ignition Peugeot RCZ 2012.5 Owner's Manual - RHD (UK, Australia)
[x] Cancel search | Manufacturer: PEUGEOT, Model Year: 2012.5, Model line: RCZ, Model: Peugeot RCZ 2012.5Pages: 336, PDF Size: 14.1 MB
Page 10 of 336
8
INSTRUMENTS AND CONTROLS
1.
Wipers / screenwash / trip computer
control stalk.
2.
Steering lock and ignition.
3.
Audio and telematic system steering
wheel control stalk.
4.
Driver's airbag.
Horn.
5.
Gear lever.
6.
Parking brake.
7.
Instrument panel.
8.
Speaker (tweeter).
9.
Side adjustable air vent.
10.
Passenger's airbag deactivation switch.
11 .
Manual headlamp height adjustment.
Page 17 of 336
FAMILIARISATION
MONITORING
The instrument panel has permanent back-
lighting for improved visibility in all situations,
both day and night.
- With the ignition on, the fuel gauge needle
should indicate the level of fuel remaining.
- With the engine running, its associated
low level warning lamp should go off.
- With the ignition on, the oil level indicator
should display "OK" or "correct",
depending on version, for a few seconds.
If the levels are not correct, top up the levels
which are low.
INSTRUMENT PANEL
62
22
- With the ignition on, the orange and red
warning lamps come on.
- With the engine running, these warning
lamps should go off.
If warning lamps remain on, refer to the page
concerned.
WARNING LAMPS
26 Illumination of the indicator lamp indicates the
status of the corresponding function.
A.
Emergency call.
SWITCH PANEL
57 202, 203
107
143
202, 203
B.
Deactivation of the interior volumetric and
anti-tilt sensors (alarm).
C.
Central locking.
D.
Deactivation of the ESC/ASR system.
E.
Deactivation of the front and rear parking
sensors.
F.
Access to PEUGEOT services.
Page 18 of 336
16
127
1.
Stop
position.
2.
Running
position.
3.
Starting
position.
IGNITION SWITCH
Avoid attaching any heavy objects to the
key which would weigh down on its shaft
in the ignition switch; this could cause a
malfunction.
PASSENGER SAFETY
)
Selection of the position:
"OFF"
(deactivated), with "rear facing"
child seat,
"ON"
(activated), with front passenger or
"forwards facing" child seat.
PASSENGER'S FRONT AIRBAG
115, 119
A.
Front and/or rear seat belts not fastened /
unfastened warning lamp.
B.
Front left seat belt warning lamp.
C.
Front right seat belt warning lamp.
D.
Rear right seat belt warning lamp.
E.
Rear left seat belt warning lamp.
F.
Passenger's front airbag deactivated
warning lamp.
G.
Passenger's front airbag activated
warning lamp.
SEAT BELTS AND
PASSENGER'S FRONT AIRBAG
111, 115, 119
Page 25 of 336
1/
INSTRUMENTS and CONTROLS
DISPLAYS
*
According to engine.
**
Only on the large central display screen.
***
Only on the large central display screen with Peugeot Connect Media (NG4 3D).
Small display screen
A.
Trip distance recorder.
(miles or km)
B.
Distance recorder.
(miles or km)
C.
Service spanner,
if a service is due shortly or is overdue.
Central display screen
D. Speed limiter
(mph or km/h) or
Cruise control.
E. Indication:
- of a gear change * (manual gearbox),
or
- of the programme or gear (automatic gearbox).
F. Engine oil level indicator,
service indicator.
(miles or km)
These two functions are displayed when the ignition is switched on,
then disappear after a few seconds.
Warning and status indicator lamps / CHECK.
Tyre under-infl ation detection.
Trip computer.
Vehicle speed repeat ** .
Vehicle parameters ** .
Navigation - Guidance *** .
These six functions are displayed according to the selection.
Page 28 of 336
26
WARNING AND INDICATOR LAMPS
Visual indicators which inform the driver of the occurrence of a
fault (warning lamp) or of the operation of a system (operation or
deactivation indicator lamp).
When the ignition is switched on
Certain warning lamps come on for a few seconds when the ignition is
switched on.
When the engine is started, these warning lamps should go off.
If they remain on, before moving off, refer to the information for the
warning lamp concerned.
Associated warnings
The illumination, fi xed or fl ashing, of certain warning lamps may be
accompanied by an audible signal and a message in the screen.
Depending on your version of instrument panel, illumination of the
warning lamp is also accompanied by:
- a symbol in the central instrument panel screen and a message in
the multi-function screen,
or
- a symbol and a message in the central instrument panel screen.
Warning lamps
When the engine is running or the vehicle is being driven, the
illumination of one of the following warning lamps indicates a fault which
requires action on the part of the driver.
The illumination of a warning lamp is always accompanied by the
display of an additional message, to assist you in identifying the
fault.
If you encounter any problems, contact a PEUGEOT dealer or a
qualifi ed workshop.
Page 29 of 336
1/
INSTRUMENTS and CONTROLS
Warning lamp
is on
Cause
Action / Observations
STOP
fi xed, alone
or associated
with another
warning lamp,
accompanied by
an audible signal
and a message
in the screen. Illumination of this warning
lamp is associated with a
serious braking system, power
steering, engine lubrication or
cooling system malfunction or a
punctured tyre. Stop as soon as it is safe to do so as there is a risk that the
engine will cut out while driving.
Park, switch off the ignition and contact a PEUGEOT
dealer or a qualifi ed workshop.
Maximum
coolant
temperature
fi xed with the
needle in the red
zone. The temperature of the cooling
system is too high. Stop as soon as it is safe to do so.
Wait until the engine has cooled down before topping up
the level, if necessary.
If the problem persists, contact a PEUGEOT dealer or a
qualifi ed workshop.
Braking
fi xed, associated
with the STOP
warning lamp. The braking system fl uid level is
too low. You must stop as soon as it is safe to do so.
Top up with brake fl uid recommended by PEUGEOT.
If the problem persists, have the system checked by a
PEUGEOT dealer or a qualifi ed workshop.
+
fi xed, associated
with the STOP
and ABS warning
lamp. The electronic brake force
distribution (EBFD) system has
a fault. You must stop as soon as it is safe to do so.
Have it checked by a PEUGEOT dealer or a qualifi ed
workshop.
Page 30 of 336
28
Engine
autodiagnosis
system
fl ashing. The engine management system
has a fault. Risk of destruction of the catalytic converter.
Have it checked by a PEUGEOT dealer or a qualifi ed
workshop.
fi xed. The emission control system has
a fault. The warning lamp should go off when the engine is started.
If it does not go off, contact a PEUGEOT dealer or qualifi ed
workshop without delay.
Low fuel level
fi xed with the
needle in the
red zone,
accompanied by
an audible signal
and a message. When it fi rst comes on there
remains approximately 5 litres
of
fuel in the tank.
At this point, you begin to use the
fuel reserve. Refuel as soon as possible to avoid running out of fuel.
Until suffi cient fuel has been added, this warning lamp
will come on every time the ignition is switched on,
accompanied by an audible signal and a message.
The audible signal and message are repeated with
increasing frequency as the fuel level drops towards "0"
.
Fuel tank capacity: approximately 55 litres
.
Never continue to drive until you run out of fuel, as this
could damage the emission control and injection systems.
Warning lamp
is on
Cause
Action / Observations
Service
temporarily,
accompanied by
a message. Minor faults have occurred for
which there is no specifi c warning
lamp. Identify the fault by reading the message displayed in the
screen, such as:
- doors, boot or bonnet open,
- low engine oil level,
- low screenwash/headlamp wash reservoir level,
- remote control battery fl at,
- low tyre pressures,
- saturation of the particle emission fi lter on Diesel
vehicles (see "Checks" - "Checking levels / Particle
emissions fi lter" section).
For any other faults, contact a PEUGEOT dealer or a
qualifi ed workshop.
fi xed,
accompanied by
a message and
an audible signal. Major faults have occurred for
which there is no specifi c warning
lamp. Identify the fault by reading the message shown in the
screen and you must then contact
a PEUGEOT dealer or
a qualifi ed workshop.
Page 33 of 336
1/
INSTRUMENTS and CONTROLS
Warning lamp
is on
Cause
Action / Observations
Rear foglamp
fi xed. The rear foglamp is switched on. Turn the ring on the stalk rearwards to switch off the rear
foglamp.
Diesel engine
pre-heating
fi xed. The ignition switch is at the
2nd position (ignition on). Wait until the warning lamp has switched off before starting.
The duration for which the warning lamp is on is
determined by the climatic conditions.
Parking
brake
fi xed. The parking brake is applied or
not properly released. Release the parking brake to switch off the warning lamp,
keeping your foot on the brake pedal.
Observe the safety recommendations.
For further information on the parking brake, refer to the
"Parking brake" section.
Passenger's
front airbag
fi xed on the
seat belt and
passenger's front
airbag warning
lamps display. The control switch, located on
the passenger's side of the
dashboard, has been placed in
the "ON"
position.
The passenger's front airbag is
activated.
In this case, do not install
a "rear facing" child seat. While you do not have a rear-facing child seat fi tted to
the front passenger seat, it is recommended that the
passenger's front airbag be activated.
On the other hand, before fi tting a rear-facing child seat,
you must turn the control switch to the "OFF"
position.
Page 35 of 336
1/
INSTRUMENTS and CONTROLS
COOLANT TEMPERATURE INDICATOR
With the engine running, when the needle is:
- in zone A
, the temperature is correct,
- in zone B
, the temperature is too high; the maximum temperature
warning lamp and the central STOP
warning lamp come on,
accompanied by an audible signal and an alert message in the
screen.
You MUST stop as soon as it is safe to do so.
Wait a few minutes before switching off the engine.
Contact a PEUGEOT dealer or a qualifi ed workshop.
ENGINE OIL LEVEL INDICATOR
This information is displayed for a few seconds when the ignition is
switched on, at the same time as the service information.
The vehicle must be on level ground and the engine must have
been off for more than 30 minutes for this level check to be
accurate. After driving for a few minutes, the temperature and pressure in the
cooling system increase.
To top up the level:
)
wait for the engine to cool,
)
unscrew the cap by two turns to allow the pressure to drop,
)
when the pressure has dropped, remove the cap,
)
top up the level to the "MAX" mark.
Page 37 of 336
1/
INSTRUMENTS and CONTROLS
SERVICE INDICATOR
This information is displayed for a few seconds when the ignition is
switched on. It informs the driver when the next service is due, in
accordance with the manufacturer's servicing schedule.
The point at which the service is due is calculated from the last indicator
zero reset. It is determined by two parameters:
- the distance travelled,
- the time elapsed since the last service.
More than 1 800 miles (3 000 km) remain before the next service is due
When the ignition is switched on, no service information appears on the
instrument panel central screen.
Between 600 miles (1 000 km) and 1 800 miles (3 000 km)
remain before the next service is due
For 7 seconds after the ignition is switched on, the spanner symbolising
the service operations comes on. The instrument panel central screen
indicates the distance remaining before the next service is due.
Example:
1 700 miles remain before the next service is due.
For 7 seconds after the ignition is switched on, the central screen
indicates:
Less than 600 miles (1 000 km) remain before the next service is due
Example:
500 miles remain before the next service is due.
For 7 seconds after the ignition is switched on, the central screen
indicates:
The spanner remains on
in the small screen
to indicate that a service must be carried out
soon.