Peugeot RCZ 2013 Owner's Manual
Manufacturer: PEUGEOT, Model Year: 2013, Model line: RCZ, Model: Peugeot RCZ 2013Pages: 336, PDF Size: 14.12 MB
Page 181 of 336
8/
PRACTICAL INFORMATION
Changing sidelamps and direction indicators
For the replacement of this type of LED lamp, contact a PEUGEOT
dealer or a qualifi ed workshop.
High pressure washing
When using this type of washing on stubborn dirt, do not persist
on the headlamps, the lamps and their surrounds to avoid
damaging their protective coating and seals.
Changing number plate lamps (W5W)
)
Insert the end of the vehicle's key in the hole in the transparent
cover.
)
Push towards the outside to unclip it.
)
Remove the transparent cover.
)
Pull the bulb out and change it.
Changing the third brake lamp (LEDs)
For the replacement of this type of LED lamp, contact a PEUGEOT
dealer or a qualifi ed workshop.
Page 182 of 336
180
CHANGING A FUSE
ACCESS TO THE TOOLS
The extraction tweezer is fi tted to the back of the dashboard fusebox
cover.
To gain access to them:
)
turn the screw a quarter of a turn to the left,
)
unclip the cover by pulling at the top right,
)
remove the cover completely and turn it over,
)
remove the carrier on which is fi tted the tweezer.
CHANGING A FUSE
Before changing a fuse, tit is necessary to:
)
identify the cause and correct it,
)
switch off all electrical consumers,
)
immobilise the vehicle and switch off the ignition,
)
identify the failed fuse using the allocation tables and drawings
presented on the following pages.
To replace a fuse, you must:
- use the special tweezer to extract the fuse from its housing and
check the condition of its fi lament,
- always replace a failed fuse with a fuse of the same rating (same
colour); a different rating fuse may cause malfunctions (risk of fi re).
Good
Failed
Tweezer
If the fault recurs soon after changing a fuse, have the electrical
system of your vehicle checked by a PEUGEOT dealer or a
qualifi ed workshop.
Page 183 of 336
8/
PRACTICAL INFORMATION
Installing electrical accessories
Your vehicle's electrical system is designed to operate with
standard or optional equipment.
Before installing other electrical equipment or accessories on your
vehicle, contact a PEUGEOT dealer or a qualifi ed workshop.
PEUGEOT will not accept responsibility for the cost incurred in
repairing your vehicle or for rectifying malfunctions resulting from
the installation of accessories not supplied and not recommended
by PEUGEOT and not installed in accordance with its instructions,
in particular when the combined consumption of all of the
additional equipment connected exceeds 10 milliamperes.
Page 184 of 336
182
DASHBOARD FUSES
The fusebox is placed in the lower section of the dashboard (left-hand
side). It consists of two boxes.
Access to the fuses
)
Refer to the paragraph "Access to the tools".
Fuse tables
Fuse N°
Rating
Functions
F1
-
Not used.
F2
30 A
Locking and deadlocking earth.
F3
5 A
Airbags, active bonnet and pretensioners
control unit.
F4
10 A
Clutch pedal switch, electrochromatic
rear view mirror, automatic gearbox,
switching and protection unit.
F5
30 A
One-touch electric windows, folding door
mirrors supply.
F6
-
Not used.
F7
5 A
Front and rear courtesy lamps, map
reading lamps, sun visor lighting, glove
box lighting.
F8
20 A
Audio equipment, audio/telephone,
multifunction screen, tyre under-infl ation
detection, clock,
F9
30 A
12 V socket.
F10
15 A
Steering mounted controls.
F11
15 A
Low current ignition switch.
F12
15 A
Instrument panel, air conditioning,
driver's seat memory unit, rain /
sunshine sensor, airbags.
Box 1
Page 185 of 336
8/
PRACTICAL INFORMATION
Fuse N°
Rating
Functions
F13
5 A
Engine fusebox, active bonnet.
F14
15 A
Multifunction screen, seat belt and
passenger's front airbag warning lamps
display, instrument panel screen,
amplifi er, Bluetooth system, parking
sensors control unit, USB Box.
F15
30 A
Locking and deadlocking.
F17
40 A
Rear screen and door mirrors demist/
defrost.
SH
-
PARC shunt.
Fuse N°
Rating
Functions
G36
30 A
Hi-Fi amplifi er.
G37
30 A
Passenger's seat memory unit.
G38
30 A
Driver's seat memory unit.
G39
5 A
Lighting memory unit.
G40
30 A
Driver and passenger heated
seats.
Box 2
Page 186 of 336
184
ENGINE COMPARTMENT FUSES
The fusebox is placed in the engine compartment near the battery
(left-hand side).
Access to the fuses
)
Unclip the cover.
)
Change the fuse (see corresponding paragraph).
)
When you have fi nished, close the cover carefully to assure the
sealing of the fusebox.
Fuse table
Fuse N°
Rating
Functions
F1
20 A
Engine control unit supply, injection
pump and EGR electrovalves (Diesel),
injectors (Diesel).
F2
15 A
Horn.
F3
10 A
Front wash-wipe.
F4
20 A
Daytime running lamps.
F5
15 A
Air fl ow sensor, coolant pump, oil pump,
thermostat, blow-by heater (petrol),
by-pass and EGR electrovalves (Diesel),
diesel heater (Diesel).
F6
10 A
Steering wheel angle sensor, ABS/ESC
control unit, ESC sensor.
F7
10 A
Power steering control unit, automatic
gearbox, engine coolant level detector,
dual function brake switch.
F8
25 A
Starter motor control.
F9
10 A
Diagnostic socket, directional
headlamps, particle emission fi lter pump
(Diesel).
F10
30 A
Engine control unit actuators (petrol:
ignition coils, electrovalves, injectors,
fuel pump (Diesel: electrovalves,
heaters).
F11
40 A
Air conditioning blower.
Page 187 of 336
8/
PRACTICAL INFORMATION
Fuse N°
Rating
Functions
F12
40 A
Windscreen wipers slow / fast speed.
F13
40 A
Built-in systems interface supply
(ignition positive).
F14
-
Not used.
F15
10 A
Right-hand main beam headlamp.
F16
10 A
Left-hand main beam headlamp.
F17
15 A
Left-hand dipped headlamp.
F18
15 A
Right-hand dipped headlamp.
F19
15 A
Variable timing electrovalve, oxygen
sensors (petrol), electrovalves (Diesel).
F20
10 A
Turbine discharge and canister purge
electrovalves (petrol), air fl ow sensor
(1.6 litre THP 200), water in Diesel
sensor (Diesel).
F21
5 A
Fans control, Turbo pump (petrol),
Valvetronic motor (1.6 litre THP 200).
Page 188 of 336
186
Table of fuses over the battery
Fuse N°
Rating
Functions
F1
-
Not used.
F2
5 A
Dual function brake switch.
F3
5 A
Battery charge unit.
F4
25 A
ABS/ESC electrovalves.
F5
-
Not used.
F6
15 A
Automatic gearbox. All work on the other types of fuses (midi-fuses and maxi-fuses)
must be carried out only by a PEUGEOT dealer or a qualifi ed
workshop.
Page 189 of 336
8/
PRACTICAL INFORMATION
TOWING A VEHICLE
TOWING EYE
This is stored in the boot under the fl oor.
For access to it:
)
open the boot,
)
raise the fl oor using the strap,
)
secure it in the vertical position beyond the stops, located on the
sides of the boot,
)
remove the towing eye from the storage box.
GENERAL RECOMMENDATIONS
Observe the legislation in force in your country.
Ensure that the weight of the towing vehicle is higher than that of
the towed vehicle.
The person at the wheel of the towed vehicle must have a valid
driving licence.
When towing a vehicle with all four wheels on the ground, always
use an approved towing bar; rope and straps are prohibited.
When towing a vehicle with the engine off, there is no longer any
power assistance for braking or steering.
In the following cases, you must always call on a professional
recovery service:
- vehicle broken down on a motorway or fast road,
- 4 wheel drive vehicle,
- when it is not possible to put the gearbox into neutral, unlock
the steering, or release the parking brake,
- towing with only two wheels on the ground,
- where there is no approved towing bar available...
Page 190 of 336
188
TOWING YOUR VEHICLE
)
On the front bumper, unclip the cover by pressing at the bottom.
)
Screw the towing eye in fully.
)
Install the towing bar.
)
Place the gear lever in neutral (position N
on the automatic
gearbox).
Failure to observe this instruction could result in damage to certain
components (braking, transmission...) and the absence of braking
assistance the next time the engine is started.
)
Unlock the steering by turning the ignition key one notch and
release the parking brake.
)
Switch on the hazard warning lamps on both vehicles.
)
Move off gently and drive slowly and for a short distance only.
TOWING ANOTHER VEHICLE
)
On the rear bumper, unclip the cover by pressing at the bottom.
)
Screw the towing eye in fully.
)
Install the towing bar.
)
Switch on the hazard warning lamps on both vehicles.
)
Move off gently and drive slowly and for a short distance only.