key battery PONTIAC FIREBIRD 1994 Owners Manual
[x] Cancel search | Manufacturer: PONTIAC, Model Year: 1994, Model line: FIREBIRD, Model: PONTIAC FIREBIRD 1994Pages: 290, PDF Size: 14.84 MB
Page 46 of 290

Should interference to this system occur,
try this:
0 Check to determine if battery
replacement is necessary. See the
instructions on battery replacement.
0 Check the distance. You may be too
far from your vehicle. This product
has a maximum range.
Check the location. Other vehicles or
objects may be blocking the signal.
0 See your Pontiac dealer or a qualified
technician for service.
Changes or modifications to this system
by other than an authorized service
facility could void authorization
to use
this equipment.
Operation
The driver’s door will unlock automatically when “UNLOCK’
is
pressed. If “UNLOCK” is pressed again
within five seconds, the passenger door
will also unl‘ock. All doors will lock when
“DOQR’ is pressed. The hatch will
unlock when the opened trunk symbol is
pressed, but only when the ignition switch is
not in “Run”, and the transmission is
in
“P” (Park) if you have an automatic
transmission. If you have a manual
transmission, the parking brake must
be set.
The system will turn on the interior lights
for about
40 seconds, or until the ignition
switch is turned to “Run”, when you
unlock the doors or hatch. The interior
lights
will come on for about two seconds
when you lock the doors.
Matching Transmitter(s) to Your
Vehicle
Each key chain transmitter is coded to
prevent another transmitter from
unlocking your vehicle. If a transmitter
is lost or stolen, a replacement can be
purchased through your dealer.
Remember to bring any remaining
transmitters with you when you go to
your dealer. When the dealer matches the
replacement transmitter to your vehicle,
the remaining transmitter must also be
matched. Once the new transmitter is
coded, the lost transmitter will not unlock
your vehicle. You
can match a transmitter to as many
different vehicles as you own, provided
they are equipped with exactly the same
model system. (General Motors offers
several different models of these systems
on their vehicles.) Each vehicle can have
onlv two transmitters matched to
it.
45 ...
ProCarManuals.com
Page 54 of 290

NOTICE: NOTICE:
Holding your key in “Start” for
longer than
15 seconds at a time will
cause your battery to be drained
much sooner. And the excessive heat
can damage your starter motor.
2. If your engine won’t start (or starts but
then stops), it could be flooded with
too much gasoline. Try pushing your
accelerator pedal all
the way to the
floor and holding it there as you hold
the key in “Start” for about three
seconds. If the vehicle starts briefly
but then stops again, do
the same
thing, but this time keep the pedal
down for five or six seconds. This
clears the extra gasoline from
the
engine Your
engine is designed to work with
the electronics in your vehicle. If you
add electrical parts or accessories,
you could change the way the fuel
injection system operates. Before
adding electrical equipment, check
with your dealer. If you don’t, your
engine might not perform properly.
If you ever have to have your vehicle
towed, see the part of this manual
that tells how to do
it without
damaging your vehicle. See “Towing
Your Vehicle” in
the Index.
To start your VS engine:
1. Without pushing the accelerator
pedal, turn the ignition key to “Start.”
When the engine starts, let go of the
key. The idle speed will go down as
your engine gets warm.
Holding your key in “Start” for
longer than
15 seconds at a time will
cause your battery
to be drained
much sooner.. And the excessive heat
2. If it doesn’t start within 10 seconds,
push the accelerator pedal all the
way to the floor, while
you hold the
ignition key in “Start.” When the
engine starts, let go of the key and
let up on the accelerator pedal. Wait
about
15 seconds between each try to
help avoid draining your battery.
1
53. .
ProCarManuals.com
Page 102 of 290

6. Pull down on the latches and align
hooks with holes. Push forward on the
larger
part of the latch until it clicks.
Do not force the latch. If it is hard to
lock, the top is not properly aligned.
f your vehicle suffers a power loss, such
1s a dead battery, you can still raise or
ower
the top manually by rotating the
ralve in the left side
of the trunk.
left side trim panel. Lift up the tab and
turn the valve clockwise to release the
hydraulic pressure. Turn the ignition key
to the
“LOCK” positon. You can now
raise or lower your top manually. Be sure
to close the valve after installing your top
so you can raise or lower it electronically
later.
101 ...
ProCarManuals.com
Page 121 of 290

Comfort Controls and Audid Systems
Forward
Press and hold “FWD’ to quickly
advance within a track. Release it to
resume playing. The radio will play
during this operation.
Random
Press “RDM’ to hear a random selection
of tracks.
To Stop the Disc Player
Turn the power off or turn the ignition
key
off. The disc stays in the player
and will resume,playing at the point
where it stopped.
Press
“AM/FM’ to stop playing the
disc and switch to radio. Press
“CDPLAY” to restart the disc at the
point wherk it stopped.
Press “EJECT” to eject the disc or
stop the disc
arid switch to radio.
“EJECT” wili work with the ignition
or radio
off. Press “EJECT” to load a
disc when the audio system is
off.
rheft-Deterrent System
Your auklio system is equipped with the
‘THEFTLOCK” theft-deterrent system.
See “Theft-Deterrent System” at the end
3f this section.
rheft-Deterrent Feature
rHEFTZOCK is a security feature for the
Zassette tape and compact disc player. It
:an be used or ignored. If ignored, the
System functions normally:
If it is used,
your system won’t be usable if it’s ever
stolen. When the system is active, the
indicator light will flash while the ignition
is off.
Setting Your Security Code
The instructions below tell you how to
enter a security code into the system. If
your vehicle loses battery power for any
reason, you must enter the security code
again before the system will turn on.
1. Write down any number from 000 to
1999 and keep it in a safe place.
2. Turn the ignition switch to tHk “ACC”
or “Run” position.
3. T~irn the audio system off.
4. Press and hold pushbuttons “1” and
“4” together until “---” shows on the
display.
You are now ready to enter your security
:ode. Don’t wait more than
15 seconds
between steps.
5. Press “MIN” and “000” will appear
on the display.
6. Press “MIN’ again and hold until the
last two digits of your code appear.
Release the button.
7. Press “HR’ until the first one or two
digits of your code appears.
on tine display.
verification.
8. Press “A”.” “rEP” will appear
9. Repeat steps 5 through 7 for
10. Press “A”.” “SEC” will appear
on the display. This means that your audio system is secured.
. . .I20
ProCarManuals.com