inflation pressure Peugeot RCZ 2011 Owner's Manual

100








TYRE UNDER-INFLATION DETECTION

System which automatically and continuously checks the pressure of
the tyres while driving.
The tyre under-infl ation detection system is an aid to driving which
does not replace the need for the driver to be vigilant or to drive
responsibly. Sensors fi tted in each valve trigger a warning in the event of malfunction
(speed above 12 mph (20 km/h)).

Under-inflated tyre

This warning lamp is displayed in the instrument panel
accompanied by an audible signal and an alert message
identifying the wheel concerned.


)
Check the tyre pressures as soon as possible.
This check must be carried out when the tyres are cold.









HORN


Audible warning to alert other road users to an imminent danger.


)
Press one of the spokes of the steering wheel.










EMERGENCY OR ASSISTANCE
CALL
This system allows you to make an emergency or assistance call to the
emergency services or to the dedicated PEUGEOT service.
For more information on the use of this function, refer to the "Audio and
telematics" section.

05 km
3,5 miles 20-60 km/h max
15-35 mph max
0
156

)
Switch on the compressor by moving the switch B
to position "I"

until the tyre pressure reaches 2.0 bars.
The sealant is injected into the tyre under pressure; do not
disconnect the pipe from the valve during this operation (risk of
splashing).
)
Remove the kit and screw the cap back on the white pipe.
Take care to avoid staining your vehicle with traces of fl uid. Keep
the kit to hand.

)
Drive immediately for approximately three miles (fi ve kilometres), at
reduced speed (between 15 and 35 mph [20 and 60 km/h]), to plug
the puncture.

)
Stop to check the repair and the tyre pressure using the kit.


If after around 5 to 7 minutes the pressure is not attained, this
indicates that the tyre is not repairable; contact a PEUGEOT
dealer or a qualifi ed workshop for assistance.



Tyre under-inflation detection

If the vehicle is fi tted with tyre under-infl ation detection, the under-
infl ation warning lamp will remain on after the wheel has been
repaired until the system is reinitialised by a PEUGEOT dealer or
a qualifi ed workshop.

8/
00
0
0
0
PRACTICAL INFORMATION

2. Inflation



)
Turn the selector A
to the "air" position.

)
Uncoil the black pipe H
fully.

)
Connect the black pipe to the valve of the wheel.

)
Visit a PEUGEOT dealer or a qualifi ed workshop as soon as
possible.
You must inform the technician that you have used this kit.
After inspection, the technician will inform you whether the
tyre can be repaired or must be replaced.


)
Connect the compressor's electric plug to the vehicle's 12 V socket.

)
Start the vehicle again and leave the engine running.
)
Adjust the pressure using the compressor (to infl ate: switch B

in position "I"
; to defl ate: switch B
in position "O"
and press
button C
), in accordance with the vehicle's tyre pressure label
(located on the left hand door aperture).
A loss of pressure indicates that the puncture has not been fully
plugged; contact a PEUGEOT dealer or qualifi ed workshop for
assistance.

)
Remove and stow the kit.

)
Drive at reduced speed (50 mph [80 km/h] max) limiting the
distance travelled to approximately 120 miles (200 km).