warning PONTIAC FIREBIRD 1994 Owner's Manual
[x] Cancel search | Manufacturer: PONTIAC, Model Year: 1994, Model line: FIREBIRD, Model: PONTIAC FIREBIRD 1994Pages: 290, PDF Size: 14.84 MB
Page 153 of 290

Problems on the Road
Hazard Warning
Flashers
Your hazard warning flashers let you
warn others. They also let police know
you have a problem. Your front and rear
turn signal lights will flash on and
off.
J
Press the button in to make your front and
rear turn signal lights flash on and
off.
Your hazard warning flashers work no
matter what position your key
is in, and
even if the key isn't in.
'0 turn off the flashers, pull out on the
ollar.
Vhen the hazard warning flashers are on,
our
turn signals won't work.
Ither Warning Devices
F you carry reflective triangles, you can
et one up at the side of the road about
00 feet (100 m) behind your vehicle.
. . .152
ProCarManuals.com
Page 157 of 290

Problems on the Road
9.
IO.
Attach the cable at least 18 inches
(45 cm) away from the dead battery,
but not near engine parts that move.
The electrical connection is just as
good there, but the chance of sparks
getting back to the battery is much
less.
Now start the vehicle with the good
battery and run the engine for a
while.
11.
12.
Try to start the vehicle with the dead
battery.
If it won't start after a few tries, it
probably needs service.
Remove the cables in reverse order
to prevent electrical shorting. Take
care that they don't touch each other
or any other metal.
A. Heavy Metal Engine Part
B. Good Battery
C. Dead Battery
I I
T.
tc
U!
(1
tc
If
ac
ac
tl
nl
B
h,
n
1 Towing Your Vehicle
ry to have a GM dealer or a professional
,wing service tow your Pontiac. The
sua1 towing equipment is a sling-type
4) or a wheel-lift (B) or car carrier (C)
)w truck.
' your vehicle has been changed or
hodified since it was factory-new by
iding aftermarket items like fog lamps,
xo skirting, or special tires and wheels,
lese instructions and illustrations may
ot be correct.
'efore you do anything, turn on the
azard warning flashers.
. . .I56
ProCarManuals.com
Page 162 of 290

I NOTICE:
Towing a vehicle over rough surfaces
could damage a vehicle. Damage
can occur from vehicle-to-ground
or vehicle-to-wheel-lift-equipment
contact.
To help avoid damage, install
a towing dolly and raise vehicle until
adequate clearance is obtained between
the ground and/or wheel-lift equipment.
Engine Overheating
I
If Steam Is Coming from Your Engine:
You will find a coolant temperature gage
on your Pontiac’s instrument panel.
You may also find a low coolant warning
light
on your Pontiac instrument panel.
161 .
ProCarManuals.com
Page 163 of 290

Problems on the Road
If your engine catches fire because
you keep driving with no coolant,
your vehicle can be badly darhaged.
The costly repairs would not be
covered by your warranty.
If No Steam Is Coming from Your
Engine:
If you get the overheat warning but see
or hear
no steam, the problem may not be
too serious. Sometimes the engine can gel
a little too hot when you:
Climb a long hill on a hot day.
Stop after high speed driving.
0 Idle for long periods in traffic.
0 Tow a trailer. If you
get the overheat warning with
no
sign of steam, try this for a minute or so:
1. If you have an air conditioner, turn it
2. Turn on your heater to full hot at the
off.
highest
fan speed and
open the
window as necessary.
3. Try to keep your engine under load
(in a drive gear where the engine runs
slower).
If you no longer have the overheat
warning, you can drive. Just to be safe,
drive slower for about
ten minutes. If the
warning doesn’t come back
on, you can
drive normally.
If the warning continues, pull over, stop,
and park your vehicle right away.
If there’s still no sign of steam,
you can
idle the engine for two or three minutes
while you’re parked, to see if the warning
stops. But then, if you still have the
warning, TURN
OFF THE ENGINE
AND GET EVERYONE OUT
OF THE
VEHICLE until it cools down.
You may decide not to lift the hood but to
get service help right away.
Cooling System
When you decide it’s safe to lift the hood,
here’s what you’ll see on the V6 engine:
1. Coolant recovery tank
2. Radiator pressure cap
3. Electric engine fan
. . .I62
ProCarManuals.com
Page 165 of 290

Problems on the Road
How to Add Coolant to the Coolant
Recovery Tank
If you haven’t found a problem yet, but
the coolant level isn’t at or above the
“FULL COLD’ mark, add a 50/50
mixture of clean water (preferably
distilled) and a proper antifreeze at the
coolant recovery tank. (See “Engine
Coolant” in the Index for more
information about the proper coolant
mix.)
NOTICE:
I
In cold weather, water can freeze
and crack the engine, radiator,
heater core and other parts. Use the
recommended coolant. When the coolant
in the coolant recovery
tank is at or above the “FULL COLD’
mark, start your vehicle.
If the overheat warning continues, there’s
one more thing
you can try. You can add
the proper coolant mix directly to the
radiator, but be sure the cooling system is
cool before
you do it.
. . ,164
ProCarManuals.com
Page 172 of 290

Changing a FIat Tire
If a tire goes flat, avoid further tire and
wheel damage by driving s’lowly to a level
place. Turn on your hazard warning
flashers. The
following steps will tell you how to
use the jack and change a tire.
The equipment you’ll need is
in the rear
area.
First you must remove the clcse-out
panel. See “Close-Out Panel” in the
Index.
On convertible models, you must also
remove the trunk access panel. It’s at the
upper back of the trunk. Turn the two
screw knobs under the trunk
edge a
quarter
turn counterclockwise to remove
lhe panel.
Find the plastic screw heads in
the trim
?anel over the spare tire. Use a coin or a
tey to turn the screw heads until the slots
mint front and back. Lift the
trim panel
md move it out
of the way.
I
171 ...
ProCarManuals.com
Page 196 of 290

When to Change Engine Oil:
See if any one of these is true for you:
Most trips are less than 4 miles
0 It’s below freezing outside and most
trips are less than
10 miles ( 16 km).
The engine is at low speed most of
the time (as in door-to-door delivery,
or
in stop-and-go traffic).
(6 km).
You tow a trailer often.
Most trips are through dusty places.
If any one of these is true for your
vehicle, then you need to change your
and filter every
3,000 miles (5 000 km) or
3 months - whichever comes first.
If none of them is true, change the oil
every
7,500 miles (12 500 km) or 12
months
- whichever comes first.
Change the filter at the first oil change
and at every other oil change after that.
Engine Coolant Heater (Engine Block
Heater):
An engine coolant heater can be a big
help if you have to park outside in very
cold weather,
0°F (-18°C) or colder. If
your vehicle has this option, see “Engine Coolant Heater” in the Index.
What to Do with Used Oil:
Did you know that used engine oil
:ontains elements that may be unhealthy
:or your skin and could even cause
:ancer? Don’t let used oil stay on your
;kin for very long. Clean your skin and
lails with soap and water, or a good hand
:leaner. Wash or properly throw away
:lothing or rags containing used engine
il. (See the manufacturer’s warnings
ibout the use and disposal of oil
xoducts.)
Used oil can be a real threat to the
mvironment. If you change your own oil,
)e sure to drain all free-flowing oil from
:he filter before disposal. Don’t ever
jispose of oil by putting it in the trash,
2ouring it on the ground, into sewers, or
into streams or bodies
of water. Instead,
recycle it by taking it to a place that
collects used oil. If you have a problem
properly disposing of your used oil, ask
your dealer, a service station or a local
recycling center for help.
3.4L L32 (Code S
Air Cleaner
iefer to the Maintenance Schedule to
letermine when to replace the air filter.
See “Scheduled Maintenance Services”
In the Index.
t
195 ...
ProCarManuals.com
Page 203 of 290

Service and Appearanc’e Care
The proper coolant for your Pontiac will:
0
Give freezing protection down to
-34°F (-37°C).
Give boiling protection up to 262°F
(128°C)
.
Protect against rust and corrosion.
Help keep the proper engine
temperature.
Let the warning lights work as
they
should.
What to Use:
Use a mixture of one-half clean water
(preferably distilled) and one-half
antifreeze that meets
“GM Specification
1825M,” which won’t damage aluminum
parts. You can also use a recycled coolant
conforming to GM Specification 1825M
with a complete coolant flush and refill. If
you use this mixture, you don’t need to
add anything else.
NOTICE:
If you use an improper coolant mix,
your engine could overheat and be
badly damaged. The repair cost wouldn’t be covered by your war-
ranty. Too much water in the mix can
freeze and crack the engine, radiator,
heater core and other parts.
Adding Coolant
To Check Coolant: When your engine is
cold, check the dipstick on the cap of the
coolant recovery tank. The coolant level should be “COLD,” or a little higher.
When your engine is warm, the level on
the dipstick should be up to
“HOT,” or a
little higher.
. . .202
ProCarManuals.com
Page 208 of 290

What to Add:
When you do need brake fluid, use only
DOT-3 brake fluid - such as Delco-
Supreme ll@
(GM Part No. 1052535).
Use new brake fluid from a sealed
container only, and always clean the
brake fluid reservoir cap before
removing it.
NOTICE:
Don’t let someone put in the
wrong kind of fluid. For example,
just
a few drops of mineral-based
oil, such as engine oil, in your
brake system can damage brake
system parts
so badly that they’ll
have to be replaced.
Brake fluid can damage paint,
so
be careful not to spill brake fluid on your vehicle. If you
do, wash it
off immediately. See “Appearance
Care”
in the Index.
Brake Wear
Unless you have the four-wheel disc
brake option, your Pontiac has front disc
brakes and rear drum brakes. Disc
brake pads have built-in wear
indicators that make a high-pitched
warning sound when the brake pads
are worn and new pads are needed. The
sound may come and
go or be heard all
the time your vehicle is moving (except
when you are pushing on the brake pedal
firmly).
I NOTICE:
I
Continuing to drive with worn-out
brake pads could result in costly
brake repair. Some driving conditions
or climates may
cause a brake squeal when the brakes are
first applied or lightly applied. This does
not mean something is wrong with your
brakes.
If you have rear drum brakes, they don’t
have wear indicators, but if you ever hear
a rear brake rubbing noise, have the rear
brake linings inspected. Also, the rear
brake drums should be removed and
inspected each time the tires are removed
for rotation or changing. When you have
the front brakes replaced, have
the rear
brakes inspected, too.
Brake linings should always be replaced
as complete axle sets.
Brake Pedal Travel
See your dealer if the brake pedal does
not return to normal height, or if there is a
rapid increase in pedal travel.
This could
be a sign
of brake trouble.
I.
207. . .
ProCarManuals.com
Page 220 of 290

Uniform Tire Quality Grading
The following information relates to the
system developed by the United States
National Highway Traffic Safety
Administration which grades tires by
treadwear, traction and temperature
performance.
(This applies only to
vehicles sold in the United States.)
Treadwear
The treadwear grade is a comparative
rating based on the wear rate of the tire
when tested under controlled conditions
on a specified government test course. For
example, a tire graded 150 would
wear one and a half
(1 1/2) times as well
on the government course as a tire graded
100. The relative performance of tires
depends upon the actual conditions of
their use, however, and may depart
significantly from the norm due to
variations in driving habits, service
practices and differences in road
characteristics and climate.
Traction - A, B, C
The traction grades, from highest to
lowest are: A,
B, and C. They represent
the tire’s ability to stop on wet pavement
as measured under controlled conditions
on specified government test surfaces of
asphalt and concrete. A tire marked C
may have poor traction performance.
Warning: The traction grade assigned to
this tire is based on braking
(straight-ahead) traction tests and does
not include cornering (turning) traction.
Temperature - A, B, C
The temperature grades are A (the
highest),
B, and C, representing the tire’s
resistance to the generation of heat and its
3bility to dissipate heat when tested under
:ontrolled conditions on a specified indoor
laboratory test wheel. Sustained
high temperature can cause the material
of the tire to degenerate and reduce tire
life, and excessive temperature can lead
to sudden tire failure. The grade
C
corresponds to a level of performance
which all passenger car tires must meet
under
the Federal Motor Vehicle Safety
Standard No.
109. Grades B and A
represent higher levels of performance
on the laboratory test wheel than the
minimum required by law.
Warning: The temperature grade for
this tire is established for a tire that is
properly inflated and not overloaded.
Excessive speed, underinflation, or
excessive loading, either separately ,,or
in combination, can cause heat buildup
and possible tire failure.
Those grades are molded on the sidewalls
of passenger car tires.
While the tires available as standard or
optional equipment on General Motors
vehicles may
vary with respect to these
grades, all such tires meet General Motors
performance standards and have been
approved for use on General Motors
vehicles. All passenger type
(P Metric)
tires must conform to Federal safety
requirements in addition to these grades.
I
219 ...
ProCarManuals.com