illumination of thiswarning light accompaniedby an audible signal, indi-cates that the passenger
air bag is disarmed (switch in the"OFF" position). SIDE AIR BAGS* These are incorporated into the frame of the front seat backs, on thedoor side. They are deployed independently of each other depending on which sidethe collision occurs, in collisionswhich could cause injury to thechest, the abdomen or the head. Air bag fault
If this warning light comes on, accompanied by anaudible signal, contact a
PEUGEOT dealer to havethe system checked.
* According to destination.

PRACTICAL INFORMATION
88
22-12-2003
CHECKING THE LEVELS Oil level Check the level regularly and top up
between changes. The maximum consumption is 0.5 l per 1 000 km. Check the level with the vehicle on level ground, engine cold, using the oillevel gauge on the instrument panel orthe dipstick. Dipstick
There are two marks on the dipstick: A=maximum
Never fill past this mark.B= minimum
To maintain the reliability of engines and emissioncontrol systems, the useof additives in engine oilis prohibited. Viscosity selection In all cases, the oil selected must meet the manufacturer's requirements.
Brake fluid level:
Ð The level must always be between the DANGER and MAXI-
MUM marks in the reservoir.
Ð If the level drops substantially, contact a PEUGEOT dealer
immediately.
Fluid change:
Ð Must be carried out according to the manufacturer's servicing schedule.
Ð Use fluids recommended by the manufacturer, which fulfil DOT4standards.
Note: Brake fluid is harmful to health
and very corrosive. Avoid all contactwith the skin. Cooling system Use the fluid recommended by the
manufacturer. When the engine is warm, the tem- perature of the coolant is controlled
by the engine fan. As this fan canoperate with the ignition keyremoved and because the coolingsystem is pressurised, wait for atleast one hour after the engine hasstopped before carrying out anywork. Slacken the cap to the first notch torelease the pressure to prevent anyrisk of scalding. When the pressurehas dropped, remove the cap andtop up the level. Note:
The coolant does not need to
be changed. Used oil Do not dispose of used oil, brake fluid or coolant into drains or into theground. Power steering reservoir  Open the reservoir, with the engine at ambient temperature.The level should always beabove the MIN. mark and closeto the MAX. mark.
Windscreen and headlamp* wash level For best quality cleaning and for
your safety, we advise that youuse products recommended by
PEUGEOT.
* According to destination.
Oil change According to the information given in
"PEUGEOT SERVICING" .
Note: avoid used oil coming into
prolonged contact with the skin.

PRACTICAL INFORMATION
90
22-12-2003
CHANGING A WHEEL Parking the vehicle
Ð If possible, park the vehicle on
level, stable and non-slippery ground.
Ð Apply the handbrake, switch off the ignition and engage first or
reverse gear.
Access to the spare wheel andthe jack The wheel is located outside the
vehicle, under the rear floor,
supported by a metal carrier.
Ð Remove the jack and the wheel- brace 1, secured behind the
driver's seat. Ð Using the wheelbrace
1, slacken the spare wheel carrier retaining bolt, located
on the inside near the closing system.
Ð Lift the carrier to release the hook rearwards, then lower it.
Ð Remove the chock 2located in the spare wheel.
Removing a wheel
Ð Chock the rear of the wheel diagonally opposite the wheel to be changed, using the chock 2.
Ð Remove the wheel trim using the wheelbrace 1, by pulling at the valve
passage hole.
Ð Slacken the wheel bolts.
Ð Place the jack under the locating point on the sub-frame Athat is closest to
the wheel to be changed. Ensure that the entire surface of the jack base plate is in contact with the ground.
Ð Extend the jack, completely unscrew the bolts and remove the wheel.

PRACTICAL INFORMATION
100
22-12-2003
BATTERY
To charge the battery using a battery charger:
Ð Disconnect the battery,
Ð Follow the instructions for use given by the battery charger manufacturer,
Ð Reconnect starting with the negative (Ð) terminal,
Ð Check that the terminals and connectors are clean. If they are covered with
sulphate (white or greenish deposit), disconnect them and clean them.
To start the vehicle from another battery:
Ð Connect the red cable to the positive (+) terminals of the two batteries,
Ð Connect one end of the green or black cable to the negative (Ð) terminal of the slave battery,
Ð Connect the other end of the green or black cable to an earth point on the broken down vehicle as far as possible from the battery.
Operate the starter, let the engine run.
Wait for the engine to return to idle, then disconnect the cables.
Ð Never disconnect a terminal when the engine is running.
Ð Never charge a battery without first disconnecting the terminals.
Ð After every reconnection of the battery, switch on the ignition and wait 1 minute before starting to allow the electronic systems to be initialised. If slight difficulties are experienced after this, please
contact a PEUGEOT dealer. A flat battery will preventthe engine from starting.
It is advisable to disconnect the battery if the vehicle is not to be used
for a period of more than one month.
ECONOMY MODE FUNCTION After the engine has stopped, with the key in the accessories position,
certain functions (windscreen wiper,electric windows, courtesy lights,audio equipment etc.) can only beused for thirty minutes, to prevent
discharging the battery.
Once the thirty minutes are over, the message "Eco mode active"
appears on the multifunction displayand the active functions are put on
standby.