jump cable PONTIAC FIREBIRD 1994 Owners Manual

Jump Starting
If your battery has run down, you may
want to use another vehicle and some
jumper cables to start your Pontiac. But
please follow the steps below to do
it
safely.
11 other. lt tney are, 11 COUIU cause a
NOTICE:
I1
ground connection you don’t want.
You wouldn’t be able to start your
Ignoring these steps could result
in
costlj damage to your vehicle that
wouidn”t be covered by your war-
ranty.
Trying to start your Pontiac by push-
ing or pulling it could damage your
yehicle, even if you have a manual
tran’smission. And if you have
an
automatic transmission, it won’t start
that way.
ro Jump Start Your Pontiac:
1. Cheik the other vehicle. It must have
a 12-volt battery with a negative
If the other system isn’t a 12-volt
system with. a negative ground, both
2. Get the vehicles close enough so the
jumper cables can reach, but be sure
the vehicles aren’t touching each Pontiac, and the
bad grounding could
damage the electrical systems.
3. Turn off the ignition on both vehicles.
Turn
off all lights that aren’t needed,
and radios. This will avoid
sparks and
help save both batteries. And it‘could
save your radio!
I NOTICE:
If you leave your radio on, it could be
badly damaged. The repairs woddn’t
be covered by your warranty.
1
ground system. 4. Open the hoods and locate the
NOTICE: batteries.
153 ...
ProCarManuals.com

Problems on the Road
Find the positive (+) and negative (-)
terminals on each battery. 5. Check that the jumper cables don’t
have loose
or missing insulation. If
they do, you could get a shock. The
vehicles could be damaged, too.
Before
you connect the cables, here
are some basic things
you should
know. Positive
(+) will go to positive
(+) and negative (-) will go to
negative
(-) or a metal engine part.
Don’t connect
(+) to (-) or you’ll get a
short that would damage the battery
and maybe other parts, too.
. . .I54
ProCarManuals.com